fuse FIAT 500 ABARTH 2016 2.G User Guide

CavityMaxi Fuse Mini Fuse Description
F16 –7.5 Amp Brown Transmission
F17 – 25 Amp Clear Powertrain (Multiair – If Equipped)
F17 – 15 Amp Blue Powertrain
F18 – 15 Amp Blue Powertrain
F18 – 5 Amp Tan Powertrain (Multiair – If Equipped)
F19 –7.5 Amp Brown Air Conditioning
F20 – 15 Amp Blue Heated Seats – If Equipped
F21 – 15 Amp Blue Fuel Pump
F22 –20 Amp Yellow Powertrain
F23 –20 Amp Yellow Anti-Lock Brake Valves
F24 –7.5 Amp Brown Stability Control System
F30 – 15 Amp Blue Fog Lamps
F82 30 Amp Green –Sunroof/Convertible Top
F83 20 Amp Yellow –Cooling Pump – If Equipped
F84 – 10 Amp Red Transmission
386 MAINTAINING YOUR VEHICLE

CavityMaxi Fuse Mini Fuse Description
F85 30 Amp Green –Rear Defroster
F87 – 5 Amp Tan Rear Defroster
F90 – 5 Amp Tan Heated Mirrors – If Equipped
VEHICLE STORAGE
If you will not be using your vehicle for more than 21
days, you may want to take steps to preserve your
battery.
•Disconnect the negative cable from the battery.
• Anytime you store your vehicle, or keep it out of
service (i.e., vacation) for two weeks or more, run the
air conditioning system at idle for about five minutes
in the fresh air and high blower setting. This will
ensure adequate system lubrication to minimize the
possibility of compressor damage when the system is
started again. NOTE:
When the vehicle has not been started or driven
for at least 30 days, an Extended Park Start Procedure is
required to start the vehicle. Refer to “Starting Proce-
dures” in “Starting And Operating” for further informa-
tion.
7
MAINTAINING YOUR VEHICLE 387

Exterior Lights........................ .79, 388
Filters Air Cleaner .......................... .351
Air Conditioning ...................... .355
Engine Oil ........................... .350
Engine Oil Disposal .....................350
Flashers Turn Signal ........................ .79, 174
Flash-To-Pass ........................... .101
Flooded Engine Starting ....................231
Fluid, Brake ............................ .396
Fluid Capacities ......................... .393
Fluid Leaks ..............................79
Fluid Level Checks Automatic Transmission ..................372
Fluids ................................ .394
Fluids, Lubricants And Genuine Parts ...........394
Fog Lights .......................... .105, 168Freeing A Stuck Vehicle
.....................335
Fuel .................................. .297
Adding ............................. .302
Additives ............................ .299
Capacity ............................ .393
Clean Air ............................ .298
Ethanol ............................. .298
Filler Cap (Gas Cap) .....................302
Gasoline ............................. .297
Materials Added ....................... .299
Methanol ............................ .298
Octane Rating ......................... .297
Requirements ......................... .297
Specifications ......................... .394
Tank Capacity ......................... .393
Fueling ............................... .302
Fuses ................................. .381
Gas Cap (Fuel Filler Cap) ................302, 304
10
INDEX 419

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.