ECO mode FORD ASPIRE 1996 1.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 1996, Model line: ASPIRE, Model: FORD ASPIRE 1996 1.GPages: 268, PDF Size: 2.2 MB
Page 18 of 268
16
*
[SR09470(ALL)07/95]
NOTE: When the combination lap/shoulder
belt is unbuckled and allowed to
retract completely, the retractor will
switch to the vehicle sensitive
(emergency) locking mode. See the
detailed instructions underSafety Seats
for Childrenin this chapter.
%*
[SR09475(ALL)07/95]
Safety Belt Extension Assembly
*
[SR09478(ALL)07/95]
For some people, the safety belt may be too
short even when it is fully extended. You can
add about eight inches (20 cm) to the belt length
with a safety belt extension assembly (part
number 611C22). Safety belt extensions are
available at no cost from your dealer.
*
[SR09482(ALL)07/95]
RWARNING
Failure to follow these instructions will
affect the performance of the safety belts
and increase the risk of personal injury.
*
[SR09484(ALL)07/95]
Safety Belt Maintenance
*
[SR09486(ALL)07/95]
Check the safety belt systems periodically to
make sure that they work properly and are not
damaged.
%*
[SR09488(ALL)07/95]
All safety belt assemblies, including retractors,
buckles, front seat belt buckle support assemblies
(slide bar) (if equipped), child safety seat tether
bracket assemblies (if equipped), and attaching
hardware, should be inspected after any
collision. Ford recommends that all safety belt
assemblies used in vehicles involved in a
collision be replaced. However, if the collision
was minor and a qualified technician finds that
the belts do not show damage and continue to
operate properly, they do not need to be
replaced. Safety belt assemblies not in use
during a collision should also be inspected and
replaced if either damage or improper operation
is noted.
File:03icsrf.ex
Update:Wed Jan 24 14:30:01 1996
Page 19 of 268
17 %
*
[SR09500(ALL)06/95]
Cleaning the Safety Belts
*
[SR09525(ALL)06/95]
Clean the safety belts with any mild soap
solution that is recommended for cleaning
upholstery or carpets. Do not bleach or dye the
belt webbing because this may weaken it.
*
[SR11700(ALL)06/95]
Air Bag Supplemental Restraint
System (SRS)
*
[SR11960(ALL)05/95]
The driver and right front passenger air bags are
Supplemental Restraint Systems (SRS), provided
at these seating positions in addition to the
lap/shoulder belt, and are designed to
supplement the protection provided to properly
belted occupants in moderate to severe frontal
collisions. The supplemental air bag system does
not provide restraint to the lower body.
*
[SR12000(ALL)05/95]
The Importance of Wearing Safety Belts
*
[SR12100(ALL)06/95]
RWARNING
Safety belts must be worn by all vehicle
occupants to be properly restrained and
help reduce the risk of injury in a
collision.
*
[SR12150(ALL)05/95]
RWARNING
All occupants of the vehicle, including the
driver, should always wear their safety
belts, even when an air bag Supplemental
Restraint System is provided.
File:03icsrf.ex
Update:Wed Jan 24 14:30:01 1996
Page 112 of 268
111
*
[AS23150(ALL)02/95]
q
Using the ªSCANº function (Stereo Cassette
Radio)
*
[AS23175(ALL)06/95]
Press the ªSCANº button to enter the scan
mode. The radio will begin scanning up the
frequency band, stopping on each listenable
station for approximately a five-second
sampling. This continues until you press the
ªSCANº button a second time.
*
[AS23200(ALL)04/95]
q
Setting the Station Memory Preset buttons
*
[AS23300(ALL)05/95]
Your radio is equipped with 5 station
memory buttons. These buttons can be used
to select up to 5 preset AM stations and 10
preset FM stations (5 in FM1 and 5 in FM2).
*
[AS23400(ALL)06/95]
Follow the easy steps below to set these buttons
to the desired frequencies:
*
[AS23500(ALL)07/95]
1. Select a band, then select a frequency.
*
[AS23700(ALL)06/95]
2. Press one of the memory preset buttons and
hold the button until the sound returns. That
station is now held in memory on that
button.
*
[AS23800(ALL)06/95]
3. Follow the two steps above for each station
memory preset button you want to set.
*
[AS23900(ALL)04/95]
NOTE: If the vehicle's battery is disconnected,
the clock and station memory preset
buttons (if programmed in auto mode)
will need to be reset.
File:09icasf.ex
Update:Wed Jan 24 14:52:32 1996
Page 116 of 268
115
*
[AS27900(ALL)02/95]
q
Protect cassettes from exposure to direct
sunlight, high humidity and extreme heat or
cold. If they are exposed to extreme
conditions, allow them to reach a moderate
temperature before playing.
*
[AS28001(ALL)02/95]
q
If a tape is loose inside the cassette, tighten it
before playing by putting your finger or a
pencil into one of the holes and turning the
hub until the tape is tight.
*
[AS28101(ALL)02/95]
q
Loose labels on cassette tapes can become
lodged in the mechanism. Remove any loose
label material before inserting a cassette.
*
[AS28200(ALL)03/95]
q
Do not leave a tape in the cassette tape
player when not in use. High heat in the
vehicle can cause the cassette to warp.
%*
[AS28400(ALL)03/95]
Clock Operation
*
[AS28500(ALL)07/90]
How to view the clock mode
*
[AS28600(ALL)06/95]
Press the ªCLOCKº button to alternate the
frequency and time in the display. In the clock
mode, pressing any radio function will
automatically display the radio frequency for
approximately ten seconds before changing back
to the clock mode.
*
[AS28800(ALL)07/90]
How to set the clock
*
[AS28900(ALL)06/95]
1. Turn the radio on.
*
[AS29050(ALL)06/95]
2. Press and hold in the ªCLOCKº button,
press the ªSEEKº button left (
b) to advance
the hours and right (
a) to advance the
minutes.
*
[AS29200(ALL)07/90]
NOTE: The clock displays 12-hour time with
no AM/PM indications.
File:09icasf.ex
Update:Wed Jan 24 14:52:32 1996
Page 120 of 268
119
Driving Your Aspire
*
[DR00400(ALL)09/93]
Procedures for driving your vehicle will vary
depending on which type oftransaxleyour
vehicle has. You may be familiar with the term
ªtransmission.º We usetransaxlebecause it is a
more accurate term for vehicles that have
front-wheel drive.
[DR01100(ALL)02/95]
Your Aspire has one of two types of transaxles:
[DR01300(ALL)01/92]
q
a manual five-speed
[DR01400(ALL)02/89]
q
an automatic three-speed
[DR01700(ALL)02/95]
Driving With an Automatic
Transaxle (If equipped)
*
[DR01800(ALL)01/95]
Putting Your Vehicle in Gear
[DR02100(ALL)02/91]
The automatic transaxle provides fully automatic
operation in D (Drive). For manual control, start
in 1 (First) or 2 (Second) and then shift
manually.
*
[DR02150(ALL)04/95]
Your vehicle is equipped with an Electronic
Powertrain Control Module that limits engine
and/or vehicle speeds with a cut-out mode to
promote durability.
File:10icdrf.ex
Update:Wed Jan 24 14:53:01 1996
Page 128 of 268
127 [DR10075(ALL)05/95]
When the engine is not running or has stalled,
the power assist is interrupted. The reserve
brake power is partially depleted each time the
brake pedal is applied and released. Do not
pump the brake pedal when the power assist
has been interrupted, unless it is necessary to
maintain steering control on slippery surfaces.
*
[DR10100(ALL)05/95]
Apply the brake pedal gradually. Use the
ªsqueezeº technique Ð push on the brake pedal
with a steadily increasing force. This allows the
wheels to continue to roll while you are slowing
down, which lets you steer properly.
[DR10200(ALL)05/95]
Extreme braking can make the wheels lock and
slide, causing you to lose control of the steering.
If you lock the wheels, release the brake pedal
and repeat the ªsqueezeº technique.
*
[DR10300(ALL)05/95]
Do not drive with your foot resting on the brake
pedal; you will wear out the linings and increase
your vehicle's stopping distance. Brake rotor
damage may also eventually occur.
*
[DR10400(ALL)05/95]
NOTE: If you are driving down a long or
steep hill, shift to a lower gear and do
not apply your brakes continuously. If
you apply your brakes continuously,
they may overheat and become less
effective.
*
[DR10500(ALL)07/95]
Occasional brake squeal during light to moderate
stops does not affect the function of the brake
system and is normal. However, if the squeal
becomes louder or more frequent, have your
brakes inspected by your dealer or a qualified
service technician.
File:10icdrf.ex
Update:Wed Jan 24 14:53:01 1996
Page 184 of 268
185
beverage. In sensitive individuals, serious
personal injury or sickness could result. Consult
a physician promptly if you experience an
adverse reaction.
%*
[SV11300(ALL)05/95]
Running Out of Fuel
*
[SV11310(ALL)07/95]
NOTE: Avoid running out of fuel because this
situation may have an adverse effect on
modern powertrain components.
*
[SV11320(ALL)07/95]
You may need to crank the engine several times
before the fuel system starts to pump fuel from
the tank to the engine.
%*
[SV11600(ALL)05/95]
Fuel Economy
*
[SV11700(ALL)06/95]
Fuel economy is an estimate of the efficiency of
your vehicle and can be calculated as Miles Per
Gallon (MPG) or Liters Per 100 Kilometers
(L/100K).
*
[SV11800(ALL)05/95]
To calculate fuel economy:
*
[SV11900(ALL)06/95]
1. Fill the tank completely and record the
initial odometer reading.
*
[SV12000(ALL)06/95]
2. Every time you buy fuel record the
amount (in gallons or liters) purchased.
*
[SV12150(ALL)07/95]
3. After at least three to five tankfuls, fill the
fuel tank and record the final odometer
reading.
[SV12200(ALL)07/95]
4. Divide the total number of miles that you
have driven by the total number of gallons
that your vehicle has used. In metric,
multiply the number of liters used by 100
and divide the answer by the number of
kilometers traveled. This will give you the
number of liters used per 100 km.
File:15icsvf.ex
Update:Wed Jan 24 14:56:41 1996
Page 232 of 268
233
*
[SV48930(ALL)07/95]
OBD II Drive Cycle
[SV48932(ALL)07/95]
The following steps must be run in the order
shown. If any steps are interrupted, repeat the
preceding step. Any safe driving mode is
acceptable between steps.
[SV48934(ALL)07/95]
Always drive vehicle in safe manner according
to traffic conditions and obey all traffic laws.
*
[SV48940(ALL)07/95]
The engine must be warmed up and at
operating temperature before proceeding with
the drive modes of the following OBD II Drive
Cycle.
*
[SV48950(ALL)07/95]
1. Start the engine. Drive or idle in N (neutral)
the vehicle for 4 minutes.
[SV48960(ALL)07/95]
2. Idle the vehicle in D (drive) or N (neutral)
for manual transaxle for 40 seconds.
*
[SV48970(ALL)07/95]
3. Accelerate the vehicle to 45 mph (70 km/h)
at 1/4 to 1/2 throttle for 10 seconds.
*
[SV48980(ALL)07/95]
4. Drive the vehicle with a steady throttle at
45 mph (70 km/h) for 30 seconds.
*
[SV48990(ALL)07/95]
5. Idle the vehicle in Drive (Neutral for manual
transmissions) for 40 seconds.
*
[SV49000(ALL)07/95]
6. Continue to drive the vehicle in city traffic at
speeds between 25 and 40 mph
(40-60 km/h) for 15 minutes. During the 15
minute drive cycle the following modes must
be achieved:
*
[SV49010(ALL)07/95]
a. at least 5 stop and idle modes at 10
seconds each
*
[SV49020(ALL)07/95]
b. acceleration from idles at 1/4 to 1/2
throttle position, and
*
[SV49030(ALL)07/95]
c. choose 3 different speeds to do 1.5
minute steady state throttle drives.
File:15icsvf.ex
Update:Wed Jan 24 14:56:41 1996