change time FIAT BRAVO 2008 2.G Dualogic Transmission Manual

5
MANUAL OPERATION
(MANUAL)
In this operating mode, the driver is re-
sponsible for choosing the best gear ra-
tio to engage, depending on the car op-
erating conditions.
Proceed as follows to shift gear:
❒move the lever to (+) position to en-
gage a higher gear;
or
❒move the lever to (–) position to en-
gage a lower gear.
If the gear change request may adversely
affect the correct operation of the engine
and the gearbox, the system does not al-
low the gear change but automatically
changes down if the engine is idling (e.g.
during deceleration).
In such cases the system warns the dri-
ver of the impossibility of changing gear by
means of a buzzer.STEERING WHEEL CONTROLS
(where provided) fig. 4
On certain versions the change can be
managed sequentially using (optional) con-
trols on the steering wheel.
To use the controls on the steering wheel,
the gear lever should be in the middle po-
sition between +and –:
❒moving the lever on the steering
wheel +: engagement of higher ratio;
❒moving the lever on the steering
wheel –: engagement of lower ratio.
The engagement of a lower (or higher)
gear ratio is only permitted if the engine
speed allows
fig. 5F0Q3290gfig. 6F0Q3291gfig. 4F0Q0777m
AUTOMATIC OPERATION
(AUTO)
To switch the automatic operation (AUTO)
on/off, push leverAto the A/Mposition;
activation will be signalled by the display of
the word AUTOand the gear engaged
fig. 5-6. In AUTOmode the system will
change gear depending on the speed of the
car, the engine speed and the intensity with
which the accelerator pedal is pressed. A
gear shift may be requested by operating the
gear lever, but without necessarily switch-
ing this mode off: this function, known as
‘gear suggestion’, suspends the automatic
mode for the time required to select the ra-
tio requested by the driver.
603.83.941 Bravo Dualogic GB 5-05-2008 10:53 Pagina 5