seats FIAT MULTIPLA 2007 1.G Owner's Manual

124
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
PASSENGER SEAT COMPLIANCE WITH REGULATIONS ON CHILD’S SEAT USE
Fiat Multipla complies with the new European Directive 2000/3/EC regulating child’s seat assembling on the different
car seats according to the table below.
Key for the table.
U = suitable for child restraint systems of the “Universal” category, according to European Standard ECE-R44 for the
specified “Groups“
Range of weight
up to 13 kg
9 -18 kg
15 -25 kg
22 -36 kg Front
central
passenger
U
U
U
UFront
side
passenger
U
U
U
URear
central
passenger
U
U
U
URear
side
passenger
U
U
U
U Group
Group 0, 0+
Group 1
Group 2
Group 3

125
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
To sum up the safety precautions to follow when
transporting children:
❒The recommended position for installing children’s
seat is on the rear seat, as it is the most protected
in the case of a crash.
❒If the passenger’s air bag is deactivated always check
the warning light
Fon the cluster to make sure
that it has actually been deactivated.
❒Attain to the instructions for fastening the specific
child restraint system which you are using. These
instructions must be provided by the manufacturer.
Keep the child restraint system installation
instructions with the car documents and this
Handbook. Never use a child restraint system
without installation instructions.❒Always check the seat belt is well fastened by pulling
the webbing.
❒Only one child is to be strapped to each retaining
system.
❒Always check the seat belts do not fit around the
child’s throat.
❒While travelling, do not let the child sit incorrectly
or release the belts.
❒Passengers should never carry children on their
laps. No-one, however strong they are, can hold a
child in the event of a crash.
❒In case of an accident, replace the seat with a new
one.
WARNINGWith passenger’s air bag active, never place child’s seats with the cradle facing
backwards since the air bag activation could cause to the child serious injuries,
even mortal, regardless of the seriousness of the crash that triggered it. You are
advised to carry children always with proper restraint systems on the rear seats, as
this is the most protected position in the case of a crash.

126
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
PRESETTING FOR MOUNTING THE
“ISOFIX TYPE” CHILD RESTRAINT SYSTEM
Fiat Multipla is created preset for mounting the Isofix type child restraint
system, a new European standardised system for mounting child
restraints. Isofix type child restraint system is an additional option that
does not prevent from using traditional child restraint systems.
Isofix type child restraint system covers three groups: 0, 0+ and 1.
Due to its different anchoring system, the Isofix type child’s seat shall be
anchored just using the proper metal brackets set between rear seat back
and cushion, which can be identified by the slots (A).
It is possible to mount both the traditional restraint system and the Isofix
type one. Max. two Isofix type child’s seats can be installed on the rear
seat using the proper couplings. On the front passenger’s seat only
traditional child’s seats can be mounted.
Only adopt Isofix type child’s seats designed, tested and approved for Fiat
Multipla.
F0E0217m
WARNINGMount the child restraint system only with the car stationary. The Isofix type child
restraint system is properly anchored to the mounting brackets when clicks are
heard. In any case, keep to the installation instructions that must be provided by
the child restraint system’s Manufacturer.

130
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
Driver’s and passenger’s airbags have been designed and calibrated to
improve the protection of a person wearing seat belts.
At their maximum inflation, their volume fills most of the space between
the steering wheel and the driver and between the dashboard and the
passenger.
In minor front crashes (for which the restraining action of the seat belts
is sufficient), the airbags will not deploy. Also in this case it is of vital
importance to wear the seat belts since in case of front crash they
guarantee proper positioning of the car occupant.
DRIVER’S FRONT AIRBAG
It consists of an instant-inflating cushion contained in a special recess in
the centre of the steering wheel.
PASSENGER’S FRONT AIRBAG
It consists of an instant-inflating cushion contained in a special recess in
the dashboard; its volume is bigger than the driver’s one.
WARNINGSERIOUS DANGER: The car is fitted with airbag on passenger’s side. Never place
cradle child’s seats on the front passenger seat of cars fitted with passenger’s
airbag since the airbag activation could cause serious injuries, even mortal. In the
case of need, always deactivate the passenger’s airbag when a child’s seat is placed
on the front seat. The front passenger seat shall be adjusted in the most backward
position to prevent any contact between child’s seat and dashboard. Even if not
compulsory by law, you are recommended to reactivate the airbag immediately as
soon as child transport is no longer necessary.
F0E0740m
F0E0222m

134
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
GENERAL WARNINGS
WARNING
Never travel with objects on your lap, in front of your chest or with a pipe,
pencil, etc. between your lips; injury may result in the event of the air bag being
triggered.WARNING
Do not cover the backrest of front seats with trims or covers that are not suitable
to be used with side bags.
If the car has been stolen or an attempt to steal it has been made, if it has been
subjected to vandals or floods, have the air bag system checked by Fiat
Dealership.WARNING
WARNINGAlways keep your hands on the steering wheel rim when driving, so that if the air
bag is triggered, it can inflate without meeting any obstacles which could cause
serious harm to you. Do not drive with the body bent forwards, keep the seat back
rest in the erect position and lean your back well against it.
WARNINGIf when turning the ignition key to MAR, the warning light ¬does not turn on or if
it stays on when travelling there could be a failure in safety systems; in this event
air bags or pretensioners could not trigger in case of impact or, in a minor number
of cases, they could trigger accidentally. Contact Fiat Dealership immediately to
have the system checked.

175
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
REFITTING THE STANDARD WHEEL
❒Following the procedure described previously, raise the car and
remove the space-saver spare wheel;
❒fit the standard wheel.
Make sure that the resting surface of the spare wheel is clean and there is
no dirt that could cause the bolts to loosen.
❒Tighten the bolts with the wrench supplied;
❒Lower the car and remove the jack;
❒Tighten the bolts in the sequence shown before;
❒Make sure the retaining ring (B) is inserted in the seats of the hub cap
so that the protruding section of the inflation valve is aligned with
symbol
Cmarked on the inside of the hub cap;
❒Press-fit the wheel cap on the rim, making sure symbol
Con the inside
of the cap, corresponds with the inflation valve.
Incorrect fitting may cause the wheel cap to come off when the car is
travelling.
F0E0619m
F0E0247m

191
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
THIRD BRAKE LIGHTS
To replace 12V-3W bulbs:
❒with the tailgate open, undo the four fastening screws under the caps
(shown by the arrows) and remove the panel;
❒take out connection (A);
❒undo the four screws securing the light unit and remove the cover
(B);
❒remove the bulbs (C) to be replaced from their seats.
After replacing the bulb, refit the two halves of the light unit then secure
the latter to the covering panel after reconnecting the electric
connection; refit the panel to the tailgate.
NUMBER PLATE LIGHTS
To replace the 12V-5W bulb:
❒using a screwdriver in the direction of the arrow, compress catch (F)
and take out the number plate light unit;
❒remove bulb holder and lens (D);
❒take out the bulb holder turning it slightly and replace the bulb (E).
F0E0254m
F0E0146m
F0E0676m

231
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
CAR
MAINTENANCE
Windows
Use specific window cleaner products to clean cloths
to avoid scratching the glass or damaging the
transparency.
IMPORTANT The inside of the rear window should
be wiped gently with a cloth in the direction of the
filaments to avoid damaging the heating device.
Engine compartment
At the end of the winter the engine compartment
should be carefully washed, without directing the jet
against electronic control units. Contact a specialised
workshop to have this done.
IMPORTANT Wash with the engine cold and the
ignition key at STOP. After washing make sure that the
various protections (e.g. rubber caps and various
covers) have not been damaged or removed.
Front headlights
IMPORTANT Never use aromatic substances (e.g.:
petrol) or ketones (e.g.: acetone) for cleaning front
headlight plastic lens.
IMPORTANT Wash with the engine cold and the
ignition key at STOP. After washing make sure that the
various protections (e.g. rubber caps and various
covers) have not been damaged or removed.INTERIORS
Periodically check that water is not trapped under the
mats (due to water dripping off shoes, umbrellas, etc.)
which could cause oxidisation of the sheet metal.
CLEANING SEATS AND FABRIC/JERSEY
UPHOLSTERY
❒Use a soft brush or vacuum cleaner to remove dust.
❒Rub the seats with a sponge moistened with a
solution of water and neutral detergent.
PLASTIC PARTS INSIDE THE CAR
Clean the plastic parts inside the car with a cloth
moistened with a solution of water and non-abrasive
neutral detergent. To remove grease or hard stains,
use special solvent-free products designed not to alter
the appearance and colour of components.
IMPORTANT Do not use alcohol or petrol to clean
the instrument panel.
Detergents cause water pollution.
Therefore the engine compartment should
be washed in areas equipped for
collecting and purifying the liquid used in
the washing process.

243
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
COLD TYRE INFLATION PRESSURE (bar)
Add +0.3 bar to the prescribed inflation pressure when the tyres are warm. Recheck pressure value with cold tyres.
With snow tyres, add +0.2 bar to the inflation pressure value prescribed for standard tyres.
Space-saver spare
wheel 1 arranged in the boot
500 kg load (arranged
in the proper space ob-
tained by removing the
rear seats, without ex-
ceeding the max. load
admitted on rear axle) From 4 people plus
40 kg load up to
a maximum of
6 people plus 60 kg
load
(arranged in the boot) From 1 person
(driver)
to 4 people
plus 40 kg load
(arranged in the boot) Tyre
Front Rear Front Rear Front Rear
185/65 R15 88H 2.3 2.3 2.5 2.5 2.5 3.0 4.2
195/60 R15 88H 2.3 2.3 2.5 2.5 2.5 3.0 4.2
205/45 R17 88V 2.7 2.7 2.8 2.9 2.7 2.9 4.2

244
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
DIMENSIONS
Boot volume (VDA standards):
❒normal conditions 430 dm
3.
❒up to roof and with rear seats
removed 1900 dm
3.
height is with car unladen.
Dimensions in mm
F0E0653m
ABCDE FGH
100 16V837 2666 586 4089 1695 1515 1871 1520
JTD 120837 2666 586 4089 1695 1515 1871 1520