stop start FIAT IDEA 2007 1.G User Guide

196
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
ENGINE COOLANT FLUID HIGH
TEMPERATURE
Turning the ignition key to MAR the warning
light on the dial turns on, but it should go off
after few seconds.
The warning light turns on (on certain versions
together with the message on the display) when
the engine is overheated. If the warning light
comes on when driving, proceed as follows:
❒normal driving conditions: stop the car,
switch off the engine and check whether the
water level in the reservoir is not below the
MIN mark. Otherwise wait for few seconds
to allow engine cooling, then open slowly and
carefully the cap, top up coolant and check
whether its level is falling between MIN and
MAX marks in the reservoir. Check visually
any leak. If when restarting the warning light
comes on again, contact a Fiat Dealership;
ç
continues on next page
red
Warning
light on dialMessage on reconfigurable
multifunction displayMessage on
multifunction display

222
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
ENGINE STARTING
EMERGENCY START-UP
If the Fiat CODE cannot deactivate the engine
immobilising system, the
Yand Uwarning lights
stay on and the engine will not start.
To start the engine the emergency start-up can be
performed.
Read the whole procedure carefully before trying to
carry it out. If you make a mistake, you must turn the
ignition key back to STOP and repeat the whole
operation from beginning.
Proceed as follows:
❒Read the 5-figure electronic code given on the
CODE card;
❒Turn the ignition key to MAR;
❒Press and hold down the accelerator pedal. The
instrument panel warning light
Uwill come on for
about 8 seconds and then go out;
❒Release the accelerator pedal and get ready to
count the flashes of the
Uwarning light;
❒Count the number of flashes that corresponds to
the first figure of the code on the CODE card, then
press the accelerator pedal and keep it there until
the
Uwarning light comes on for four seconds
and then goes out; release the accelerator pedal;
❒The Uwarning light will start flashing again: after it
has flashed the number of times that corresponds
to the second figure on the CODE card, press the
accelerator pedal to the floor and keep it there;
❒Do the same for the remaining figures on the
CODE card;
❒Once the final figure has been entered, keep the
accelerator pedal pressed. The
Uwarning light
will light up for four seconds and then go out;
release the accelerator pedal;
❒Rapid flashing of the warning light U(for about 4
seconds) confirms the operation has been carried
out successfully;
❒Start the engine by turning the ignition key from
MAR to AVV.
If however the warning light
Ustays on, turn the
ignition key to STOP and repeat the procedure from
step one
IMPORTANT After an emergency start-up, you should
contact a Fiat Dealership otherwise you will have to
repeat the procedure described each time you want to
start the engine.

224
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
BUMP STARTING
Never bump start the engine (bu pushing, towing, or
coasting downhill) as this could cause fuel to flow into
the catalytic exhaust system and damage it beyond
repair.IMPORTANT Remember that until the engine has
started the brake booster and electrical power
steering systems will not work and a greater effort will
therefore be required to press the brake pedal or turn
the steering wheel.
WARNINGAlert other drivers that the car is stationary in compliance with local regulations:
hazard warning lights, warning triangle etc. Any passengers on board should leave
the car, especially if it is heavily laden. Passengers should stay away from
oncoming traffic while the wheel is being changed on. If the wheel is being changed
on a steep or badly surfaced road, place the wedges or other suitable material
under the wheel to stop the car.

229
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
It is of vital importance to communicate that the tyre has been repaired using the
quick tyre repair kit. Hand the instruction brochure to the personnel charged with
treating the tyre repaired with the kit.WARNING
❒if reaching the tyre pressure specified in paragraph “Inflation pressure”
in section “Technical Specifications”, start driving immediately;
❒after driving for about 10 minutes stop and check again the tyre pres-
sure; pull up the handbrake;
❒if at least 1.8 bar pressure is read, restore proper pressure (with engine
running and handbrake on) and restart;
❒drive with the utmost care to the nearest Fiat Dealership.
FOR CHECKING AND RESTORING PRESSURE ONLY
The compressor can be also used just for restoring pressure. Disconnect
the quick connection and connect it directly to the tyre valve; in this way the
cylinder is not connected to compressor and the sealing fluid will not flow
into the tyre.
CYLINDER REPLACEMENT PROCEDURE
To replace the cylinder proceed as follows:
❒disconnect connection A;
❒turn counter-clockwise the cylinder to replace and raise it;
❒fit the new cylinder and turn it clockwise;
❒connect connection Ato the cylinder and fit the transparent tube Bin-
to the proper space.
F0H0359m
F0H0360m

257
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
WARNING
WARNING
Do not start the engine when towing the car.
WARNINGWhile the car is being towed with the
engine off, remember that the brake
pedal and steering will require more
effort as you no longer have the benefit
of the brake booster and the electrical
power steering. Do not use flexible cables
to tow. Avoid jerking. Whilst towing,
ensure that the coupling to the car does
not damage the surrounding components.
When towing the car, you must comply
with the specific traffic regulations
regarding the tow hitch and how to tow
on the road. TOW RING HOOKING
Proceed as follows:
❒take the tow ring (B) from its support;
❒tighten the ring on the rear or front threaded pin.
F0H0204m
F0H0205m
Before starting to tow, turn the ignition
key to MAR and then to STOP. Do not
remove the key. If the key is removed, the
steering lock engages automatically which
prevents the wheels being turned.

307
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
DASHBOARD
AND CONTROLS
INDEX
– control .................................. 101
– flashing .................................... 101
Manual climate control
system ......................................... 85
Multifunction display (on
comfort instrument panel) ..... 35
- controls ..................................... 36
Multifunction display (on
modal instrument panel) ......... 27
- controls ..................................... 28
Number plate light
– bulb replacement ................ 223
Oddment compartments ........ 118
- roof console ............................. 119
- upper.......................................... 117
Outlets ......................................... 121
Parking ....................................... 181
Parking sensors .......................... 146
Performance................................ 298
Plates ........................................... 287
Pollen filter ................................. 263
Power windows ......................... 125
Pretensioners.............................. 156
Prolonged car inactivity .......... 190
Protecting the environment .... 150
Radio transmitters and
cellular telephones..................... 141
Rain sensor ................................ 105
Rear fog lights
– bulb replacement ................. 244
– control button ...................... 115
Rear window washer
– control .................................. 104
– fluid level ............................... 270
Rear window wipers
– control .................................. 104
– smart washing ....................... 105
– blades .................................... 279
– nozzles.................................... 281
Rearview mirrors....................... 78
Rev counter ................................ 25
Reversing light
– bulb replacement ................. 244
Rims ............................................. 295
Roof racks ................................. 136
Rubber tubing ............................. 279
Safety devices ............................ 151
Seat belts
– general instructions ............ 152
– height adjustment ............... 154– maintenance ......................... 159
– S.B.R. system ......................... 153
– use .......................................... 152
Seats .............................................. 69
Side/taillights
– bulb replacement ........... 243-244
– control .................................. 100
Smart washing............................. 105
Snow chains ............................... 189
Sound system
– installation ............................ 141
– preset system ...................... 141
Spark plugs .................................. 290
Speedometer .............................. 25
Starting the engine
– bump starting ........................ 224
– emergency start-up ............. 222
– ignition switch ..................... 20
– jump starting ........................ 223
– Multijet engines .................... 179
– petrol engines ...................... 178
– stopping the engine ............. 180
– warming up the engine ...... 180
Steering . ...................................... 293
Steering lock .............................. 20
Steering wheel (adjustment) ... 68