lock FIAT STRADA 2012 Owner handbook (in English)

25
The pretensioner does not require
any maintenance or lubrication.
Anything that modifies its original
conditions invalidates its efficiency.
If, due to unusual natural events
(floods, sea storms, etc.), the device
has been affected by water and mud,
it must be replaced.
To obtain the highest degree of
protection from the action of the
pretensioner, wear the seat belt
tight across the chest and pelvis.PRETENSIONERS
To make the protective action of the
seat belts even more effective, the
Fiat Strada is fitted with
pretensioners. These devices “feel”,
through a sensor, the occurrence of
a severe impact, retracting the belts
by a few centimetres. This
guarantees that the belt adheres
perfectly to the body of the
occupants, before the restraining
action begins. The reel locks to
indicate that the pretensioner has
intervened; the seat belt cannot be
drawn back up even when guided.
A small amount of smoke may be
emitted. This smoke is not harmful
and does not indicate a fire.The pretensioners
require neither internal
lubrication nor maintenance
interventions. The
pretensioners must not be
tampered with under any
circumstances. This could
compromise the operation of
the safety devices. Should
intervention be necessary,
contact a Fiat Dealership.
WARNING
007-044 STRADA LUM GB 1ed 9-01-2012 14:49 Pagina 25

33
TRIP button
Brief press:
– access TRIP COMPUTER
information.
Long press:
– reset TRIP COMPUTER.Standard display fig. 51
A – date
B – milometer (total/trip)
C – clock
D – outside temperature.
On some versions, when a door is
opened / closed with the key
removed, the display shows the total
milometer reading and the clock for
a few seconds.
F0X3002m
The display can also show the
following:
– through the flashing “spanner”
icon, when the vehicle must be
taken to a Fiat Dealership for
Scheduled Servicing;
– TRIP COMPUTER indications;
– brightness level adjustment for
some internal controls;
– FIAT MY CAR menu;
– warning messages in the event of
failures.
fig. 51
007-044 STRADA LUM GB 1ed 9-01-2012 14:49 Pagina 33

36
Dusk sensor sensitivity
(auto lamp)
This function, only available for
certain versions/markets, allows
dusk sensor sensitivity to be
adjusted to 3 levels:
level 1 – minimum sensitivity
level 2 – medium sensitivity
level 3 – maximum sensitivity
The greater the sensitivity, the lesser
the light intensity required to
automatically switch on the dipped
headlights, side lights and number
plate light.
To adjust, proceed as follows:
– press the MODE button briefly:
the display will show the level set
previously;
– press the ▼or ▲button to make
the desired adjustment;
– press the MODE button briefly to
confirm;
– hold down the MODE button to
return to the standard display.Trip B
This function, present only on some
versions/markets where provided,
allows the display of Trip B (partial
trip) to be activated (ON) or
deactivated (OFF). For further
information, see TRIP COMPUTER
in this section.
To activate or deactivate the
function, proceed as follows:
– press the MODE button briefly:
ON or OFF (depending on the
previous setting) flashes on the
display;
– press the ▼or ▲button to
select;
– press the MODE button briefly to
confirm;
– hold down the MODE button to
return to the standard display.Set Clock
(time adjustment)
To adjust the time, proceed as
follows:
– press the MODE button briefly:
the hours flash on the display;
– press the ▼or ▲button to
adjust;
– press the MODE button briefly:
the minutes flash on the display;
– press the ▼or ▲button to
adjust;
– press the MODE button briefly to
confirm;
– hold down the MODE button to
return to the standard display.
Every time the ▼or ▲buttons are
pressed, the value is
decreased/increased by 1 unit
respectively When the buttons are
held down, the value decreases or
increases rapidly, as appropriate. It is
advisable to release the button as
you approach the desired value, then
complete the adjustment with single
presses.
007-044 STRADA LUM GB 1ed 9-01-2012 14:49 Pagina 36

37
Clock Mode (12h or 24h)
To choose the time display format
(12h or 24h), proceed as follows:
– press the MODE button briefly:the mode set previously flashes on
the display;
– press the ▼or ▲button to select
12h or 24h;
– press the MODE button briefly to confirm;
– hold down the MODE button to return to the standard display.
Set Date
This function is used to set the date
(day – month – year). To set,
proceed as follows:
– press the MODE button briefly: the year flashes on the display;
– press the ▼or ▲button to
adjust; – press the MODE button briefly:
the month flashes on the display;
– press the ▼or ▲button to
adjust;
– press the MODE button briefly: the day flashes on the display;
– press the ▼or ▲button to
adjust;
– press the MODE button briefly to confirm;
– hold down the MODE button to return to the standard display.
Every time the ▼or ▲buttons are
pressed, the value is
decreased/increased by 1 unit
respectively When the buttons are
held down, the value decreases or
increases rapidly, as appropriate. It is
advisable to release the button as
you approach the desired value, then
complete the adjustment with single
presses. Audio Rpt.
(radio info repetition
for versions/markets,
where provided)
This function, present only on some
versions/markets where provided,
allows the frequency band or the
RDS messages from the current
station to be displayed.
To activate (ON) or deactivate
(OFF) radio info repetition, proceed
as follows:
– press the MODE button briefly:
ON or OFF (depending on the
previous setting) flashes on the
display;
– press the ▼or ▲button to
select;
– press the MODE button briefly to confirm;
– hold down the MODE button to return to the standard display.

007-044 STRADA LUM GB 2ed 4-04-2012 9:08 Pagina 37

38
Cons. (fuel consumption unit)
This function, present only on some
versions/markets where provided,
allows the unit of measurement used
to calculate fuel consumption to be
selected: km/l or l/100km.
Proceed as follows:
– press the MODE button briefly:
km/l or l/100km (depending on
the previous setting) flashes on
the display;
– press the ▼or ▲button to
select;
– press the MODE button briefly to
confirm;
– hold down the MODE button to
return to the standard display.
Door Lock
(with vehicle in motion
for versions/markets,
where provided)
This function, present only on some
versions/markets where provided,
allows automatic locking of doors
above a speed of 20 km/h to be
activated.
To activate (ON) or deactivate
(OFF) the function, proceed as
follows:
– press the MODE button briefly:
ON or OFF (depending on the
previous setting) flashes on the
display;
– press the ▼or ▲button to
select;
– press the MODE button briefly to
confirm;
– hold down the MODE button to
return to the standard display.
Dist. Unit (distance unit)
This function, present only on some
versions/markets where provided,
allows the unit of measurement used
to calculate distance to be selected:
km or mi.
Proceed as follows:
– press the MODE button briefly:
km or mi (depending on the
previous setting) flashes on the
display;
– press the ▼or ▲button to
select;
– press the MODE button briefly to
confirm;
– hold down the MODE button to
return to the standard display.

007-044 STRADA LUM GB 2ed 4-04-2012 9:08 Pagina 38
Autoclose -

ABS SYSTEM
FAILURE (amber)
When the key is turned to MAR, the
warning light switches on but should
switch off after a few seconds.
The warning light will switch on
when the system is either not
working or not available. In this case
the braking system maintains its own
efficiency unaltered, but without the
advantage of the ABS system.
Drive carefully and contact a Fiat
Dealership as soon as possible.
On some versions, the display shows
a dedicated message. BATTERY CHARGE
LOW (red)
The warning light switches
on when the ignition key is turned
to MAR, but it should switch off as
soon as the engine has started (with
the engine idling a brief delay before
switching off is acceptable).
If the warning light stays on, contact
a Fiat Dealership immediately.
On some versions, the display shows
a dedicated message.
w>x>
EBD FAILURE
(red - amber)
(for versions/
markets, where
provided)
If the
xand >warning lights
switch on simultaneously with the
engine running, this indicates that
there is a fault in the EBD system or
that the system in unavailable.
In this case, the rear wheels may
suddenly lock and the vehicle may
swerve when braking sharply. Drive
very carefully to a Fiat Dealership to
have the system inspected
immediately.
On some versions, the display shows
a dedicated message.
48
045-094 STRADA LUM GB 1ed 23-01-2012 9:10 Pagina 48

E-LOCKER SYSTEM
(Front differential
locking)
(for versions/markets,
where provided)
The warning light switches on (on
some versions together with a
dedicated message on the display) as
follows:
– flashing when the system is
activated;
– flashing more rapidly to indicate
that the speed of the vehicle is
approaching 20 km/h;
– constantly if there is a fault with
the system.RIGHT DIRECTION
INDICATOR
(green - intermittent)
The warning light switches on when
the direction indicator control stalk
is moved upwards or, together with
the left indicator, when the hazard
warning light button is pressed.
LEFT DIRECTION
INDICATOR
(green - intermittent)
The warning light switches on when
the direction indicator control stalk
is moved downwards or, together
with the right indicator, when the
hazard warning light button is
pressed.


ELD
SIDE LIGHTS (green) -
FOLLOW ME HOME
(green)
Side lights
The warning light switches on when
the side lights are activated.
Follow me home
(for versions/markets, where
provided)
This warning light switches on when
this device is activated (see Follow
Me Home in this section).
The display will show the dedicated
message.
FOG LIGHTS (green)
(for versions/markets,
where provided)
The warning light switches on when
the front fog lights are activated.REAR FOG LIGHTS
(amber)
(for versions/markets,
where provided)
The warning light switches on when
the rear fog lights are activated.
3
5
4
MAIN BEAM
HEADLIGHTS
The warning light switches on when
the main beams headlights are
activated.
1
54
045-094 STRADA LUM GB 1ed 23-01-2012 9:10 Pagina 54

fig. 68
F0X0044m
fig. 69
F0X0045m
fig. 70
F0X0046m
GLASSES HOLDER fig. 68
For some versions, there is a glasses
holder on the driver side door. To
open, operate in the direction of the
arrow as illustrated.
FRONT ROOF LIGHTS
With tilting lens fig. 69
The roof light is switched on using
the lens, as follows:
pressed to 1: off;
normal position: switches on when a
door is opened;
pressed to 2: always onWith switches
and spot light fig. 70
The roof light switches on in 2
different situations according to the
position of switch A:
1: always on (ON) even with doors
closed;
2: switches on when a door is
opened;
3: always off (OFF).
Spot light
Switch B controls the spot light,
depending on the position:
1: spot light on (ON);
2: spot light off (OFF).Roof light timing
On some versions, to facilitate
getting into/out of the vehicle,
especially at night or with poor
lighting, 2 different timing modes are
available.
Entrance timing
The roof lights switch on as follows:
– for a period of 15 seconds when
the front doors are unlocked;
– for a period of 3 minutes when
one of the doors is opened;
66
045-094 STRADA LUM GB 1ed 23-01-2012 9:10 Pagina 66

fig. 71
F0X0047m
fig. 72
F0X0048m
– for a period of 7 seconds when
one of the doors is closed
(within 3 minutes).
The timed period is interrupted if
the ignition is turned to MAR.
Exit timing
After removing the key from the
ignition switch, the roof lights switch
on as follows:
– for a period of 3 minutes within 2
minutes of the engine stopping;
– for a period of 3 minutes when
one of the doors is opened;
– for a period of 7 seconds when
one of the doors is closed (within
3 minutes).
Timing will stop automatically when
the doors are locked.REAR ROOF LIGHT fig. 71
(for versions/markets,
where provided)
The rear roof light is switched on
using the lens, as follows:
pressed to 1: off;
normal position: switches on when a
door is opened;
pressed to 2: always on.POWER SOCKET fig.72
This is present only on certain
versions and operates when the
ignition key is turned to MAR.
To use, lift cap A.
It can be used with devices /
accessories with a maximum power
of 180 W.
Before connecting any
electrical accessories,
contact a Fiat Dealership to
check whether this is possible.
WARNING
67
045-094 STRADA LUM GB 1ed 23-01-2012 9:10 Pagina 67

DOORS
Before opening a door,
ensure that you can do
so in safe conditions.
WARNING
FROM OUTSIDE
Opening: turn the key to position 1-
fig. 75 and pull the opening handle.
Closing: turn the key to position 2.
fig. 75
F0X0051m
fig. 76
F0X0052m
FROM INSIDE
Opening: pull opening lever A-fig. 76.
Closing: close the door and press
the lever.
CENTRAL LOCKING
From outside
With the doors closed, insert and
turn the key in a door lock.From inside
With doors closed, press (to lock)
or pull (to unlock) one of the door
opening levers.
The remote control can also be used
to activate central locking.
IMPORTANT If one of the doors is
not fully closed or there is a system
failure, central locking will not
operate and, after several attempts,
the system will be excluded for
about 30 seconds.
The doors can be locked or
unlocked during this period, without
the intervention of the electronic
system. After the 30 seconds have
elapsed, the control unit is ready to
receive commands again.
If the cause of operational failure has
been removed, the device will
resume normal operation.
Otherwise, the exclusion cycle will
be repeated.
69
045-094 STRADA LUM GB 1ed 23-01-2012 9:10 Pagina 69