oil level FIAT 500 ABARTH 2012 2.G Owners Manual
[x] Cancel search | Manufacturer: FIAT, Model Year: 2012, Model line: 500 ABARTH, Model: FIAT 500 ABARTH 2012 2.GPages: 358, PDF Size: 2.59 MB
Page 131 of 358

CAUTION!
The TPMS has been optimized for the original
equipment tires and wheels. TPMS pressures and
warning have been established for the tire size
equipped on your vehicle. Undesirable system opera-
tion or sensor damage may result when using re-
placement equipment that is not of the same size,
type, and/or style. Aftermarket wheels can cause
sensor damage. Do not use tire sealant from a can or
balance beads if your vehicle is equipped with a
TPMS, as damage to the sensors may result.
16. Automatic Gearbox Failure This light will illuminate when there is an
automatic transmission fault. 17. Oil Pressure Warning Light
This light indicates low engine oil pressure. The
light should turn on momentarily when the engine
is started. If the light turns on while driving, stop the
vehicle and shut off the engine as soon as possible. A
chime will sound for four minutes when this light turns
on.
Do not operate the vehicle until the cause is corrected.
This light does not indicate how much oil is in the engine.
The engine oil level must be checked under the hood.
18. Malfunction Indicator Light (MIL) The Malfunction Indicator Light (MIL) is part of
an onboard diagnostic system, called OBDII, that
monitors engine and automatic transmission con-
trol systems. The light will illuminate when the key is in
the ON/RUN position before engine start. If the bulb
does not come on when turning the key from OFF/LOCK
to ON/RUN, have the condition checked promptly.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 129
Page 282 of 358

Engine Oil
Checking Oil Level
To assure proper engine lubrication, the engine oil must
be maintained at the correct level. Check the oil level at
regular intervals, such as every fuel stop. The best time to
check the engine oil level is about five minutes after a
fully warmed engine is shut off. Do not check oil level
before starting the engine after it has sat overnight.
Checking engine oil level when the engine is cold will
give you an incorrect reading.
Checking the oil while the vehicle is on level ground, and
about five minutes after a fully warmed engine is shut
off, will improve the accuracy of the oil level readings.
Maintain the oil level between the range markings on the
dipstick. The safe range is indicated by a crosshatch zone.
Adding 1 qt (1L) of oil when the reading is at the low end
of the indicated range will result in the oil level at the full
end of the indicator range.
CAUTION!
Do not overfill the engine with oil. Overfilling the
engine with oil will cause oil aeration, which can
lead to loss of oil pressure and an increase in oil
temperature. This loss of oil pressure and increased
oil temperature could damage your engine.
Change Engine Oil
The oil change indicator system will remind you that it is
time to take your vehicle in for scheduled maintenance.
Refer to the “Maintenance Schedule” for further informa-
tion.
NOTE: Under no circumstances should oil change
intervals exceed 8,000 miles (13 000 km) or six months,
whichever occurs first.
280 MAINTAINING YOUR VEHICLE
Page 291 of 358

5. Lower the wiper blade and snap the pivot cap into
place.
Adding Washer Fluid
The windshield washer fluid reservoir is located in the
engine compartment, and the fluid level should be
checked at regular intervals. Fill the reservoir with wind-
shield washer solvent (not engine coolant/antifreeze).
Refer to “Engine Compartment” in “Maintaining Your
Vehicle” for further information.
WARNING!
Commercially available windshield washer solvents
are flammable. They could ignite and burn you. Care
must be exercised when filling or working around
the washer solution.
Exhaust System
The best protection against carbon monoxide entry into
the vehicle body is a properly maintained engine exhaust
system.
If you notice a change in the sound of the exhaust system;
or if the exhaust fumes can be detected inside the vehicle;
or when the underside or rear of the vehicle is damaged;
have an authorized technician inspect the complete ex-
haust system and adjacent body areas for broken, dam-
aged, deteriorated, or mispositioned parts. Open seams
or loose connections could permit exhaust fumes to seep
into the passenger compartment. In addition, inspect the
exhaust system each time the vehicle is raised for lubri-
cation or oil change. Replace as required.
7
MAINTAINING YOUR VEHICLE 289
Page 321 of 358

At Each Stop For Fuel
•Check the engine oil level about five minutes after a
fully warmed engine is shut off. Checking the oil level
while the vehicle is on level ground will improve the
accuracy of the oil level reading. Add oil only when
the level is at or below the ADD or MIN mark.
•Check the windshield washer solvent and add if
required.
Once A Month
•Check tire pressure and look for unusual wear or
damage.
•Inspect the battery and clean and tighten the terminals
as required.
•Check the fluid levels of the engine coolant reservoir
and brake master cylinder, and add as needed.
•Check all lights and other electrical items for correct
operation.
At Each Oil Change
•Change the engine oil filter.
•Inspect the brake hoses and lines.
CAUTION!
Failure to perform the required maintenance items
may result in damage to the vehicle.
Required Maintenance Intervals
Refer to the Maintenance Schedules on the following
pages for the required maintenance intervals.
NOTE: On vehicles equipped with 17” summer tires,
more frequent tire rotation may be necessary to achieve
optimal tread wear, and tire rotation at each oil change
indicator message is recommended.
8
M A I
N T
E
N A
N CE
S
C
H E
D
U L
E
SMAINTENANCE SCHEDULES 319
Page 346 of 358

ConnectorUCI .............................. 176
Universal Consumer Interface (UCI) ....... 176
Contract, Service ........................ 334
Coolant (Antifreeze) ................... 314,315
Cooling System ......................... 292
Adding Coolant (Antifreeze) ............. 293
Coolant Level .................... 292,295
Disposal of Used Coolant ............... 295
Drain, Flush, and Refill ................ 292
Inspection .......................... 295
Points to Remember ................ 294,296
Pressure Cap ........................ 294
Selection of Coolant (Antifreeze) .......... 292
Corrosion Protection ..................... 300
Cruise Light ........................... 126
Cupholders ............................ 115
Customer Assistance ..................... 332 Data Recorder, Event
...................... 52
Daytime Running Lights ................... 92
Dealer Service .......................... 278
Defroster, Windshield ................66,182,188
Diagnostic System, Onboard ................ 276
Disposal Antifreeze (Engine Coolant) ............. 295
Engine Oil ......................... 282
Door Locks ............................. 19
Door Locks, Automatic .................... 21
Driving On Slippery Surfaces .................. 199
Through Flowing, Rising, or Shallow Standing
Water ............................. 200
Electric Remote Mirrors .................... 74
Electrical Power Outlets ................... 112
Electronic Brake Control System ............. 207
Anti-Lock Brake System ................ 207
344 INDEX
Page 347 of 358

Brake Assist System................... 207
Traction Control System ................ 208
Electronic Speed Control (Cruise Control) ...... 100
Electronic Stability Control (ESC) ............. 210
Electronic Vehicle Information Center (EVIC) .... 135
Emergency, In Case of Hazard Warning Flasher ............... 248
Jacking ............................ 259
Jump Starting ....................... 266
Towing ............................ 271
Emission Control System Maintenance ......... 276
Engine Break-In Recommendations .............. 63
Checking Oil Level ................... 280
Compartment ....................... 275
Cooling ........................... 292
Exhaust Gas Caution ................65,242
Fails to Start ........................ 198
Flooded, Starting ..................... 198 Fuel Requirements
.................... 238
Oil ......................... 280,314,315
Oil Change Interval ................... 280
Oil Filler Cap ....................... 281
Oil Filter ........................... 315
Oil Selection ........................ 281
Overheating ........................ 248
Starting ........................... 196
Temperature Gauge ................... 133
Enhanced Accident Response Feature .......... 47
Event Data Recorder ...................... 52
Exhaust Gas Caution ................. 24,65,242
Exhaust System ....................... 65,289
Exterior Lights .......................... 68
Filler Location Fuel ...................... 135
Filters Air Cleaner ......................... 282
Engine Oil ....................... 282,315
10
INDEX 345
Page 351 of 358

Lubrication, Body....................... 286
Maintenance Free Battery .................. 283
Maintenance Procedures ................... 279
Maintenance Schedule .................... 318
Maintenance, General ..................... 279
Malfunction Indicator Light (Check Engine) . . 129,277
Manual Transmission ..................... 300
Fluid Level Check .................... 300
Frequency of Fluid Change ............. 300
Lubricant Selection ................... 300
Manual, Service ......................... 336
Master Cylinder (Brakes) .................. 297
Mirrors ................................ 72
Automatic Dimming ................... 72
Electric Powered ...................... 74
Modifications/Alterations, Vehicle ............. 7
Monitor, Tire Pressure System ............... 233
Multi-Function Control Lever ................ 92New Vehicle Break-In Period
................ 63
Occupant Restraints ..................... 43,49
Occupant Restraints (Sedan) .........24,40,41,43,46
Octane Rating, Gasoline (Fuel) .............. 238
Odometer ............................. 134
Trip .............................. 134
Oil Change Indicator ..................... 138
Oil Change Indicator, Reset ................. 138
Oil, Engine ......................... 280,314
Capacity ........................... 314
Change Interval ..................... 280
Checking .......................... 280
Disposal ........................... 282
Filter ............................. 282
Identification Logo ................... 281
Materials Added to ................... 282
Recommendation .................. 281,314
Viscosity ........................... 281
10
INDEX 349