Diagram FIAT PANDA 2008 169 / 2.G 4x4 Supplement Manual
[x] Cancel search | Manufacturer: FIAT, Model Year: 2008, Model line: PANDA, Model: FIAT PANDA 2008 169 / 2.GPages: 26, PDF Size: 1.16 MB
Page 11 of 26
10
FIAT PANDA 4 x 4
WASHING THE CAR
After using the car off-road (wheels, body,
underengine and underbody protections
very dirty), remember to wash it and to
clean accurately radiators (engine and air-
conditioner), radiator fan and wheels (rims
and wheelhouses), underengine and un-
derbody protections to preserve their
regular operation and to guarantee prop-
er ventilation of brake discs, perfect wheel
geometry and regular operation of the
propeller shaft.
TOWING THE CAR
The car can only be towed in one of the
following ways (always and exclusively
with the engine off, gearbox in neutral and
handbrake disengaged):
– with the 4 wheels on the roadbed;
– with front wheels raised or resting on
the wrecking car floor and rear wheels
resting on a suitable truck;
– with rear wheels raised or resting on the
wrecking car floor and front wheels rest-
ing on a suitable truck;
– on wrecking car, with front and rear
wheels resting on the wrecking car floor.
TOWING TRAILERS
IMPORTANT If the car is used at its max.
towing capacity on sloping road, change
engine oil every 10,000 km.
As concerns tow hook installation in-
structions and warnings refer to the at-
tached Owner Handbook.
The assembly diagram with the new tow
hook fixing points is given below.
604.39.016 PANDA 4X4 GB 6-05-2008 13:22 Pagina 10
Page 12 of 26
11
FIAT PANDA 4 x 4
ASSEMBLY DIAGRAM, fig. 24
The tow hook structure must be fastened
in the points identified by symbol Øus-
ing a total of 4 M8 screws and 2 M12
screws. Internal plates 1 thickness shall be
6mm. The hook should be fastened to the
body avoiding any type of drilling and trim-
ming of the rear bumpers that remains vis-
ible when the hook is removed.
IMPORTANT It is compulsory to fasten,
at the same height as the tow hook and
in a clearly visible position, a label of suit-
able size and material with the following
information: MAX LOAD ON BALL 60 kg
After fitting, screw holes shall be sealed to
prevent an exhaust gas inlet.
fig. 24F0G0266m
existing screw
existing hole
existing hole
standard tow ball existing hole
existing
screw
existing hole
604.39.016 PANDA 4X4 GB 6-05-2008 13:22 Pagina 11