tow FIAT PANDA 2007 169 / 2.G 4x4 Supplement Manual

1
FIAT PANDA 4 x 4
This Supplement describes the main fea-
tures of Fiat Panda 4 x 4 versions togeth-
er with a few instructions for use. For all
the other information not contained here-
in, refer to the Owner Handbook this sup-
plement is attached to.
FIAT PANDA 4 x 4 DRIVE LINE
Fiat Panda 4 x 4 drive line features
two differentials and a viscous joint.
Thanks to this system, under poor
grip conditions the four-wheel drive
will engage automatically (i.e.: no
driver’s action required) and provide
optimum torque distribution be-
tween front and rear axle.
Fiat Panda 4 x 4 is therefore suited
for all types of roads: in fact, it is ca-
pable of coping well with snowy, icy,
muddy and dirt roads, even with
steep slopes.SUMMARY
ABS SYSTEM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
ELD - ELECTRONIC LOCKING DIFFERENTIAL . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
HEADLIGHT WASHER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
IF A TYRE IS PUNCTURED . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
IF AN EXTERIOR LIGHT BURNS OUT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
WASHING THE CAR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
TOWING THE CAR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
TOWING TRAILERS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
SERVICE SCHEDULE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
ENGINE CODES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
BODY VERSIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
WHEELS AND TYRES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
INFLATING PRESSURES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
SNOW CHAINS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
TRANSMISSION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
STEERING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
DIMENSIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
PERFORMANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
CAPACITIES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
WEIGHTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21
FUEL CONSUMPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
CO
2EMISSIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
603.83.460 PANDA 4X4 GB 26-06-2007 11:19 Pagina 1

6
FIAT PANDA 4 x 4
After changing the wheel
❒put the jack partly open and the tools
used into the tool bag;
❒stow the bag with tools into its place
under the driver’s seat.
IMPORTANT Replaced wheel shall be
placed in the boot under the cover mat as
shown in fig. 10.
IMPORTANT Do not use inner tubes
with tubeless tyres. Check tyre and space-
saver spare wheel pressure regularly.IMPORTANT Changing original wheels
with others of different type (i.e.: with al-
loy rim instead of steel rims and vice ver-
sa) will involve to change the whole set
of wheel bolts with others of suitable
length. It is however recommended to
keep replaced bolts in the event of future
refitting of the original wheels.
fig. 10F0G0615m
603.83.460 PANDA 4X4 GB 26-06-2007 11:19 Pagina 6

10
FIAT PANDA 4 x 4
WASHING THE CAR
After using the car off-road (wheels, body,
underengine and underbody protections
very dirty), remember to wash it and to
clean accurately radiators (engine and air-
conditioner), radiator fan and wheels (rims
and wheelhouses), underengine and un-
derbody protections to preserve their
regular operation and to guarantee prop-
er ventilation of brake discs, perfect wheel
geometry and regular operation of the
propeller shaft.
TOWING THE CAR
The car can only be towed in one of the
following ways (always and exclusively
with the engine off, gearbox in neutral and
handbrake disengaged):
– with the 4 wheels on the roadbed;
– with front wheels raised or resting on
the wrecking car floor and rear wheels
resting on a suitable truck;
– with rear wheels raised or resting on the
wrecking car floor and front wheels rest-
ing on a suitable truck;
– on wrecking car, with front and rear
wheels resting on the wrecking car floor.
TOWING TRAILERS
IMPORTANT If the car is used at its max.
towing capacity on sloping road, change
engine oil every 10,000 km.
As concerns tow hook installation in-
structions and warnings refer to the at-
tached Owner Handbook.
The assembly diagram with the new tow
hook fixing points is given below.
603.83.460 PANDA 4X4 GB 26-06-2007 11:19 Pagina 10

11
FIAT PANDA 4 x 4
ASSEMBLY DIAGRAM, fig. 24
The tow hook structure must be fastened
in the points identified by symbol Øus-
ing a total of 4 M8 screws and 2 M12
screws. Internal plates 1 thickness shall be
6mm. The hook should be fastened to the
body avoiding any type of drilling and trim-
ming of the rear bumpers that remains vis-
ible when the hook is removed.
IMPORTANT It is compulsory to fasten,
at the same height as the tow hook and
in a clearly visible position, a label of suit-
able size and material with the following
information: MAX LOAD ON BALL 60 kg
After fitting, screw holes shall be sealed to
prevent an exhaust gas inlet.
fig. 24F0G0266m
existing screw
existing hole
existing hole
standard tow ball existing hole
existing
screw
existing hole
603.83.460 PANDA 4X4 GB 26-06-2007 11:19 Pagina 11

21
FIAT PANDA 4 x 4
Fiat Panda 4 x 4Fiat Panda 4 x 4
ClimbingFiat Panda 4 x 4
CROSS
WEIGHTS
Weights (kg)
Kerb weight
(including fuel, space-saver
spare wheel, tools and accessories):
Payload (*)
including the driver:
Maximum admitted loads (**)
– front axle:
– rear axle:
– total:
Towable loads
– trailer with brakes:
– trailer without brakes:
Maximum load on roof (***):
Maximum load on tow hitch
(trailer with brakes):
(*) If special equipment is fitted (sunroof, tow hitch, etc.) the unladen car weight increases, thus reducing the payload as specified
in the max. admitted loads.
(**)Loads not to be exceeded. The driver is responsible for arranging the loads in the boot and/or on the
roof so that they comply with these limits.
(***) Lineaccessori Fiat roof rack, max. capacity: 50 kg.petrol Multijet
965 1060
445 445
750 825
735 735
1410 1505
800 900
400 400
50 50
60 60petrol Multijet
980 1075
445 445
750 825
735 735
1425 1520
800 900
400 400
50 50
60 60Multijet
1090
445
830
735
1535
900
400
50
60
603.83.460 PANDA 4X4 GB 26-06-2007 11:19 Pagina 21