engine FIAT QUBO 2016 1.G Repair Manual

IMPORTANT If the battery remains with the charge
below 50% for a long time it becomes damaged
through sulphation and its starting capacity is
reduced.
The battery is also more prone to the risk of freezing
(at temperatures as high as -10°C).
Refer to the paragraph "Vehicle inactivity" in "Starting
and driving" if the vehicle is left parked for a long
time.
If, after buying the vehicle, you want to install
electric accessories which require permanent electric
supply (alarm, etc.) contact the Fiat Dealership
whose qualified personnel, in addition to suggesting
the most suitable devices, will evaluate the overall
electric absorption, checking whether the vehicle
electric system is capable of withstanding the load
required, or whether it should be integrated with
a more powerful battery.
Since these devices continue to use electricity even
when the engine is off, they gradually run down
the battery.
WHEELS AND TYRESCheck the pressure of each tyre, including the spare,
every two weeks and before long journeys. The
pressure should be checked with the tyre rested and
cold.
It is normal for the pressure to increase when the
vehicle is used; for the correct tyre inflation
pressure, see “Wheels” in the “Technical
specifications” section.
Incorrect pressure causes abnormal tyre wear
fig. 173:A
normal pressure: tread evenly worn.
Blow pressure: tread particularly worn at the edges.C
high pressure: tread particularly worn in the
centre.
The tyres must be replaced when the tread is less
than 1.6 mm thick. In all cases, follow the laws in
force in the country where you are driving.fig. 173
F0T0013
182KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

SPRAY NOZZLES
If the jet is not coming out, firstly check that there is
fluid in the windscreen/rear window reservoir (for
versions/markets where provided) (see “Checking
levels” in this section).
Then check that the nozzle holes are not clogged;
use a needle to unblock them if necessary.
Windscreen (washer)
The window washer jets are fixed. The nozzle
holders are located under the bonnet (see fig. 175).
Rear window (washer)
The rear window washer jets are fixed. The nozzle
holder is located above the rear window (see ).
BODYPROTECTION FROM ATMOSPHERIC
ELEMENTS
The main causes of corrosion are the following:
❒atmospheric pollution
❒salty air and humidity (coastal areas, or hot humid
climates)
❒seasonal environment conditions.
The abrasive action of wind-borne atmospheric dust
and sand, as well as mud and gravel raised by other
cars is also not to be underestimated.
Fiat used the best manufacturing technologies on
your vehicle to effectively protect the bodywork
against corrosion.
These are the most important:
❒painting products and systems which give the
vehicle particular resistance to corrosion and
abrasion;
❒use of galvanised (or pre-treated) steel sheets,
with high resistance to corrosion;
❒spraying the underbody, engine compartment,
wheelhouse internal parts and other parts with
highly protective wax products;
fig. 175
F0T0090
186KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

Windows
Use specific detergents to clean the windows. Also
use clean cloths to avoid scratching the glass or
altering the transparency.
IMPORTANT Wipe the rear window gently with a
cloth in the direction of the filaments to avoid
damaging the heating device.
Engine compartment
At the end of each winter, thoroughly wash the
engine compartment, taking care to avoid spraying
the water jet directly onto the electronic control
units and the relay/fuse box on the left side of the
engine compartment (as you look from behind
the wheel). Have this operation performed at a
specialist garage.
IMPORTANT The washing should take place with the
engine cold and the ignition key in the STOP
position. After the wash, make sure that the various
protective devices (e.g. rubber caps and guards)
have not been removed or damaged.
Front headlights
IMPORTANT Never use aromatic substances (e.g.
petrol) or ketenes (e.g. acetone) for cleaning the
plastic lenses of the front headlights.
INTERIORSCheck regularly that water is not trapped under the
mats (from dripping off shoes, umbrellas, etc.) which
could cause the metal to rust.
WARNING
Never use flammable products, such as
petroleum ether or modified petrol,
to clean the inside of the vehicle.The
electrostatic charges which are generated by
rubbing during the cleaning operation may
cause a fire.
WARNING
Do not keep aerosol cans in the vehicle:
these could explode. Aerosol cans must
not be exposed to temperatures of more than
50°C .When the vehicle is exposed to sunlight ,
the temperature inside can greatly exceed
this value.
189KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCYSERVICING AND
MAINTENANCETECHNICAL
SPECIFICATIONS
INDEX

TECHNICAL SPECIFICATIONS
IDENTIFICATION DATAWe recommend taking note of the identification
codes. The identification data are printed on labels in
the following positions fig. 176:
❒VIN plate.
❒Chassis marking.
❒Bodywork paint identification plate.
❒Engine marking.
VIN PLATE
This is applied on the rear part of the vehicle and
contains the following data fig. 177:BType-approval number
C
Vehicle type identification code
D
Chassis number
EMaximum authorised weight of vehicle fully ladenFMaximum permitted weight of vehicle fully laden
plus trailerG
Maximum permitted weight on first (front) axle
H
Maximum permitted weight on second (rear) axle
IEngine typeLBodywork version codeM
Number for spare parts
N
Correct value of smoke coefficient (for diesel
engines)
fig. 176
F0T0175
fig. 177
F0T0011
191KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCETECHNICAL
SPECIFICATIONSINDEX

CHASSIS MARKING
This is printed on the passenger compartment floor,
near the right front seat.
Slide the hatch A fig. 178 forward to access.
The marking includes:
❒type of vehicle;
❒chassis manufacture number.BODY PAINTWORK IDENTIFICATION
PLATE
This plate is applied inside the bonnet and shows the
following data fig. 179:
APaint manufacturer.
BColour name.
C
D
ENGINE MARKING
This is printed onto the cylinder block and shows the
type and production serial number.
fig. 178
F0T0084
fig. 179
F0T0012
192KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCETECHNICAL
SPECIFICATIONS
INDEX
Fiat colour code.
Respray and touch up code.

ENGINE CODES - BODYWORK
VERSIONSVersion Engine code
1.3 Multijet199A2000The following body version code and key are an
example that may be applied to all body version
codes.
Example:
225BXB1AAX
Key :225
Model
BBodyXB
Engine
1TractionA
Transmission
AX
VersionBODY
A
Qubo M1 (5 seat)
C
Qubo N1 (4 seats)
ENGINES
XA
1.4 petrol Euro 4
XB
1.3 Multijet 75 HP Euro 4
XC
Methane
XD
1.3 Multijet 75 HP Euro 5
XE
1.3 Multijet 95 HP Euro 5
XF
1.4 petrol Euro 5
DRIVE
1Front
TRANSMISSIONA
Mechanical gearbox
1Comfort/Dualogic gearbox
193KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCETECHNICAL
SPECIFICATIONSINDEX

ENGINEGeneral features 1.3 Multijet 75 HP
Type code 199A2000
Cycle Diesel
Number and arrangement of cylinders straight 4
Piston diameter and travel (mm) 69.6 x 82
Total displacement (cm3) 1248
Compression ratio 17.6
Max. power (EEC) (kW) 55
Max. power (EEC) (HP) 75
Corresponding engine speed (rpm) 4000
Max. torque (EEC) (Nm) 190
Max. torque (EEC) (kgm) 19.4
Corresponding engine speed (rpm) 1750
Spark plugs -
Fuel Diesel for motor vehicles (EN 590 specification)
194KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCETECHNICAL
SPECIFICATIONS
INDEX

CAPACITIES
1.3 Multijet 75 HP
Recommended fuels and original
lubricants
litres kg
Fuel tank: 45 -
Diesel for motor vehicles (EN590
specification)
including a reserve of: 6/7 -
Engine cooling system: 7.6 -50% mixture of distilled water and
PARAFLU
UP
(*)
Engine sump: 3.0 2.6
SELENIA WR P.E.
Engine sump and filter: 3.2 2.8
Gearbox/differential casing: 1.84 1.6TUTELA CAR TECHNYX
Hydraulic power steering 0.38 0.35TUTELA GI/E
Hydraulic brake circuit: - 0.5TUTELA TOP 4
Windscreen and rear window
washer fluid tank:3.0 -Water and liquid mixture
TUTELA PROFESSIONAL SC 35(*)When the vehicle is used in particularly harsh weather conditions, we recommend using a 60-40 mixture of PARAFLU
UP
and
distilled water.
206KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCETECHNICAL
SPECIFICATIONS
INDEX

FLUIDS AND LUBRICANTSRECOMMENDED PRODUCTS AND SPECIFICATIONSUseFluid and lubricant specifications for
correct operationGenuine fluids and
lubricantsChange interval
Diesel engine
lubricantsSAE 5W-30 grade synthetic base lubricants.
QualificationFIAT 9.55535-S1.SELENIA WR P.E.
Contractual Technical
Reference N. F510.D07According to
Scheduled Servicing
PlanFor diesel engines, in the event of an emergency in which the original products are not available, lubricants
with at least ACEA C2 performance are acceptable; however, in this case optimum engine performance is not
guaranteed and the lubricants should be replaced with recommended products as soon as possible at a Fiat
Dealership.
The use of products with features lower than ACEA C2 could cause engine damage not covered by warranty.
In particularly harsh climatic conditions, ask the Fiat Dealer Network for advice on the appropriate
PETRONAS LUBRICANTS product.
207KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCETECHNICAL
SPECIFICATIONSINDEX

UseFluid and lubricant specifications for
correct operationGenuine fluids and
lubricantsApplications
Protective agent
for radiatorsRed protective with antifreeze action, based on
inhibited monoethyl glycol with organic formula.
Exceeding CUNA NC 956-16, ASTM D 3306
specifications.
Qualification FIAT 9.55523.PARAFLU
UP
(*)
Contractual Technical
Reference N. F101.M01Mixture: 50% water
and 50%
PARAFLU
UP
(**)
Fuel additiveAntifreeze additive for diesel, with protective
action for diesel engines.TUTELA DIESEL
ART
Contractual Technical
Reference N. F601.L06To be mixed with
diesel 25 cc per 10
litres
Windscreen/rear
window washer
fluidMixture of alcohol, water and surfactants CUNA
NO 956-II
Qualification FIAT 9.55522.TUTELA
PROFESSIONAL SC
35
Contractual Technical
Reference N. F201.D02To be used diluted or
undiluted in
windscreen/rear
window washer/wiper
systems(*)IMPORTANT Do not use fluids with different specifications for topping up or mixing.
(**)In particularly harsh weather conditions, we recommend using a 60-40 mixture ofPARAFLU
UP
and distilled water.
209KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCETECHNICAL
SPECIFICATIONSINDEX