lock FORD ASPIRE 1996 1.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 1996, Model line: ASPIRE, Model: FORD ASPIRE 1996 1.GPages: 268, PDF Size: 2.2 MB
Page 8 of 268
5
%*
[IN05100(ALL)06/95]
Your Vehicle Identification
Number (VIN)
[IN05150(ALL)05/95]
one inch art:0030500-A
Vehicle Identification Number (VIN/Serial Number)
*
[IN05200(ALL)06/95]
Your Vehicle Identification Number (VIN) is the
same as the warranty number that appears on
your owner card. You should include this
number any time you write to Ford Motor
Company about your vehicle.
*
[IN05300(ALL)06/95]
The Vehicle Identification Number is attached to
your vehicle in the following places:
[IN05400(ALL)06/95]
q
on the metal tag attached to the top of the
cowl top panel on the driver's side Ð you
can see the tag by looking through the
windshield from outside your vehicle. It is
recessed in the top of the instrument panel.
[IN05550(ALL)12/93]
q
on the Safety Compliance Certification label
Ð this label is attached to the left door lock
pillar. It is required by the National Highway
Traffic Safety Administration and is made of
special material. If someone tampers with it,
it will be destroyed or a series of diagonal
lines will appear.
File:02icinf.ex
Update:Wed Jan 24 14:28:18 1996
Page 14 of 268
12
*
[SR02200(ALL)06/95]
RWARNING
Never wear the shoulder belt under the
arm. Never swing it around the neck over
the inside shoulder. Never use a single
belt for more than one person or across
more than one seating position. Each
seating position in your vehicle has a
specific safety belt assembly which is
made up of one buckle and one tongue
that are designed to be used as a pair.
Failure to follow these precautions could
increase the risk and/or severity of injury
in a collision.
[SR02400(ALL)07/95]
RWARNING
Never drive or ride with a twisted or
jammed safety belt. If you cannot untwist
or unjam the safety belt, see the nearest
qualified technician immediately.
*
[SR02800(ALL)07/95]
RWARNING
To reduce the risk of serious injury in a
collision, children should always ride with
the seatback upright.
*
[SR02825(ALL)07/95]
RWARNING
Never let a passenger hold a child on his
or her lap while the vehicle is moving.
The passenger cannot protect the child
from injury in a collision.
*
[SR02850(ALL)05/95]
Lock the doors of your vehicle before driving to
lessen the risk of the door coming open in a
collision.
File:03icsrf.ex
Update:Wed Jan 24 14:30:01 1996
Page 15 of 268
13
*
[SR03400(ALL)05/95]
Combination Lap and Shoulder
Belts
*
[SR03500(ALL)06/95]
While your vehicle is in motion, the combination
lap and shoulder belt adjusts to your movement.
However, if you brake hard, turn hard, or if
your vehicle receives an impact of 5 mph
(8 km/h) or more, the lap/shoulder belt locks
and helps reduce your forward movement.
*
[SR03600(ALL)05/95]
After you get into your vehicle, close the door
and lock it. Then adjust the seat to the position
that suits you best.
[SR03700(ALL)07/95]
To fasten the belt, pull the combination
lap/shoulder belt from the retractor so that the
shoulder portion of the belt crosses your
shoulder and chest. Be sure the belt is not
twisted. If it is, remove the twist. Insert the belt
tongue into the proper buckle until you hear a
snap and feel it latch. Make sure the tongue is
securely fastened to the buckle by pulling on
tongue.
[SR03800(ALL)05/93]
one third page art:0032150-A
Fastening the safety belt
*
[SR03850(ALL)06/95]
Adjust the lap part of the belt by pulling up on
the shoulder belt until the lap belt fits snugly
and as low as possible around your hips.
File:03icsrf.ex
Update:Wed Jan 24 14:30:01 1996
Page 16 of 268
14
*
[SR03860(ALL)06/95]
NOTE: Be sure to read and understand
Important Safety Belt Informationat
the beginning of this chapter.
[SR05300(ALL)07/95]
one third page art:0032252-B
Unfastening the combination lap/shoulder belts Ð front
and rear outboard seating positions
*
[SR05400(ALL)05/95]
While the belt retracts, guide the tongue to its
original position to prevent it from striking you
or the vehicle.
[SR09320(ALL)05/95]
Passenger Seat Lap/Shoulder Belt
Retractors (Dual Locking Modes)
*
[SR09330(ALL)06/95]
Your vehicle is equipped with a dual locking
mode retractor on the shoulder belt portion of
the combination lap/shoulder safety belt for all
passengers.
[SR09340(ALL)05/95]
Dual locking mode retractors operate in two
ways:
*
[SR09350(ALL)06/95]
Vehicle sensitive (emergency) locking mode
[SR09360(ALL)05/95]
In this operating mode, the shoulder belt
retractor will allow the occupant freedom of
movement, locking tight only on hard braking,
hard cornering, or impacts of approximately
5 mph (8 km/h) or more. The retractor can also
be made to lock by pulling on the belt.
File:03icsrf.ex
Update:Wed Jan 24 14:30:01 1996
Page 17 of 268
15
*
[SR09370(ALL)05/95]
Automatic locking mode
*
[SR09380(ALL)07/95]
In this operating mode, the shoulder belt
retractor will be automatically locked and will
remain locked when the combination
lap/shoulder safety belt is buckled, and does not
allow the occupant freedom of movement. This
mode provides the following:
*
[SR09390(ALL)07/95]
q
A tight lap/shoulder belt on the occupant.
*
[SR09400(ALL)07/95]
q
Child safety seat installation.
*
[SR09410(ALL)07/95]
RWARNING
Rear-facing infant seats should never be
placed in the front seats.
*
[SR09420(ALL)07/95]
This modemust be usedwhen installing a child
safety seat on the front passenger seat and rear
outboard seats where dual locking retractors are
provided.
*
[SR09430(ALL)07/95]
To switch the retractor from the emergency
locking mode to the automatic locking mode,
perform the following steps:
*
[SR09440(ALL)07/95]
1. Buckle the lap/shoulder combination belt.
*
[SR09450(ALL)07/95]
2. Grasp the shoulder portion of the belt and
pull downward until all of the belt is
extracted, and when allowed to retract, a
clicking sound will be heard. At this time,
the belt retractor is in the automatic locking
mode (child restraint mode).
*
[SR09460(ALL)07/95]
3. A clicking sound will continue to be heard
as the belt is allowed to retract. This
indicates that the retractor is in the
automatic locking mode.
File:03icsrf.ex
Update:Wed Jan 24 14:30:01 1996
Page 18 of 268
16
*
[SR09470(ALL)07/95]
NOTE: When the combination lap/shoulder
belt is unbuckled and allowed to
retract completely, the retractor will
switch to the vehicle sensitive
(emergency) locking mode. See the
detailed instructions underSafety Seats
for Childrenin this chapter.
%*
[SR09475(ALL)07/95]
Safety Belt Extension Assembly
*
[SR09478(ALL)07/95]
For some people, the safety belt may be too
short even when it is fully extended. You can
add about eight inches (20 cm) to the belt length
with a safety belt extension assembly (part
number 611C22). Safety belt extensions are
available at no cost from your dealer.
*
[SR09482(ALL)07/95]
RWARNING
Failure to follow these instructions will
affect the performance of the safety belts
and increase the risk of personal injury.
*
[SR09484(ALL)07/95]
Safety Belt Maintenance
*
[SR09486(ALL)07/95]
Check the safety belt systems periodically to
make sure that they work properly and are not
damaged.
%*
[SR09488(ALL)07/95]
All safety belt assemblies, including retractors,
buckles, front seat belt buckle support assemblies
(slide bar) (if equipped), child safety seat tether
bracket assemblies (if equipped), and attaching
hardware, should be inspected after any
collision. Ford recommends that all safety belt
assemblies used in vehicles involved in a
collision be replaced. However, if the collision
was minor and a qualified technician finds that
the belts do not show damage and continue to
operate properly, they do not need to be
replaced. Safety belt assemblies not in use
during a collision should also be inspected and
replaced if either damage or improper operation
is noted.
File:03icsrf.ex
Update:Wed Jan 24 14:30:01 1996
Page 31 of 268
29 [SR16960(ALL)05/94]
half page art:0032255-B
Safety belt buckle placement for child seats
[SR16980(ALL)05/95]
Using the Dual Locking Mode Retractor
When Installing a Child Safety Seat
*
[SR17000(ALL)05/95]
Your vehicle is equipped with a dual locking
mode retractor on the shoulder belt portoin of
the front passenger seat and both rear seats. The
automatic locking modemust be usedwhen
installing a child seat or infant carrier in the
front passenger seat or rear seats.
*
[SR17010(ALL)07/95]
RWARNING
Never install a rear-facing child seat or
infant carrier in the right front passenger
seat.
File:03icsrf.ex
Update:Wed Jan 24 14:30:01 1996
Page 34 of 268
32 [SR17160(ALL)07/95]
half page art:0032270-BBuckling the belt
*
[SR17225(ALL)07/95]
4. Grasp the shoulder portion of the belt and
pull downward until all of the belt is
extracted and a click is heard. At this time,
the retractor is in the automatic locking
mode (child seat restraint mode). See
Figure 4.
File:03icsrf.ex
Update:Wed Jan 24 14:30:01 1996
Page 35 of 268
33 [SR17275(ALL)07/95]
half page art:0032271-A
Setting the retractor to automatic locking mode
*
[SR17280(ALL)07/95]
5. Allow the belt to retract. Pull up on the
shoulder webbing. A clicking sound will be
heard as the belt retracts. This indicates the
retractor is in the automatic locking mode.
Push down on the child seat while you pull
up on the belt to remove any slack in the
belt. See Figures 5 and 6.
File:03icsrf.ex
Update:Wed Jan 24 14:30:01 1996
Page 37 of 268
35 [SR17284(ALL)07/95]
half page art:0032246-C
Removing slack from the belt
*
[SR17286(ALL)07/95]
6. Before placing the child in the child seat,
forcibly tilt the seat from side to side, and
tug it forward to make sure that the seat is
securely held in place. See Figure 7.
[SR17300(ALL)05/95]
7. Double-check that the retractor is in the
automatic locking mode. Try to pull more
belt out of the retractor. If you cannot, the
belt is in the automatic locking mode. See
Figure 8.
File:03icsrf.ex
Update:Wed Jan 24 14:30:01 1996