ESP FIAT IDEA 2007 1.G Owner's Guide

231
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
WARNINGThe jack should only be used to change a wheel on the car for which it was
designed. It should not be put to other uses or employed to raise other models of
cars. Under no circumstances should it be used when carrying out repairs under the
car. An incorrectly positioned jack may cause the car to fall. Do not use the jack to
lift loads exceeding that indicated on the label attached to the jack itself. Do not
fit snow chains on a space-saver spare wheel. If a front wheel (drive wheel) is
punctured and you require snow chains to proceed, take a standard wheel from
the rear axle and fit the space-saver spare wheel in its place. Having fitted two
standard wheels on the front drive axle you can use snow chains, thus solving the
emergency situation.
WARNINGWhen driving with a space-saver spare wheel fitted, the driving performance of
your car may change. Avoid accelerating or braking suddenly, steering abruptly or
fast cornering. The lifespan of a space-saver spare wheel is approximately 3000
km, after which it will need to be replaced with another spare wheel of the same
type. Never fit a standard tyre on the space-saver spare wheel rim. Have the wheel
replaced and refitted as soon as possible. Never use two or more spare wheels at
the same time. Do not lubricate the bolt threads before fitting them back: they
could come loose.
WARNINGFasten the wheel cap correctly to prevent the wheel from coming free in motion.
Never tamper with the inflation valve. Never place tools between the rim and tyre.
Check the tyre and space-saver spare wheel pressure regularly. The tyre inflation
pressure is shown in the “Technical specifications” chapter.

235
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
F0H0165m
F0H0166m
❒Fit the spare wheel making the holes (M) coincide with the respective
centring pins (N);
❒Using the wrench provided, fully tighten the four fastening bolts;
❒Turn the jack handle (L) to lower the car and remove the jack;
❒Use the wrench provided to fasten the bolts completely in a criss-
cross fashion as shown in the figure.
REFITTING THE STANDARD WHEEL
Following the procedure described previously, raise the car and remove
the spare wheel.
For versions with steel rim
Proceed as follows:
❒Make sure the contact surfaces between standard wheel and hub are
clean so that the fastening bolts will not come loose;
❒Fit the standard wheel by inserting the first bolt in the hole closest to
the inflation valve;
❒Fit the wheel cap making the groove (on the wheel cap) coincide with
the inflation valve and fit the other three bolts;
❒Using the wrench provided, tighten the fastening bolts;
❒Lower the car and remove the jack;
❒Using the wrench provided, fully tighten the bolts in the sequence
shown previously for the spare wheel;
IMPORTANT Incorrect fitting may cause the wheel cap to come off
when the car is travelling.

249
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
FUSE LOCATION
Fuses are grouped into two fuse boxes to be found respectively on the
left side of the dashboard and in the engine compartment near the
battery.
Fuse box on the dashboard
To gain access to the fuses in the control box on the dashboard, remove
the protective trim (A).
MO
DE
+7
75
4
P
F0H0199m
F0H0200m
F0H0336m
Left-hand drive versions
Right-hand drive versions

251
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
FUSE SUMMARY TABLE
Control box on dashboard
USERFUSE AMPERE
Right-hand dipped beam headlightF12 15
Left-hand dipped beam headlight / headlight aiming device F13 15
Reversing lights / engine compartment control box relay coils / body computer F31 7.5
+30 Driver’s / passenger’s door control units (*)F32 15
Left rear power windowF33 20
Right rear power windowF34 20
+15 Cruise control, signal from switch on brake pedal for control units (*) F35 7.5
+30 Presetting for trailer control unit, rear locks front locks with single door control unit (*) F36 20
+15 Third brake light, instrument panel, brake lights (*) F37 10
Boot unlockingF38 15
+30 EOBD diagnostic socket, sound system, navigator, tyre pressure control unit (*)F39 10
Rear heated screenF40 30
Heated door electric mirrorsF41 7.5
+15 ABS / ESP control unit (*)F42 7.5
Windscreen wiper/washerF43 30
Cigar lighter / current socket on tunnelF44 20
Heated seatsF45 15
Boot current socketF46 20
Driver’s door control unit power supply (power window, lock) F47 20
Passenger’s door control unit power supply (power window, lock) F48 20
+15 utilities (left and central dashboard control lights, electric mirrors, heated seat control
lighting,presetting for radiotelephone, navigator, rain / daylight sensors, parking sensor control unit,
sunroof control lighting) (*)F49 7.5
Airbag control unitF50 7.5
+15 Tyre pressure control unit, ECO / Sport control (*) F51 7.5
Rear screen wiper/washerF52 15
+30 Direction indicators, hazard lights, instrument panel (*) F53 10
(*) +30 = battery directive positive terminal (not under key)
+15 = positive terminal under key

252
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
Fuse box in engine compartment
USERFUSE AMPERE
Dashboard control unit 1F1 70
Power steering control unitF2 70
Ignition switchF3 20
Dashboard control unit 2F4 50
ABS / ESP control unitF5 60
Radiator electric fan (low speed) (all versions)F6 30
Radiator electric fan (high speed) (all versions excluded 1.2 16V, 1.4 16V heated) F7 40
Climate control electric fanF8 30
Headlight washerF9 20
HornF10 15
Electronic injection secondary servicesF11 15
Right main beam headlightF14 10
Left main beam headlightF15 10
+15 Electronic injection system / Dualogic gearbox (*)F16 7,5
Electronic injection primary servicesF17 10
+30 Engine control unit / Radiator electric fan remote control switch (1.9 Multijet) (*) F18 7.5
CompressorF19 7.5
Heated diesel oil filter (Multijet)F20 30
Fuel pumpF21 15
Electronic injection primary services (1.2 16V, 1.4 16V)F22 15
Electronic injection primary services (Multijet)F22 20
+30 Dualogic gearbox (*)F23 15
+15 Electric power steering (*)F24 7,5
Front fog lightsF30 15
(*) +30 = battery directive positive terminal (not under key)
+15 = positive terminal under key

255
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
F0H0203m
JACKING THE CAR
If the car is to be lifted, go to a Fiat Dealership which is equipped with
the arm hoist or workshop lift.
Jack up the car only by positioning the jack arms or the shop jack in the
points shown in the figures.
TOWING THE CAR
The car is delivered with two tow rings: the short tow ring shall be fitted
at the front and the long one at the back.
Tow rings are arranged in tool container.
Side figures show how rear (long) ring was arranged, within spare wheel
and in the container of kit Fix & Go automatic, respectively.
F0H0342m
F0H0361m

261
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
Thousands of km
Check and adjust handbrake lever stroke
Check exhaust emissions/smoke (Multijet versions)
Check exhaust emissions (petrol versions)
Check antievaporation system (petrol versions)
Change fuel filter cartridge (“green filter”)
(Multijet versions)
Change air cleaner cartridge (petrol versions)
Change air cleaner cartridge (1.9 Multijet versions) (❏)
Top up fluids (engine coolant, brakes, windscreen washer,
battery, Dualogic etc.)
Check timing belt conditions (■)
Replace timing belt (*) (■)
Change spark plugs (petrol versions)
Check engine control system operation
(through diagnosis socket)
Change engine oil and oil filter (❏)
Change engine oil and oil filter
(Multijet versions with DPF) (**)
Change brake fluid (or every 2 years)
Change pollen filter (or every year)
(*) Or every 4 years for particularly demanding use:
- cold/hot climates;
- driving in the city idling for a long time;
- dusty roads or roads covered with sand and/or salt
Or every 5 years, regardless of the km covered and conditions of use.
(**) Engine oil and oil filter shall be changed when the corresponding warning light turns on (see section “Warning lights and Messages”), or in
any case every 2 years.
(
❏) Every 30.000 km for 1.3 Multijet versions without DPF
(
■) Excluding 1.3 Multijet versions
20 40 60 80 100 120 140 160 180
●● ● ●
●● ● ●
●● ● ●
●●
●●●
●●●
●●●●● ●●●●
●●●●● ●●●●
●●
●
●● ● ●
●● ● ●
●●●●● ●●●●
(●)(●)(●)(●)(●)(●)(●)(●)(●)
●●●
●●●●● ●●●●

IMPORTANT - Battery
The charge in the battery should be checked at the
start of winter to limit the risk of electrolyte freezing.This check should be carried out more frequently if
the car is used mainly for short trips, or if it is fitted
with accessories that permanently absorb electricity
even with the ignition key removed, especially in the
case of after market accessories. If the car is used in
hot climates or particularly harsh conditions it is wise
to check the level of the battery fluid (electrolyte)
more frequently than specified in the “Service
schedule” in this section.
264
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
Car maintenance should be entrusted to Fiat Dealership. For routine and minor maintenance
operations you wish to carry out yourself, always make sure you have the proper equipment,
genuine Fiat spare parts and the necessary fluids; do not however carry out these operations if you
have no experience.

ENGINE OIL
Checking engine oil
Check the oil level a few minutes (about 5) after the engine has stopped,
with the car parked on level ground.
Check that the level is within the MIN and MAX marks on the dipstick.
The interval between the MIN and MAX marks corresponds to about
one litre of oil.
Topping up engine oil
If the oil level is near or even below the MIN mark, add oil through the
filler neck, until reaching the MAX mark. Oil level shall never exceed the
MAX mark.
IMPORTANT If a routine check reveals that the oil level is above the
MAX mark, contact Fiat Dealership to have the correct level restored.
IMPORTANT After adding or changing the oil, let the engine turn over
for a few seconds and wait a few minutes after turning it off before you
check the level.
267
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
F0H0208m
F0H0209mF0H0326m
1.2 16V - 1.4 16V versions
1.3 Multijet versions 1.9 Multijet versions
F0H0258m1.4 8V versions (where provided)

CHANGING THE BATTERY
If required, replace the battery with a genuine spare
part having the same specifications.If a battery with different specifications is fitted, the
service intervals given in the “Service schedule” in this
section will no longer be valid. Refer to the
instructions provided by the battery manufacturer.
274
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
WARNING
If the car is left inactive for long periods at cold, remove the battery and store it in
a warm place to prevent freezing.WARNING
When working on the battery or near it, always wear the proper goggles. Batteries contain substances that are very harmful for the environment. You are advised to have the
battery changed at a Fiat Dealership, which is properly equipped for disposing of used batteries
respecting nature and the law.
Incorrect fitting of electrical and electronic accessories can seriously damage the car.
If after buying the car, you want to install electric accessories which require permanent electric
supply (alarm, free-hand phone kit, etc.) contact Fiat Dealership whose qualified personnel, in
addition to suggesting the most suitable devices, will evaluate the overall electric absorption,
checking whether the car’s electric system is capable of withstanding the load required, or whether
it should be integrated with a more powerful battery.