reset sun roof FIAT TEMPRA 1988 Service And Repair Manual

Job 15. Sun roof - removal and
refitting.
PART A: GENERAL
E3 INSIDE INFORMATION! If an electric sunroof fails to
work, it can be operated manually with the aid of a key
positioned behind the cover panel in the roof light
assembly. By engaging the key in the exposed drive pin,
you can turn it and adjust the roof position. Q
• Step A1: SPECIAL NOTE. Here we cover the
replacement of the electric motor (where fitted) and the
glass roof panel. We strongly recommend that any
further work, which could involve the removal of the
headlining, should be entrusted to your FIAT agent or
body specialist.
PART B: TO REMOVE THE MOTOR:
• Step B1: Close the sunroof fully and then disconnect the
battery earth lead.
Q Step B2: Carefully lever out the panel cover and remove
the roof light lens.
Q Step B3: Undo the screws and lower the panel...
G Step B4: ...then unplug the two connectors from the
other side of the panel.
O Step B5: Unplug the connector from the motor cable,
once exposed...
• Step B8: Refit by reassembling in reverse order.
PART C: TO REMOVE THE GLASS PANEL:
• Step C1: Position the glass in the fully tilted mode and
remove the mouldings (arrowed) by sliding them rearwards.
• Step C2: Undo the
mounting bolts (two
per side) found behind
the mouldings...
• Step C3: and
raise the glass to
remove it from the
frame.
• Step C4: Refit in
the reverse order.
Job 16. Front seats - removal and
refitting.
PART A: SEATS WITHOUT PRETENSIONERS
• Step A1:
Undo the screws
(arrowed) and
remove the seat
mounting cover
from both sides.
• Step A2:
Undo the four
bolts
-
two per
side of each seat
-

fixing the runners
to the floor and
remove the seat.
PART B: SEATS WITH SEAT BELT PRETENSIONERS -
REMOVAL
IMPORTANT NOTES: i) In a collision, the pretensioners
are activated whether the belt is buckled or not. They
cannot be reset and must be replaced! If the seat belt
was buckled, it too, must be replaced,
ii) Read Safety First! Steps B2 and B3.
he motor.
SAFETY FIRST!
• Handle pretensioners with extreme care
-
don't drop.
• Never cause impact to the tensioning device
-
which
could set off the pre-loaded spring.
• The components must be fitted with care to avoid
knocking or jarring.
• Detach the pretensioner if working on the seat.
• Always insert the blue safety clip before removing or
refitting the seat
• Never attempt to service or dismantle the unit
• Never grasp the buckle or the power unit
• Step B6:
...then undo the
mounting screws
(arrowed).
D INSIDE
INFORMATION:
The relay is
found here
(a).H
• Step B7: You
can now withdraw