Complete manual FIAT PANDA 2007 169 / 2.G Owners Manual

41
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IIN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
Air recirculation on/off knob C
U= outside air intake
T= inside air recirculation
This function is particularly useful when
the outside air is heavily polluted (in a traf-
fic jam, tunnel etc.). However, it is better
not to use it for long periods, especially
if there several people in the car.
IMPORTANT The inside air recirculation
system makes it possible to reach the re-
quired “heating” or “cooling” conditions
faster. Do not use the air recirculation
function on rainy/cold days as it could con-
siderably increase the possibility of the
windows misting inside.Air distribution knob D
¥air flow from central vents and side
outlets;
μto warm the feet and keep the face
cool (“bilevel” function);
wto speed up passenger compartment
warming;
≤to warm the passenger compartment
and at the same time demist the wind-
screen;
-to demist and defrost the windscreen
and front side windows.
VENTILATON
To ventilate the passenger’s compartment
properly proceed as follows:
❒central and side vents completely open;
❒turn knob Ato the blue section;
❒turn knob Cto U;
❒turn knob Dto ¥;
❒
turn knob Bto the required speed.
MANUAL CLIMATE
CONTROL SYSTEM
(where provided)
CONTROLS fig. 47
Air temperature knob A
(mixing hot and cold air)
Red section = hot air
Blue section = cold air
Fan activation and climate control
system on/off knob B
0= fan off
1-2-3= fan speed
-= top fan speed
Press the knob to turn the climate control
system on, the knob led will turn on. Press
it again to turn it off, the knob led will turn
off.
fig. 47F0G0600m
032-059 Panda New GB 21-06-2007 13:48 Pagina 41

USING THE MANUAL
GEARBOX
To engage the gears, press the clutch ped-
al fully and shift the gear lever into one of
the required positions (the diagram is
shown on the knob fig. 2).
IMPORTANT The car can only be put in-
to reverse gear when it has stopped mov-
ing completely. With the engine running,
before engaging the reverse, wait at least
2 seconds with the clutch pedal fully down
to prevent damage and grating of the
gears.
To engage reverse Rfrom neutral, lift the
sliding ring Aunder the knob and shift the
lever to the right and back. To release the handbrake:
❒slightly lift the handbrake and press re-
lease button A;
❒keep button Apressed and lower the
lever. Warning light xwill turn off.
Press the brake pedal when carrying out
this operation to prevent the car from
moving accidentally.
fig. 2F0G0060m
105
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
To change gears properly
you must push the clutch
pedal fully down. It is therefore es-
sential that there is nothing under the
pedals: make sure the mats are lying
flat and do not get in the way of the
pedals.
WARNING
Do not drive with your hand
resting on the gear lever as
the force exerted, even if
slight, could lead over time to
premature wear on the gearbox inter-
nal components.
101-112 Panda New GB 21-06-2007 13:50 Pagina 105