check engine FIAT PUNTO 1995 176 / 1.G Service Manual

FIAT PUNTO 1995 176 / 1.G Service Manual PUNTO 1995 176 / 1.G FIAT FIAT https://www.carmanualsonline.info/img/10/4691/w960_4691-0.png FIAT PUNTO 1995 176 / 1.G Service Manual

Page 54 of 225

FIAT PUNTO 1995 176 / 1.G Service Manual 
2A*10 SOHC (8-valve) petrol engine in-car repair procedures 
4.7 Removing the timing belt cover bottom bolt 
7 Unbolt and remove the timing belt cover. Note the bolt located at the bottom of the cove

Page 55 of 225

FIAT PUNTO 1995 176 / 1.G Service Manual 
2A*10 SOHC (8-valve) petrol engine in-car repair procedures 
I To make o camshaft sprocket holding ; tool, obtain two lengths of steel strip I about 6 mm thick by 30 mm wide or ; similar, one €00 m

Page 56 of 225

FIAT PUNTO 1995 176 / 1.G Service Manual 
2A*10 SOHC (8-valve) petrol engine in-car repair procedures 
6.3 Camshaft cover gasket 
not attempt to lover it ofl • instead free >t by working around the cover and lapping it lightly with a soft-

Page 57 of 225

FIAT PUNTO 1995 176 / 1.G Service Manual 
2A*10 SOHC (8-valve) petrol engine in-car repair procedures 
Preparation for refitting 16 The mating faces of the cylinder head and cylinder block must be perfectly clean before 
refitting
 the head.

Page 58 of 225

FIAT PUNTO 1995 176 / 1.G Service Manual 
2A*10 SOHC (8-valve) petrol engine in-car repair procedures 
10.10 Tighten the flywheel bolt to the specified torque However, it may be possible lo have it surface*ground; seek (he advice of a Rat de

Page 59 of 225

FIAT PUNTO 1995 176 / 1.G Service Manual 
2A*10 SOHC (8-valve) petrol engine in-car repair procedures 
require cutting with a sharp Knife to release 
the sump.
 Clean away all old gasket material. Refitting 
5
 Wwn refitting, a bead of RTV s

Page 60 of 225

FIAT PUNTO 1995 176 / 1.G Service Manual 
2A*10 SOHC (8-valve) petrol engine in-car repair procedures 
13.13b Using a socket to lit a new oil sea! to the oil pump 
Refitting 14 Bolt the pump into position using a new joint gasket (see illust

Page 61 of 225

FIAT PUNTO 1995 176 / 1.G Service Manual 
2B»1 
Chapter 2 Part B: 
DOHC (16-valve) petrol 
engine in-car repair procedures 
Contents 
Auxiliary drlvebelts - removal and refitting See Chapter 1A Camshaft oil seal - renewal 6 Camshafts and ca

Page 64 of 225

FIAT PUNTO 1995 176 / 1.G Service Manual 
2B*4 DOHC (16-valve) petrol engine in-car repair procedures 
4.8 Undo three bolts and romove tho crankshaft pulley from the sprocket 
Crankshaft setting toot fabrication 7 To make Ihe crankshafl sett

Page 65 of 225

FIAT PUNTO 1995 176 / 1.G Service Manual 
2B*5 DOHC (16-valve) petrol engine in-car repair procedures 
4.11a Release the crankshaft TDC sensor wiring from the clip on the upper timing cover... throttle potentiometer and the Idle control step