engine oil FIAT DOBLO 2008 1.G User Guide

157VEHICLE MAINTENANCE
ENGINE OIL fig. 6, 7, 8
Check engine oil with the vehicle on
level ground and while the engine is
still warm (approximately 5 minutes
after stopping the engine.
The oil level should be included be-
tween the MINand MAXreference
marks on the dipstick.
The space between MINand MAX
equals about 1 litre of oil.If the oil level is near or actually be-
low the MINmark, add oil through
the filler until it reaches the MAX
mark.
Oil level shall never exceed the
MAXmark. Be very careful under
the bonnet: you risk burn-
ing yourself. Remember
that when the engine is hot, the
fan can start up and cause in-
juries.
Do not add oil with dif-
ferent specifications from
the oil already in the en-
gine.
fig. 6 - 1.4 8V versions
F0A0536bF0A0346b
fig. 7 - 1.3 Multijet versions
149-173 Doblo GB 9-05-2008 12:10 Pagina 157

158VEHICLE MAINTENANCE
Used engine oil and re-
placed oil filters contain
substances which can
harm the environment. We rec-
ommend you have the vehicle
seen to at a Fiat Dealership for
the oil and filter change. It is suit-
ably equipped for disposing of
used oil and filters in an environ-
mentally-friendly way that com-
plies with the law.ENGINE OIL CONSUMPTION
Max engine oil consumption is usu-
ally 400 grams every 1000 km.
During the beginning of the vehicle’s
life the engine is be tuned in. Engine oil
consumption can only be considered
stabilised after the first 5000 ÷ 6000
km.
IMPORTANTOil consumption
depends on the driving style and the
conditions of use. IMPORTANTIf, following a check
the engine oil if move the MAXlev-
el, go to a Fiat Dealershipto have
the correct level restored.
IMPORTANT After topping up or
changing the oil, let the engine turn for
a few seconds and wait a few minutes
after stopping it before you check the
level.
fig. 8 - 1.9 Multijet versions
F0A0265b
149-173 Doblo GB 9-05-2008 12:10 Pagina 158

160VEHICLE MAINTENANCE
Prevent brake fluid,
which is highly corrosive,
from coming into contact
with painted parts. Should it hap-
pen, immediately wash with wa-
ter.
Check that fluid contained in tank is
at maximum level. If fluid has to be
added, it is suggested to use the brake
fluid in table "Fluids and lubricants"
(see chapter "Technical characteris-
tics"). At plug opening, pay maximum
attention in order to prevent any im-
purities from entering the tank.
For topping up, always use a funnel
with integrated filter with mesh equal
to or lower than 0.12 mm.
fig. 14
F0A0126b
POWER STEERING FLUID
fig. 13
The oil level with the vehicle on lev-
el ground and engine cold should be
included between the references MIN
and MAXon the reservoir.
When the oil is hot, the level can ex-
ceed the reference line MAX.
When topping up (where necessary)
make sure that the oil has the same
specifications as the oil in the system.Do not travel with the
windscreen washer reser-
voir empty. The wind-
screen washer is fundamental for
improving visibility.
fig. 13
F0A0261b
Do not let the power
steering fluid come into
contact with hot engine
parts. It catches fire very easily.
Oil consumption is ex-
tremely low. If the oil lev-
el needs topping up again
a s short period of time, have the
system checked for leakage at a
Fiat Dealership.
BRAKE/HYDRAULIC
CLUTCH FLUID fig. 14-15
Check that the level of the fluid in the
reservoir is at the maximum.
Use DOT 4 fluid only for topping up.
We recommend TUTELA TOP 4
that the braking system was originally
filled with.
149-173 Doblo GB 9-05-2008 12:10 Pagina 160

202TECHNICAL SPECIFICATIONS
FLUIDS AND LUBRICANTS
PRODUCTS WHICH MAY BE USED AND THEIR CHARACTERISTICS
Specifications of the lubricants and fluids to use
for best operation
Synthetic-based engine oils grade SAE 10W-40
that pass ACEA A3 and API SL specifications.
Synthetic-based engine oils grade SAE 5W-30
that pass ACEA A1-A5 - API SL and
FIAT 9.55535-M1specifications.
Synthetic-based engine oils grade SAE 10W-40
that pass ACEA B3 and API CD specifications.
Synthetic-based engine oils grade SAE 5W-40
that pass ACEA B4, API CF and
FIAT 9.55535-M2specifications.
Synthetic-based engine oils grade SAE 5W-40 that pass
ACEA B4, API CF and FIAT 9.55535-M2specifications
F0A0175b
(*) For very low temperatures, we recommend SELENIA MULTIPOWER.
(**) For very low temperatures, we recommend SELENIA WR.
Applications Use
Lubricants for
petrol engines (*)
Lubricants for
diesel engines (**)
Lubricants for
diesel engines
(1.3 Multijet versions)
Fluids and lubricants
recommended
SELENIA 20K
SELENIA
MULTIPOWER
SELENIA
TURBO DIESEL
SELENIA
WR
174-211 Doblo GB 16-12-2008 14:26 Pagina 202

213INDEX
- rear window ............................. 61
- windscreen ............................... 60
Digital clock .......................... 26-27
Dimensions ................................... 187
Direction indicators
- control ...................................... 64
- front bulb replacement .......... 133
- rear bulb replacement ........... 134
- side bulb replacement ............ 134
Door lock/unlock
remote control ............................. 8
Double ladder (partitions) ......... 51
Driver’s protection ladder
(partitions)................................... 51
Driving your vehicle .................... 106
EBD electronic brake force
distributor ................................... 90
Electric windows .......................... 74
Electronic brake force
distributor EBD .......................... 90
Electronic control units .............. 166
Engine
- fuel feed ..................................... 181
- identification code .................. 176
- ignition ...................................... 181
- specifications ............................ 179Engine compartment
- washing ...................................... 172
Engine coolant gauge ................... 25
Engine coolant level ..................... 159
Engine oil
- checking the level.................... 157
- consumption............................. 158
- specifications ............................ 202
Engine oil level .............................. 157
EOBD system................................ 97
Evaporation system...................... 104
Exhaust gas recirculation ............ 104
Extending the boot ...................... 80
Fiat CODE system ..................... 6
First aid kit ..................................... 148
Follow me home ......................... 66
Front doors ................................... 74
Front foglights
- bulb replacement ................... 133
- control button ......................... 68
Fuel
- at the filling station ................. 102
- capacities .................................. 200
- fuel cut-off switch ................... 69
- gauge .......................................... 25
Fuel cap........................................... 103Fuel consumption ......................... 204
Fuel cut-off switch........................ 69
Fuses
- dashboard fusebox.................. 139
- engine compartment
fusebox ...................................... 140
- replacement.............................. 138
- table............................................ 141
Gearbox
- gearbox use .............................. 109
- technical characteristics ........ 182
Getting to know your vehicle ... 6
Glove compartment .................... 69
Handbrake .......................... 107-182
Hazard lights.................................. 68
Headlight beam corrector.......... 88
Headlight slant
(electrical corrector) ................ 88
Headlights
- adjusting the headlights
abroad........................................ 89
- beam corrector ....................... 88
- beam direction......................... 89
- slant compensation ................. 88
Head restraints
212-220 Doblo GB 16-12-2008 14:26 Pagina 213

FUEL CAPACITY (litres) ENGINE OIL CHANGE
1.4 1.3 Multijet 1.9 Multijet
litres kg litres kg litres kg
Oil sump2.4 2.1 3.0 2.6 4.0 3.5
Oil sump and filter2.6 2.25 3.2 2.8 4.3 3.7
Dispose of waste oil properly
Versions Size Medium load Full load
Front Rear Front Rear
Passenger Transportation 185/65 R15 88T 2.3 (*) 2.3 (*) 2.3 2.7
Family (7 seater) 185/65 R15 92T 2.3 2.7 2.3 2.7
Cargo standard capacity/Combi N1185/65 R15 92T 2.3 2.7 2.3 2.7
Cargo extra capacity/Long wheelbase 175/75 R14 C99/98T 3.0 3.5 3.0 3.5
Combi N1 exra capacity 175/75 R14 C99/98T 2.8 3.0 3.0 3.5
Passenger Transportation Natural Power 175/70 R14 88T 2.6 3.0 2.6 3.0
Cargo Natural Power 175/70 R14 C95/93S 2.8 3.5 2.8 3.5
With warm tyres the pressure should be +0.3 bar in relation to the prescribed value. Check again the correct pressure when the tyres are cold.
(*) Up to 3 people + 50 kg.
Tank capacity.................................................................................................................... 60
Reserve.......................................................................................................................... 5 - 7
Use only unleaded petrol with a rated octane number (RON) not less than 95.
Refuel diesel vehicles with diesel fuel for motor vehicles (EN590 Specification).
COLD TYRE INFLATION PRESSURE (bar)
Fiat Group Automobiles S.p.A. - Customer Services - Technical Services - Service Engineering
Largo Senatore G. Agnelli, 5 - 10040 Volvera - Torino (Italia)
Print no. 603.81.542 - 12/2008 - 2
ndedition
212-220 Doblo GB 16-12-2008 14:26 Pagina 220