98GETTING TO KNOW YOUR VEHICLE
43 21
10987 65
fig. 146
F0A0099b
fig. 145
F0A0096B
CELLULAR PHONE
SET-UP
The system set-up consists of:
– a dual-purpose aerial (sound sys-
tem + cellular phone), on the vehicle
roof;
– a dual-purpose aerial connection
wires and ten-pin connector wiring
fig. 146.
– a double coil speaker (sound sys-
tem + cellular telephone), located on
the passenger side dashboard. HEAVY PRESETTING
The system consists of the following:
– sound system power wires;
– wires for front speakers on the
dashboard;
– 2 speakers on the dashboard;
– wires for door speakers (where
provided);
– 2 door speakers;
– 2 rear speakers (for passengers
transport versions);
– wires for rear speakers;
– sound system compartment;
– aerial wire and aerial.Speakers
– two mid-range speakers on dash-
board, diameter 100 mm, power 30W
max each.
– two woofer speakers on front
doors, diameter 165 mm, power 40W
max each (Panorama versions only).
– two full-range elliptic speakers on
rear window shelf, 95 x 154 mm, pow-
er 20W max each (Panorama versions
only).
Sound system installation
To fit the sound system, remove the
oddment compartment shown in fig.
145. To remove the compartment,
press it upwards and then pull it out
towards the inside of the vehicle.
fig. 144
F0A0162B
99GETTING TO KNOW YOUR VEHICLE
Wiring diagram:
1Sound system mute function.
2Spare.
3Cellular phone input earth signal.
4Cellular phone INPUT signal.
5Dual-purpose speaker on the front
passenger side door (+).
6Dual-purpose speaker on the front
passenger side door (-).
7Ignition switch power (+15).
8Spare.
9Battery power (+).
10Earth.Maximum power to be
applied to the aerial is
20W.
Have the cellular tele-
phone installed and con-
nected to the setup sys-
tem in the vehicle by a Fiat Deal-
ership only. This will ensure the
best results and prevent any
problems which could effect ve-
hicle safety.
Purchase a free-hands kit
which is compatible for
your cellular telephone.
fig. 147
F0A0210b
fig. 148
F0A0211b
Have the cellular telephone and the
connections performed by a Fiat
Dealershiponly.
In Fiat Doblò passengers Transport
versions, use a screwdriver in the
point shown in fig. 147to reach the
ten pin connector. Lift the central tun-
nel cover and remove the connector.
In Fiat Doblò Cargo versions, loosen
the screws shown in fig. 148in the
glove compartment to reach the ten
pin connector. Use a screwdriver in
the pre-cut point and remove the con-
nector.
