light FIAT QUBO 2008 1.G Dualogic Transmission Manual

PERFORMANCE ..........................................................................15
TRANSMISSION ..........................................................................16
WEIGHTS.......................................................................................17
CAPACITIES...................................................................................18
FLUIDS AND LUBRICANTS ....................................................18
FUEL CONSUMPTION ..............................................................19
CO
2EMISSIONS ..........................................................................19
CONTENTS
READY TO START .......................................................................3
OPERATING MODE .....................................................................4
WARNING LIGHTS AND MESSAGES...................................10
TOWING THE CAR................................................................. 13
FUSE REPLACEMENT ................................................................13
SERVICE SCHEDULE...................................................................14
CHECKING FLUID LEVELS.......................................................14
ENGINE CODE - BODYWORK VERSIONS.........................15
604_39_872 DUALOGIC Fiorino Qubo GB 8-10-2008 15:59 Pagina 2

7
If the ECOfunction is used the display will
show the letter E(Economy) next the
gear engaged fig. 6.
IMPORTANT If the display does not show
the gear engaged after 10 seconds with the
ignition key in MAR, turn the ignition to
STOP, wait for the display to turn off and
then repeat the manoeuvre. If the prob-
lem persists, contact the Fiat Dealership.ENGINE STARTING
The system permits engine start-up with
a gear engaged and also with the gearbox
in neutral (N); the brake pedal must al-
ways be pressed with the gear engaged.
It is advisable to place the gear lever in
neutral (N) before starting the engine.
After start-up:
❒the gearbox automatically engages neu-
tral (N)
❒the lever remains in the same position
as the last time the engine was turned
off
❒the display will show the letter (N) and,
when the brake pedal is released, a
buzzer together with the flashing of the
letter (N), will signal any inconsistency
between the position of the lever and
the gear engaged
❒the gears that may be engaged are 1st,
2ndor reverse (R), with the brake ped-
al pressed.
IMPORTANT If start-up is requested with
the gearbox in a position other than N
and without the brake pedal pressed, dis-
play shows a dedicated message see
(“Warning lights and messages” para-
graph). In this case, repeat the starting
procedures pressing the brake pedal.
fig. 6F0T0228m
If the engine does not start
with the gear engaged, a po-
tentially hazardous situation
because the gearbox has au-
tomatically shifted to neutral is indi-
cated by a buzzer.
IMPORTANT If the starting request takes
place with the gearbox in failure condi-
tions, carry out the “Delayed ignition”
procedure (also see relevant messages):
turn the key to the AVVposition for at
least 7 seconds with the brake depressed
and the engine will start. The system will
remain in recovery mode (maximum
speed permitted: 3
a, Automatic mode not
available). If the engine does not start, con-
tact a Fiat Dealership.
IMPORTANT When the driver’s door is
opened, the system activates the hydraulic
part to prepare it for subsequent engine
start-up.
604_39_872 DUALOGIC Fiorino Qubo GB 8-10-2008 15:59 Pagina 7

10
WARNING LIGHTS
AND MESSAGESREDUCE GEAR CHANGES
The warning light comes on in the panel
(together with a message in the display) to
signal the incorrect use of the gearbox by
the driver.
Incorrect use (by the driver) could auto-
matically activate a procedure for pro-
tecting the system.MANUAL METHOD
UNAVAILABLE
The message appears in the display when
it is not possible to select MANUAL
mode with the engine running.
DUALOGIC™
GEARBOX FAILURE
(red)
When the ignition key is turned
to MAR, the warning light turns on and
should go off after a few seconds.
The warning light in the panel comes on
flashing (together with a message in the
display and a buzzer) to indicate that the
gearbox is faulty.
t
If the gearbox is faulty, con-
tact a Fiat Dealership as
soon as possible to check
the system.
If the warning light (together
with the message in the dis-
play) continues to remain on
in the panel, go to a Fiat
Dealership.
Contact a Fiat Dealership if
the message remains in the
display.
AUTOMATIC METHOD
NOT AVAILABLE
The message appears in the display when
it is not possible to select AUTOmode
with the engine running.
Contact a Fiat Dealership if
the message remains in the
display.
604_39_872 DUALOGIC Fiorino Qubo GB 8-10-2008 15:59 Pagina 10