diagram FIAT BRAVO 2007 2.G Owners Manual
[x] Cancel search | Manufacturer: FIAT, Model Year: 2007, Model line: BRAVO, Model: FIAT BRAVO 2007 2.GPages: 246, PDF Size: 3.75 MB
Page 135 of 246
134
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATION
INDEX
DASHBOARD
AND CONTROLS
CORRECT USE
OF THE CAR
USING THE GEARBOX
To engage the gears, press the clutch ped-
al fully and shift the gear lever into the re-
quired position (the diagram of gear po-
sition is shown on the knob fig. 2and
fig. 3.
To engage 6
thgear (1.416V, 1.4 T-JET and
1.9 Multijet 16V version ) press the lever
to the right to prevent engaging 4thgear
by mistake. A similar action is required to
shift down from 6
thto 5th.
IMPORTANT The car can only be put in-
to reverse gear when it has stopped mov-
ing completely. With the engine running,
before engaging the reverse, wait at least
2 seconds with the clutch pedal fully down
to prevent damage and grating of the
gears.
To engage reverse Rfrom neutral, lift the
sliding ring A-fig. 2or A-fig. 3 under the
knob and shift the lever to the right and
back.
fig. 2F0Q0734mfig. 3F0Q0602m
To change gears properly
you must push the clutch
pedal fully down. It is therefore es-
sential that there is nothing under the
pedals: make sure the mats are lying
flat and do not get in the way of the
pedals.
WARNINGDo not drive with your hand
resting on the gear lever as the
force exerted, even if slight,
could lead over time to pre-
mature wear on the gearbox internal
components.
129-140 BRAVO GB 10-05-2007 9:16 Pagina 134
Page 139 of 246
138
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATION
INDEX
DASHBOARD
AND CONTROLS
CORRECT USE
OF THE CAR
Assembly diagram fig. 4
The tow-hook structure must be secured
at the points indicated with
Øwith a to-
tal of 2 M8 bolts, 4 M10 bolts and 2 M12
bolts.
The hook should be fastened to the body
avoiding any type of drilling and trimming
of the rear bumpers that remains visible
when the hook is removed.
After fitting, screw holes shall be sealed to
prevent exhaust gas inlet.
F0Q0249mfig. 4
Existing hole
REAR AXLEExisting holesFull load
Ball to 94/20 EC standard
Existing holes
Existing
holes
Existing holes
129-140 BRAVO GB 10-05-2007 9:16 Pagina 138