steering wheel adjustment FIAT PANDA 2016 319 / 3.G Owners Manual

LOCKING/UNLOCKING
DOORS FROM THE
OUTSIDE
Mechanical key:insert the metal
insert in the lock and turn it.
Key with remote control(for
versions/markets where provided):
press the
button to lock the doors, or
the
button to unlock the doors.
IMPORTANT Before opening a door,
ensure that you can do it in conditions
of safety. Open the doors only when the
vehicle is stationary.
CHILD SAFETY DEVICE
6)This system prevents the rear doors
from being opened from the inside.
The device A fig. 5 can only be
engaged with the doors open:
❒position 1 - device engaged (door
locked);
❒position 2 - device not engaged (door
may be opened from the inside).
The device remains engaged even if the
doors are electrically unlocked.
IMPORTANT The rear doors cannot be
opened from the inside when the child
safety device is engaged.
WARNING
6)Always use this device when carrying
children. After engaging the child lock
on both rear doors, check for proper
engagement by trying to open a rear door
with the internal handle.
SEATS
FRONT SEATS
7) 8) 9) 10)2)Longitudinal adjustment
Lift lever A fig. 6 and push the seat
forwards or backwards: in the driving
position your arms should rest on
the rim of the steering wheel.
Height adjustment
(for versions/markets, where provided)
Adjust lever B fig. 6 upwards or
downwards to obtain the required
height.
IMPORTANT Carry out the adjustment
whilst seated in the driver's seat.
5F1D0030
6F1D0007
11

REAR HEAD RESTRAINTS
Upwards adjustment: raise the head
restraint until it clicks into place.
Downwards adjustment: press
button A fig. 13 and lower the head
restraint.
IMPORTANT If the rear seats are used,
always set the head restraints in the
"completely raised" position.
Removal
Proceed as follows to remove the head
restraints:
❒raise the head restraints to their
maximum height;
❒press buttons A and B fig. 13 at the
side of the two supports, then remove
the head restraints by pulling them
upwards.
WARNING
11)All adjustments must be made with the
vehicle stationary. Head restraints must
be adjusted so that the head, rather than
the neck, rests on them. Only in this case
can they protect your head correctly.
12)To make the best use of the head
restraint's protective action, adjust the
backrest so that your torso is upright and
keep your head as close as possible to the
head restraint.
STEERING WHEEL
13) 14)
ADJUSTMENTS
The steering wheel can be adjusted
vertically.
To adjust, move lever A fig. 14
downwards to position 1, then adjust
the steering wheel to the most suitable
position and lock it in position by
moving lever A to position 2.
13F1D0012
14F1D0013
14
GETTING TO KNOW YOUR CAR

WARNING
136)If the replaced fuse blows again,
contact a Fiat Dealership.
137)Never replace a blown fuse with metal
wires or other material.
138)Never replace a fuse with another with
a higher amp rating; DANGER OF FIRE.
139)If a general fuse (MEGA-FUSE,
MIDI-FUSE, MAXI-FUSE) cuts in, do not
attempt any repair and contact a Fiat
Dealership.
140)Before replacing a fuse, make sure
that the ignition key has been removed and
that all the other devices are switched off
and/or deactivated.
141)If a general protection fuse for safety
systems (airbag system, braking system),
power unit systems (engine system,
transmission system) or steering system
blows, contact a Fiat Dealership.
WARNING
50)If you need to wash the engine
compartment, take care not to directly hit
the fuse box and the window wiper motors
with the water jet.
CHANGING A WHEEL
142) 143) 144) 145) 146)
JACK
Important notes:
❒the jack weight is 1.76 kg;
❒the jack requires no adjustment;
❒the jack cannot be repaired and in
the event of a fault it must be replaced
by another original one;
❒no tool other than its cranking device
may be fitted on the jack.
CHANGING PROCEDURE
Proceed as follows:
❒stop the vehicle in a position that is
not dangerous for oncoming traffic
where you can change the wheel safely.
The ground should be flat if possible,
and sufficiently firm;
❒switch off the engine, pull up the
handbrake and engage the 1
stgear or
reverse. Wear the reflective safety
jacket (compulsory by law) before
getting out of the vehicle;
❒open the luggage compartment, pull
tab A fig. 109 and lift up the mat;❒using the wrench A fig. 110 located
in the tool box, loosen the locking
device, take the tool box B and place it
close to the wheel to be replaced.
Then take the space-saver wheel C.
For the Panda VAN and Panda 4x4
versions, the jack and the tools can be
located under the passenger side
front seat;
109F1D0072
110F1D0073
112
IN AN EMERGENCY

Rear fog lights ................................ 18
Rear light clusters (bulb
replacement) ................................ 107
Rear view mirrors ........................... 15
Refuelling the vehicle ......................
Replacing a bulb ............................ 103
Reversing light/rear fog light ........... 10
SBR (Seat Belt Reminder)
system ......................................... 72
Scheduled servicing ....................... 122
Seat belts....................................... 71
Seats ............................................. 11
– Adjustments .............................. 11
Side bags....................................... 88
Side lights/daytime running lights
(bulb replacement) ....................... 107Snow chains .................................. 154
Starting the engine ......................... 92
Steering lock .................................. 9
Steering wheel ............................... 14
Steering wheel stalks
– left stalk..................................... 16
– right stalk .................................. 20
Stop/Start system .......................... 96
Sun roof ......................................... 26
Supplementary Restraint System
(SRS) - Airbag .............................. 85
Supplies ......................................... 166
Symbols......................................... 4
Technical specifications ................ 141The keys ........................................ 8
Towing the vehicle .......................... 119
Towing trailers ................................
TP system ...................................... 66
Version with LPG system .............. 32
Version with methane system
(Natural Power) ............................ 34
Warning lights on panel ................ 41
Weights.......................................... 158
Wheel (changing)............................ 114
Wheels and tyres ........................... 139
Wheels ........................................... 1
Window cleaning............................ 20
Windscreen/rear window wiper ...... 138
INDEX 99
99
FCA Italy S.p.A. – Mopar – Technical Services – Service Engineering
Largo Senatore G. Agnelli, 3 - 10040 Volvera - Turin (Italy)
Print no. 603.9 9 .846 - 1 1/2015 - 1 Edition 7
48