key FORD AEROSTAR 1997 1.G User Guide

74
*
[CF01340(ALL)01/96]
Clock Controls on Electronic
Radios
[CF01345(ALL)04/96]
The electronic radios have a built-in clock. For
complete operating instructions, refer to the
Electronic Sound Systemschapter in this Owner
Guide.
*
[CF02100(ALL)01/96]
Ignition
%*
[CF02110(ALL)01/96]
Understanding the Positions of the Ignition
*
[CF02120(ALL)01/96]
quarter page art:0020004-B
The positions of the key in the ignition lock cylinder.
%*
[CF02130(ALL)04/96]
ACCESSORY allows some of your vehicle's
electrical accessories such as the radio and the
windshield wipers to operate while the engine is
not running.
*
[CF02135(ALL)01/96]
LOCK locks the steering wheel and gearshift
lever.
*
[CF02140(ALL)01/96]
LOCK is the only position that allows you to
remove the key. The LOCK feature helps to
protect your vehicle from theft.
*
[CF02150(ALL)01/96]
If your key is stuck in the LOCK position and
will not turn, move your steering wheel left or
right until the key turns freely.
*
[CF02160(ALL)01/96]
OFF allows you to shut off the engine and all
accessories without locking the steering wheel or
the automatic transmission gearshift lever.
*
[CF02170(ALL)01/96]
ON allows you to test your vehicle's warning
lights (except the brake system warning light) to
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

75
make sure they work before you start the
engine. The key returns to the ON position once
the engine is started and remains in this position
while the engine runs.
*
[CF02180(ALL)01/96]
START cranks the engine. Release the key once
the engine starts so that you do not damage the
starter. The key should return to ON when you
release it. The START position also allows you
to test the brake warning light.
%
*
[CF02500(ALL)02/96]
The Turn Signal Lever
*
[CF02510(ALL)02/96]
You can use the turn signal lever on the left side
of the steering column to:
*
[CF02520(ALL)02/96]
q
operate the turn signals and cornering lamps
*
[CF02530(ALL)03/96]
q
turn the high beams on/off
*
[CF02540(ALL)03/96]
q
flash the lamps
*
[CF02550(ALL)03/96]
q
turn the windshield wipers and washer
on/off
%*
[CF02560(ALL)01/96]
Turn Signals
[CF02570(ALL)01/96]
one third page art:0095013-A
Turn signal operation
*
[CF02580(ALL)08/95]
If the turn indicator light in the instrument
panel does not illuminate or remains on (doesn't
flash) when you signal a turn, the turn signaling
system is malfunctioning. Have this condition
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

76corrected as soon as possible, but make sure that
you use the accepted hand signals in the
meantime.
*
[CF03200(ALL)08/95]
High Beams and Flashing the Lamps
[CF03800(ALL)01/96]
one third page art:0095014-A
Headlamp high beam and flash-to-pass operation
%*
[CF04400(ALL)01/96]
Windshield Wipers and Washer
*
[CF04500(ALL)04/96]
To turn on the windshield wipers, the ignition
key must be turned to the ON or ACC position.
[CF04950(ALL)01/96]
one third page art:0095015-A
Interval wiper on turn signal lever Ð wiper and washer
operation
*
[CF05000(ALL)08/95]
To set the interval wipers, rotate the knob at the
end of the turn signal lever toward or away
from the instrument panel to the interval
operation you desire.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

85 %
*
[CF21409(ALL)04/96]
Anti-theft front door lock knobs
*
[CF21901(ALL)01/96]
Anti-theft lock knobs are designed to preclude
unlocking the door by pulling up on the bullet
type lock knob. To unlock and open the front
door from the inside of the vehicle, pull on the
inside door handle.
*
[CF23801(ALL)01/96]
Sliding Door
[CF23901(ALL)01/96]
With the door unlocked, unlatch the sliding door
by pulling the inside handle to the rear, or by
pulling the outside handle out and rearward. To
close, push the inside handle forward or pull the
outside handle forward.
[CF24101(ALL)01/96]
quarter page art:0020188-B
Sliding door handles
% [CF24300(ALL)04/96]
Liftgate
*
[CF24301(ALL)01/96]
Liftgate opening procedure
[CF24401(ALL)01/96]
1. Insert the key into the lock and turn it
counterclockwise. You can also unlock the
latch (but not release it) with the power door
lock system (if equipped).
*
[CF24500(ALL)01/96]
2. Reach under the license plate light shield
and release the liftgate latch by squeezing
the paddle handle rearward.
[CF24600(ALL)01/96]
3. To make the gate swing up to the fully
opened position, pull back and upward on
the latch paddle handle.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

87 [CF25800(ALL)01/96]
3. You can lock the liftgate latch by pushing
down the lock button before you pull down
and close the liftgate. You can also lock the
liftgate latch by inserting your vehicle's door
key and turning it clockwise after you have
closed the liftgate, or by using the power
door locks (if equipped).
*
[CF25900(ALL)01/96]
The liftgate area is only intended for cargo, not
passengers. You can open and close the liftgate
from outside the vehicle. It cannot be opened
from inside the cargo area.
[CF28800(ALL)01/96]
Dual Rear Cargo Door (If equipped)
[CF29300(ALL)01/96]
quarter page art:0020200-A
Opening the right rear door
[CF29400(ALL)01/96]
To open the left rear door, open the right rear
door and then pull up on the tee-shaped handle
located on the inside of the left rear door.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

99 [SS00165(ALL)01/96]
E-Z Access Operation Ð Passenger Side
Rear Captain's Chair (Optional Quad
Buckets)
[SS00170(ALL)01/96]
To provide easy access to the rear of the vehicle,
the passenger side rear captain's chair can be
tilted forward.
*
[SS00175(ALL)01/96]
To tilt seat forward:
*
[SS00180(ALL)01/96]
1. Put the seatback in the upright position.
[SS00185(ALL)01/96]
2. Lift upward on the lower handle on the
right (outboard) side of the seat.
*
[SS00190(ALL)01/96]
3. The seat can now be tilted forward.
*
[SS00195(ALL)01/96]
To latch the seat in its normal position, push
seatback rearward until it is latched in position.
% [SS00200(ALL)04/96]
Quick Release Rear Captain Chairs
[SS00205(ALL)04/96]
To remove:
[SS00210(ALL)01/96]
1. For right hand seats, lift and rotate the seat
latch handle (located under the seat)
rearward, causing the J hook to disengage
from the front floor well retainer.
[SS00215(ALL)01/96]
For left hand seats, lift and rotate the seat
latch handle (located under the seat)
rearward, causing the J hook to disengage
from the front floor well retainer. Disengage
the lap/shoulder safety belt from the seat by
inserting a key or similar device into the slot
in the detachable anchor and lifting upward.
Stow the tongue end of the detachable
anchor as shown.
[SS00220(ALL)01/96]
2. Push the seat assembly rearward to
disengage the front and rear floor hooks and
lift the seat assembly from the vehicle.
File:06cpssa.ex
Update:Thu Jun 13 08:56:07 1996

101
*
[SS00265(ALL)01/96]
To remove seat assembly:
[SS00270(ALL)04/96]
1. Disengage the lap/shoulder safety belt from
the seat by inserting a key or screwdriver
into the slot in the detachable anchor and
lifting upward. Stow the tongue end of the
detachable anchor as shown in the
illustration.
[SS00275(ALL)01/96]
three fourths page art:0095047-A
Location of the detachable anchor warning label on safety
belt
File:06cpssa.ex
Update:Thu Jun 13 08:56:07 1996

113
*
[SS04340(ALL)02/96]
3. A clicking sound will continue to be heard
as the belt is allowed to retract. This
indicates that the retractor is in the
automatic locking mode.
*
[SS04350(ALL)02/96]
NOTE: When the combination lap/shoulder
belt is unbuckled and allowed to
retract completely, the retractor will
switch to the vehicle sensitive
(emergency) locking mode. See the
detailed instructions underSafety Seats
for Childrenin this chapter.
[SS04375(ALL)01/96]
Two Passenger Bench or Bedseat
(If Equipped)
[SS04400(ALL)04/96]
In addition to anchorages in the floor and roof
structures, some rear safety belts have a
detachable anchor mounted to the outboard side
of the rear seats. This should remain attached,
except when removing the rear seats.
[SS04800(ALL)01/96]
Disengaging rear seat safety belts for seat
removal
[SS04850(ALL)01/96]
In order to remove the rear seat, the safety belt
must be disengaged from the seat. To disengage
the safety belt from the seat, insert a key or
small screwdriver into the slot provided on the
detachable anchor. Then lift upward.
File:06cpssa.ex
Update:Thu Jun 13 08:56:07 1996

127
*
[SS12700(ALL)05/96]
q
and the electrical wiring which connects the
components.
*
[SS12800(ALL)05/96]
The diagnostic module monitors its own internal
circuits and the supplemental air bag electrical
system readiness (including the impact sensors),
the system wiring, the air bag system readiness
light, the air bag backup power and the air bag
igniters.
*
[SS12900(ALL)05/96]
Determining if System Is Operational
*
[SS13000(ALL)05/96]
The Air Bag Supplemental Restraint System uses
a readiness light and a tone to indicate the
condition of the system. The readiness light is in
the instrument cluster. When you turn the
ignition key to ON, this light will illuminate for
approximately six (6) seconds and then turn off.
This indicates that the system is operating
normally. NOTE: Routine maintenance of the air
bag system is not required.
%*
[SS13100(ALL)05/96]
A problem with the system is indicated by one
or more of the following:
*
[SS13200(ALL)05/96]
q
the readiness light will either flash or stay lit,
*
[SS13300(ALL)05/96]
q
the readiness light will not light immediately
after ignition is turned on,
%*
[SS13400(ALL)05/96]
q
a group of five beeps will be heard. The tone
pattern will repeat periodically until the
problem and light are repaired.
*
[SS13500(ALL)05/96]
If any of these things happen, even
intermittently, have the Air Bag Supplemental
Restraint System serviced at your Ford or
Lincoln-Mercury dealer immediately. Unless
serviced, the system may not function properly
in the event of a collision.
File:06cpssa.ex
Update:Thu Jun 13 08:56:07 1996

153
Starting
%*
[TO04800(ALL)01/96]
Fuel-Injected Engines
*
[TO04900(ALL)01/96]
When starting a fuel-injected engine,the most
important thing to remember is to avoid
pressing down on the accelerator before or
during starting. Only use the accelerator when
you have problems getting your vehicle started.
SeeStarting Your Enginein this chapter for
details about when to use the accelerator while
you start your vehicle.
*
[TO05150(ALL)01/96]
Starting Your Vehicle
%*
[TO05200(ALL)01/96]
Preparing to Start Your Vehicle
*
[TO05300(ALL)02/96]
RWARNING
Do not start your vehicle in a closed
garage or in other enclosed areas. Exhaust
fumes can be toxic. Always open the
garage door before you start the engine.
*
[TO05400(ALL)01/96]
Before you start your vehicle, do the following:
*
[TO05500(ALL)01/96]
1. Make sure all occupants in the vehicle
buckle their safety belts. SeeSafety Restraints
in the Index for more details.
*
[TO05600(ALL)01/96]
2. Make sure the headlamps and other
accessories are turned off when starting.
*
[TO05750(ALL)01/96]
3. Make sure that the gearshift is in P (Park)
and the parking brake is set before you turn
the key.
*
[TO06015(ALL)02/96]
Before you start your vehicle, you should test
the warning lights on the instrument panel to
make sure that they work. Refer to the
Instrumentationchapter.
File:08cptoa.ex
Update:Thu Jun 6 14:43:40 1996