lock FIAT LINEA RHD 2010 1.G Service Manual

fig. 15/aF0R0228m
fig. 16F0R0230m
To change the bulb proceed as follows:

open the tailgate and loosen the two fastening screws
disconnect the central electric connector and pull the lens unit out-
wards;
release the clips Fand extract the bulb holders;
remove the bulb to replace A, B, Cor D pushing it slightly and
turning it anticlockwise (bayonet-type bulb) and replace it;

refit the bulb holder and refasten the clips F;
to replace the rear fog light, release the clips H-fig. 16, remove
the protection and replace the bayonet bulb.
reconnect the electrical connector, reposition the cluster correct-
ly on the body and then tighten the fastening screws G.
fig. 15/bF0R0229m
124
CORRECT USE
OF THE CAR
AND CONTROLS
DEVICES
MAINTENANCE
SPECIFICATIONS
INDEX
WARNING
LIGHTS AND
MESSAGES IN AN
EMERGENCY
DASHBOARD
SAFETY
CAR
TECHNICAL
LINEA Owner HAND BOOK RHD.pdf 124LINEA Owner HAND BOOK RHD.pdf 1248/21/09 2:16:20 PM8/21/09 2:16:20 PM

IF AN INTERIOR LIGHT
BURNS OUT
For the type of bulb and power rating, see
“When needing to change a bulb”.
FRONT CEILING LIGHT
To replace the bulbs proceed as follows:


work in the points shown by the ar-
rows and remove light A-fig. 21;
open the protection lid B-fig. 22;
replace bulbs Creleasing them from the
side contacts; make sure that new bulbs
are correctly clamped between contacts;
re-close the lid B-fig. 22and secure light
A-fig. 21into its housing locking it
properly.
REAR CEILING LIGHT
(where provided)
To replace the bulbs proceed as follows:

work in the points shown by the ar-
rows and remove light D-fig. 23;
open the protection lid E-fig. 24;change the bulb F-fig. 24releasing it
from the side contacts and making sure
the new bulb is correctly fastened be-
tween the contacts;re-close the protection lid E-fig. 24
and secure light D-fig. 23into its hous-
ing locking it properly.
fig. 21F0R0115m
fig. 22F0R0117m
fig. 23F0R0116m
fig. 24F0R0118m
126
CORRECT USE
OF THE CAR
AND CONTROLS
DEVICES
MAINTENANCE
SPECIFICATIONS
INDEX
WARNING
LIGHTS AND
MESSAGES IN AN
EMERGENCY
DASHBOARD
SAFETY
CAR
TECHNICAL
LINEA Owner HAND BOOK RHD.pdf 126LINEA Owner HAND BOOK RHD.pdf 1268/21/09 2:16:20 PM8/21/09 2:16:20 PM

LOADS FUSE AMPERES
Cigar lighter or socket
Boot lock actuator
Power window unit (driver’s side front window motor)
Power window unit (passenger’s side front window motor)
+15 control lighting: radio on steering wheel, control panel; power mirrors,
power window unit, alarm setup
+15 airbag node
+15 radio setup, Blu&Me setup
Power window unit, driver’s seat adjustment motor
Body computer and instrument panel node F44
F45
F47
F48
F49
F50
F51
F52
F5315
10
20
20
7.5
7.5
7.5
15
7.5
132
CORRECT USE
OF THE CAR
AND CONTROLS
DEVICES
MAINTENANCE
SPECIFICATIONS
INDEX
WARNING
LIGHTS AND
MESSAGES IN AN
EMERGENCY
DASHBOARD
SAFETY
CAR
TECHNICAL
LINEA Owner HAND BOOK RHD.pdf 132LINEA Owner HAND BOOK RHD.pdf 1328/21/09 2:16:21 PM8/21/09 2:16:21 PM

FASTENING THE TOW
RING fig. 33
Proceed as follows:

release the cap A;
take the tow hook Bfrom the sup-
port;
tighten the ring on the rear or front
threaded pin.
The power brakes and pow-
er steering will not work while
the car is being towed. More effort on
the
brake pedal and steering wheel will
therefore be required. Do not use wires
for towing. Do not jerk. Make sure not
to damage parts in contact with the
car while towing. Respect the specific
rules of the Highway Code when tow-
ing the car specifically in relation to
the towing device and the behaviour
to maintain on the road.
WARNING
fig. 33F0R0131m
Do not start the engine while
towing the car.
WARNING
Clean the threaded seat
carefully before fastening
the ring . Make sure that the ring is
fully fastened in the seat before tow-
ing the car.
WARNING
Release the steering wheel
lock before towing (see “Ig-
nition device” in “Dashboard and con-
trols”). The power brakes and power
steering will not work while the car is
being towed. More effort on the brake
pedal and steering wheel will therefore
be required. Do not use wires for tow-
ing. Do not jerk. Make sure not to
damage parts in contact with the car
while towing. Respect the specific rules
of the Highway Code when towing the
car specifically in relation to the tow-
ing device and the behaviour to main-
tain on the road.
WARNING
136
CORRECT USE
OF THE CAR
AND CONTROLS
DEVICES
MAINTENANCE
SPECIFICATIONS
INDEX
WARNING
LIGHTS AND
MESSAGES IN AN
EMERGENCY
DASHBOARD
SAFETY
CAR
TECHNICAL
LINEA Owner HAND BOOK RHD.pdf 136LINEA Owner HAND BOOK RHD.pdf 1368/21/09 2:16:21 PM8/21/09 2:16:21 PM

20 40 60 80 100 120 140 160 180
SERVICE SCHEDULE PETROL VERSIONS
Service coupons shall be performed every 20,000 kms or every 12 months whichever occur first
Thousands of kilometres
Check tyre conditions/wear and adjust pressure if
necessary
Check operation of lighting system (headlamps,
direction indicators, hazard warning lights, luggage
compartment light, passenger compartment lights,
instrument panel warning lights, etc.)
Check operation of windscreen wash/wipe
Check front disc brake pad condition and wear
Check rear drum brake linings condition and wear
Visually inspect conditions and integrity: exterior
bodywork, underbody protection(**), pipes and hoses
(exhaust - fuel - brakes), rubber parts (boots,
sleeves, bushes, etc.), Oil leakage and Coolant leakage, evaporation control system
Check cleanness of locks, bonnet and boot and
lever cleanness and lubrication
Visually inspect condition of the auxiliary drive belt/s
and accessory drive belt
Replace auxiliary drive belt/s and accessory drive
belt
Check handbrake lever travel and adjust if necessary
Replace fuel filter
Replace air filter cartridge ( )
139
CAR
MAINTENANCE
CORRECT USE
OF THE CAR
TECHNICAL
INDEX
DASHBOARD
SAFETY
WARNING
LIGHTS AND
MESSAGES IN AN
EMERGENCY
SPECIFICATIONS
AND CONTROLS
DEVICES
LINEA Owner HAND BOOK RHD.pdf 139LINEA Owner HAND BOOK RHD.pdf 1398/21/09 2:16:22 PM8/21/09 2:16:22 PM

SERVICE SCHEDULE DIESEL VERSIONS
Service coupons shall be performed every 15,000 kms
Thousands of kilometres
Check tyre conditions/wear and adjust pressure if
necessary
Check operation of lighting system (headlamps,
direction indicators, hazard warning lights, luggage
compartment light, passenger compartment lights,
instrument panel warning lights, etc.)
Check operation of windscreen wash/wipe
Check front disc brake pad condition and wear,
replace if required
Check rear drum brake linings condition and wear,
replace if required
Visually inspect conditions and integrity: exterior
bodywork, underbody protection, pipes and hoses
(exhaust - fuel - brakes), rubber parts (boot, sleeves,
bushes, etc.), Oil leakage and Coolant leakage
Check cleanness of locks, bonnet and boot and lever
cleanness and lubrication
Visually inspect condition of the auxiliary drive belt/s
and accessory drive belt, replace if required
Replace drive belt/s and accessory drive auxiliary
belt
Check handbrake lever travel and adjust if necessary
Replace fuel filter15 30 45 60 75 90 105 120 135 150 165 180Inspection
at 3000 kms
141
CAR
MAINTENANCE
CORRECT USE
OF THE CAR
TECHNICAL
INDEX
DASHBOARD
SAFETY
WARNING
LIGHTS AND
MESSAGES IN AN
EMERGENCY
SPECIFICATIONS
AND CONTROLS
DEVICES
LINEA Owner HAND BOOK RHD.pdf 141LINEA Owner HAND BOOK RHD.pdf 1418/21/09 2:16:22 PM8/21/09 2:16:22 PM

DEMANDING USE
OF THE CAR
Should prevailing use of the car be under
one of the following specially heavy con-
ditions:
trailer or caravan towing;
dusty roads;
short distances (less than 7-8 km) re-
peated and with external temperatures
below zero;
frequently idling engines or long dis-
tance low speed driving (e.g . taxis or
door-to-door deliveries) or in case of
a long term inactivity;
in cities;
perform the following inspections and
shown on the Service Schedule:

check cleanness of locks, bonnet and
boot and lever cleanness and lubrica-
tion;
visually inspect the conditions of: en-
gine, gearbox, transmission, pipes and
hoses (exhaust - fuel - brakes), rubber
parts (boots, sleeves, bushes, etc.);
check battery charge and liquid level
(electrolyte) (see paragraph “Charge
level check” in chapter “Maintenance
and care”);
visually inspect the accessory drive belt
conditions;
check pollen filter
check air cleaner and replace, if re-
quired.
REGULAR
INSPECTIONS
Every 1,000 km or before long journeys,
check and top up if required:
 engine coolant fluid level; Engine Oil level, every 3,000 km and
brake - clutch fluid level and type;
power steering fluid level;


tyre pressure and conditions;
operation of lights (headlights, direction
indicators, hazard lights, etc.);
143
CAR
MAINTENANCE
CORRECT USE
OF THE CAR
TECHNICAL
INDEX
DASHBOARD
SAFETY
WARNING
LIGHTS AND
MESSAGES IN AN
EMERGENCY
SPECIFICATIONS
AND CONTROLS
DEVICES
. If the vehicle is
replacements more frequently than
check front disk brake pad conditions
and wear; frequently than required; replace engine oil and oil filter more
frequently
than required on the service replace spark plugs more
schedules, in particular contact a Fiat
Dealership if a reduction in the
vehicle engine performance is noted;used frequently in dusty or heavily
polluted environments it is
advisable to replace the filtering
elementts more frequently, in
particular it should be replaced if a
reduction of the amount of air
admitted to the passenger
compartment is noted; top up if required;
LINEA Owner HAND BOOK RHD.pdf 143LINEA Owner HAND BOOK RHD.pdf 1438/21/09 2:16:22 PM8/21/09 2:16:22 PM

Replacing the windscreen wiper
blades fig. 10
How to remove the blade:
raise the windscreen wiper arm Afrom
the windscreen;
turn blade B90° around pin C, locat-
ed at the end of the wiper arm;
press the blade locking tabs;
remove the blade from pin C.
fig. 10F0R0236m
SPRAY NOZZLES
Windscreen washer fig. 11
If there is no jet of fluid, firstly check that
there is fluid in the reservoir: see “Check-
ing fluid levels” in this section).
Then check that the nozzle holes are not
clogged, if necessary using a needle.
The windscreen jets are directed by ad-
justing the angle of the nozzles.
Fluid jets shall be directed at about
1/3height from the window upper edge.
fig. 11F0R0143m
How to insert the blade:
insert the blade fastening tabs in the
hole on the end of the arm;
refit the arm with the blade on the
windscreen.
154
CORRECT USE
OF THE CAR
AND CONTROLS
DEVICES
SPECIFICATIONS
WARNING
LIGHTS AND
MESSAGES IN AN
EMERGENCY
CAR
MAINTENANCE
INDEX
DASHBOARD
SAFETY
TECHNICAL
LINEA Owner HAND BOOK RHD.pdf 154LINEA Owner HAND BOOK RHD.pdf 1548/21/09 2:16:35 PM8/21/09 2:16:35 PM

GENUINE LEATHER STEERING
WHEEL/GEAR LEVER KNOB
These components must be cleaned with
mild soap and water only.
Never use spirit and/or alcohol based
products.
Before using off-the-shelves products de-
signed for cleaning car interiors, make sure
that they do not contain spirit and/or al-
cohol based substances before using them.
If window cleaner accidentally drips onto
the steering wheel or gear lever knob,
wipe away immediately and then wash the
concerned area with mild soap and water. IMPORTANT Be carefully when arranging
a steering wheel lock device, where applic-
able, to prevent damaging the leather up-
holstery by rubbing. INTERIOR PLASTIC PARTS
It is advisable to clean interior parts with a
moist cloth and a solution of water and mild
soap. Use specific products for cleaning plas-
tic, without solvents and specifically de-
signed to prevent damage to the appearance
and colour of the treated parts to remove
grease and tough stains.
IMPORTANT Never use spirit or petro-
leum to clean the instrument panel.
158
CORRECT USE
OF THE CAR
AND CONTROLS
DEVICES
SPECIFICATIONS
WARNING
LIGHTS AND
MESSAGES IN AN
EMERGENCY
CAR
MAINTENANCE
INDEX
DASHBOARD
SAFETY
TECHNICAL
LINEA Owner HAND BOOK RHD.pdf 158LINEA Owner HAND BOOK RHD.pdf 1588/21/09 2:16:36 PM8/21/09 2:16:36 PM

MODEL PLATE fig. 1
This is applied to the right-hand side of the
spare wheel shelf and shows the following
data:
VIN (Vehicle Identification Number)
- Car Model and Version code
- Chassis number
IDENTIFICATION DATA
Take note of the identification codes. The
following identification codes are printed
and shown on the plates:
Model plate.
Chassis marking.
fig. 1F0R0247m
FIAT INDIA AUTOMOBILES LTD.
VIN
*
fig. 2F0R0146m
CHASSIS MARKING fig. 2
This is printed on the passegner com-
partment floor bed under the front left
seat.
car model (MCA 110 716);
chassis number.
ENGINE MARKING
Engine marking is stamped on the cylinder
block and includes the model and the
serial number.
160
CORRECT USE
OF THE CAR
AND CONTROLS
DEVICES WARNING
LIGHTS AND
MESSAGES IN AN
EMERGENCY
CAR
MAINTENANCE
INDEX
TECHNICAL
SPECIFICATIONS
DASHBOARD
SAFETY
VERSION110 716Kg
Kg
Kg
Kg 1
2
- Vehicle Mass Data
LINEA Owner HAND BOOK RHD.pdf 160LINEA Owner HAND BOOK RHD.pdf 1608/21/09 2:16:36 PM8/21/09 2:16:36 PM