wheel FIAT IDEA 2007 1.G Owner's Guide

236
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
For versions with alloy rims
❒Make sure that hub contact surfaces are clean;
❒Refit the standard wheel fitting it on the pins, refit the fastening bolts
and tighten them using the wrench provided;
❒Lower the car and remove the jack;
❒Using the wrench provided, tighten the bolts in the sequence shown
previously for the space-saver spare wheel (see figure);
❒Refit the snap-fitted wheel hub cap.
When you have finished
❒Stow the spare wheel (C) in the space provided in the boot;
❒Insert the jack partially open in its container (B) forcing it lightly to
prevent it from vibrating when travelling;
❒Put the tools back into their places in the container;
❒Stow the container complete with tools on the spare wheel and
secure everything with the clamping device (A);
❒Correctly re-position the stiff cover.
F0H0161m

255
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
F0H0203m
JACKING THE CAR
If the car is to be lifted, go to a Fiat Dealership which is equipped with
the arm hoist or workshop lift.
Jack up the car only by positioning the jack arms or the shop jack in the
points shown in the figures.
TOWING THE CAR
The car is delivered with two tow rings: the short tow ring shall be fitted
at the front and the long one at the back.
Tow rings are arranged in tool container.
Side figures show how rear (long) ring was arranged, within spare wheel
and in the container of kit Fix & Go automatic, respectively.
F0H0342m
F0H0361m

257
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
WARNING
WARNING
Do not start the engine when towing the car.
WARNINGWhile the car is being towed with the
engine off, remember that the brake
pedal and steering will require more
effort as you no longer have the benefit
of the brake booster and the electrical
power steering. Do not use flexible cables
to tow. Avoid jerking. Whilst towing,
ensure that the coupling to the car does
not damage the surrounding components.
When towing the car, you must comply
with the specific traffic regulations
regarding the tow hitch and how to tow
on the road. TOW RING HOOKING
Proceed as follows:
❒take the tow ring (B) from its support;
❒tighten the ring on the rear or front threaded pin.
F0H0204m
F0H0205m
Before starting to tow, turn the ignition
key to MAR and then to STOP. Do not
remove the key. If the key is removed, the
steering lock engages automatically which
prevents the wheels being turned.

258
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
C C
A A
R R
M M
A A
I I
N N
T T
E E
N N
A A
N N
C C
E E
SCHEDULED SERVICING .................................................. 259
SERVICE SCHEDULE ........................................................... 260
ANNUAL INSPECTION SCHEDULE .............................. 262
ADDITIONAL CHECKS ..................................................... 262
CHECKING FLUID LEVELS ............................................... 265
DIESEL FUEL FILTER (green filter) ................................... 272
BATTERY ................................................................................ 273
WHEELS AND TYRES ......................................................... 277
RUBBER HOSES .................................................................... 279
WINDSCREEN/REAR WINDOW WIPERS .................. 279
BODYWORK ........................................................................ 282
INTERIORS............................................................................. 285

ANNUAL INSPECTION
SCHEDULE
For cars with an annual mileage of below 20,000 km
(for example about 15,000 km) the following yearly
inspection programme is provided:
❒check tyre conditions/wear and adjust pressure if
required (including the spare wheel);
❒check lighting system operation (headlights,
direction indicators, hazard lights, boot lights,
passenger compartment lights, warning lights, etc.);
❒check windscreen/washer
(nozzles/and blade position regulation)
❒check front disk brake pad conditions and wear;
❒sight inspect the conditions of: engine, gearbox,
transmission, pipes and hoses (exhaust - fuel -
brakes), rubber parts (boots, sleeves, bushes, etc;
❒check for bonnet and boot lock cleanness, lever
cleanness and lubrication;
❒check battery charge;
❒visual check on various drive belt conditions;
❒top up fluid levels (engine coolant, brakes,
windscreen washer, battery, etc.);
❒change engine oil;
❒change engine oil filter;
❒replace pollen filter (where provided).
ADDITIONAL CHECKS
Every 1,000 km or before long journeys, check and top
up if required:
❒engine coolant fluid level;
❒brake fluid level;
❒windscreen washer fluid level;
❒tyre pressure and conditions.
Every 3,000 km check and top up if required: engine
oil level.
You are recommended to use FL Selenia products,
designed and produced specifically for Fiat cars (see
table “Capacities” in section “Technical
specifications”).
262
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE

WHEELS AND TYRES
Check the pressure of each tyre, including the spare, every two weeks
and before long journeys. The pressure should be checked with the tyre
rested and cold.
For the correct tyre inflation pressure, see “Wheels” in “Technical
specifications” section.
Incorrect pressure causes abnormal tyre wear:
(A): normal pressure: tread evenly worn.
(B): low pressure: tread particularly worn at the edges.
(C): high pressure: tread particularly worn in the centre.
Tyres must be replaced when the tread wears down to 1.6 mm. In any
case, comply with the laws in the country where the car is being driven.
IMPORTANT NOTES
❒As far as possible, avoid sharp braking and screech starts, etc. Be
careful not to hit the kerb, potholes or other obstacles hard. Driving
for long stretches over bumpy roads can damage the tyres;
❒Periodically check that the tyres have no cuts in the side wall,
abnormal swelling or irregular tyre wear. If any of these occur, have
the car seen to at a Fiat Dealership;
277
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
F0H0216m

❒Avoid overloading the vehicle when travelling: this
may cause serious damage to the wheels and tyres;
❒If a tyre is punctured, stop immediately and change
it to avoid damage to the tyre, the rim, suspensions
and steering system;
❒Tyres age even if they are not used much. Cracks
in the tread rubber are a sign of ageing. In any case,
if the tyres have been on the car for over 6 years,
they should be checked by specialised personnel, to
see if they can still be used. Also remember to
check the spare wheel;
❒In the case of replacement, always fit new tyres,
avoiding those of dubious origin;
❒If a tyre is changed, also change the inflation valve;
❒To allow even wear between the front and rear
tyres, it is advisable to change them over every 10-
15 thousand kilometres, keeping them on the same
side of the car so as to not reverse the direction of
rotation.
278
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
WARNING
Never submit alloy rims to repainting treatments requiring to use temperatures
exceeding 150°C since the mechanical properties of the wheels could be impaired.WARNING
If the pressure is too low the tyre overheats and this can cause it serious damage.
WARNINGRemember that road holding depends also on the correct tyre inflating pressure.
WARNINGDo not cross switch the tyres, moving them from the right of the car to the left and
vice versa.

285
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
Upholstery of your car has been designed
to withstand wear deriving from common
use of the car. You are however
recommended to avoid strong and/or
continuous scratching with clothing
accessories such as metallic buckles, studs,
Velcro fastenings and the like, since these
items cause circumscribed stress of the
cover fabric that could lead to yarn
breaking, and damage the cover as a
consequence.
INTERIOR PLASTIC PARTS
For routine cleaning, wipe with a cloth with water and
neutral non-abrasive detergent. Remove grease or
persistent stains with appropriate products designed
to preserve the appearance of components.
IMPORTANT Never use spirit or petroleum to clean
the instrument panel or other plastic parts.STEERING WHEEL / GEARBOX LEVER
KNOB AND SEATS COATED WITH REAL
LEATHER
These components shall only be cleaned with water
and neutral soap. Never use spirit or alcohol-based
products.
Before using special products for cleaning interiors,
read carefully label instructions and indications to
make sure they are free from spirit and/or alcohol-
based substances.
If when cleaning the windscreen with special glass
products, some drops fall on the leather covering of
the steering wheel/gear lever knob remove them
immediately and then clean with water and neutral
soap.
IMPORTANT Take the utmost care when engaging
the steering lock to prevent scratching the leather
covering.
WARNINGDo not keep aerosol cans in the car: they might explode. Aerosol cans must never
be exposed to a temperature above 50°C. The temperature inside the car exposed
to the sun may go well beyond that figure.

286
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
INDEX
DASHBOARD
AND CONTROLS
TECHNICAL
SPECIFICATIONS
T T
E E
C C
H H
N N
I I
C C
A A
L L
S S
P P
E E
C C
I I
F F
I I
C C
A A
T T
I I
O O
N N
S S
IDENTIFICATION DATA ................................................. 287
ENGINE CODES - BODYWORK VERSIONS .............. 289
ENGINE ................................................................................. 290
FUEL FEED/IGNITION ....................................................... 292
TRANSMISSION .................................................................. 292
BRAKES ................................................................................... 293
SUSPENSIONS ....................................................................... 293
STEERING............................................................................... 293
WHEELS .................................................................................. 294
DIMENSIONS ........................................................................ 297
PERFORMANCE ................................................................... 298
WEIGHTS ............................................................................... 299
CAPACITIES........................................................................... 300
FLUIDS AND LUBRICANTS ............................................. 301
FUEL CONSUMPTION ....................................................... 303
CO
2EMISSIONS .................................................................. 304

293
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
INDEX
DASHBOARD
AND CONTROLS
TECHNICAL
SPECIFICATIONS
1.216V - 1.48V (◊) - 1.416V- 1.3 Multijet 70 HP
Disc, self-ventilating (257 mm x 22mm)
Drum type (203 mm)
Controlled by hand lever, working
on rear brakes
SUSPENSIONS
Front
Rear1.2
16V - 1.48V (◊) - 1.416V- 1.3 Multijet - 1.9 Multijet
Mc Pherson independent wheels
Interconnected wheels with twisting axle
STEERING
Type
Minimum steering
cycle m
(◊) Engine model provided for certain versions/markets only1.2
16V - 1.48V (◊) - 1.416V- 1.3 Multijet - 1.9 Multijet
Rack and pinion with electric power steering
10.0
1.3 Multijet 90 HP - 1.9 Multijet
Disc, self-ventilating (284 mm x 22mm)
Drum type (228 mm)
Controlled by hand lever, working
on rear brakes
BRAKES
Service brakes:– front
– rear
Parking brake
IMPORTANT Water, ice and antifreeze salt on roads may deposit on the brake discs thus reducing braking efficiency at first braking.