lights FORD ASPIRE 1997 1.G Owners Manual

7
Instrumentation
[IS00600(ALL)04/96]
The warning lights and gauges alert you to
possible problems with your vehicle. The
following section details what each of these
indicators means.
[IS00650(ALL)01/96]
In your vehicle, the warning lights and gauges
are grouped together on the instrument panel.
We call this grouping a cluster. Your vehicle has
a standard cluster.
File:03icisf.ex
Update:Tue Mar 4 08:51:24 1997

9
*
[IS01950(ALL)01/96]
Indicator Lights and Chimes
%*
[IS01975(ALL)03/96]
Safety Belt Warning Light and Chime
[IS01990(ALL)01/96]
one inch art:0030171-B
Safety belt light
[IS02000(ALL)01/96]
This warning light and chime remind you to
fasten your safety belt under the following
conditions:
[IS02100(ALL)04/96]
q
If the safety belt is not buckled when the
ignition is turned to the ON position, the
chime will turn on for four (4) to eight (8)
seconds and the light will illuminate for at
least 60 seconds.
*
[IS02200(ALL)01/96]
q
If the safety belt is buckled while the light is
on and the chime is sounding, both the light
and chime will turn off.
*
[IS02300(ALL)03/96]
q
If the safety belt is buckled before the
ignition is turned to the ON position, neither
the light nor the chime will come on.
%*
[IS02400(ALL)01/96]
Brake System Warning Light
[IS02550(ALL)01/96]
one inch art:0032206-B
Brake system and parking brake light
File:03icisf.ex
Update:Tue Mar 4 08:51:24 1997

12 [IS03900(ALL)04/96]If the light stays on or illuminates while the
engine is running:
*
[IS04000(ALL)03/96]
1. Pull off the road as soon as safely possible.
[IS04100(ALL)01/96]
2.Shut off the engine immediately.Continued
operation could cause severe engine damage.
[IS04200(ALL)01/96]
3. Check the engine oil level. Make sure the car
is on level ground.
[IS04300(ALL)01/96]
4. Add oil to the full mark on the dipstick
before you drive your car again. Do not
overfill. Do not operate the engine when the
oil light is on. For more information about
adding oil, seeEngine oil recommendationsin
the Index.
[IS04350(ALL)01/96]
WARNING
Do not rely on the oil light to tell you
when the oil is low. Have the oil checked
often. It is possible for damage to occur if
an engine is operated with a low oil level.
%*
[IS04500(ALL)03/96]
High Beam Light
*
[IS04600(ALL)03/96]
This light illuminates when the headlamps are
turned to high beam or when you flash the
lights. If your vehicle is equipped with daytime
running lights and you have your headlamps on
your high beam telltale will not illuminate when
you flash the lights.
*
[IS04700(ALL)01/96]
one inch art:0030174-A
High beam light
File:03icisf.ex
Update:Tue Mar 4 08:51:24 1997

16
*
[IS06075(ALL)01/96]
NOTE: If your vehicle must be jump-started
because of a low battery, the Anti-Lock
Brake System warning light could
remain on. This is due to low battery
voltage and does not indicate a
malfunction in the system. Under these
circumstances, you should drive your
vehicle only after the battery has had
time to charge and the light has gone
out.
[IS06090(ALL)02/96]
After starting the engine, check all the warning
lights to make sure that they are off. If any one
of them is still lit, it indicates a situation that
needs your attention. When you release the
parking brake, the brake warning light should
go off.
%*
[IS06100(ALL)01/96]
Ignition Key Chime
*
[IS06105(ALL)01/96]
If the driver or passenger door is open while the
key is still in the ignition, a warning chime
sounds.
[IS06115(ALL)02/96]
Headlamps On Chime
[IS06120(ALL)01/96]
This chime will sound when a door is opened
while the headlamps or parking lamps are on.
*
[IS06200(ALL)04/96]
Gauges
%*
[IS06300(ALL)03/96]
Fuel Gauge
*
[IS06325(ALL)01/96]
The fuel gauge displays approximately how
much fuel you have in the fuel tank.
*
[IS06350(ALL)01/96]
The ignition must be turned off while putting
fuel in the tank in order to get a correct fuel
gauge reading after the ignition is turned on.
*
[IS06375(ALL)01/96]
The fuel gauge indicator may vary slightly while
the vehicle is in motion. This is the result of fuel
movement within the tank. You can get a more
accurate reading with the vehicle on smooth,
level ground.
File:03icisf.ex
Update:Tue Mar 4 08:51:24 1997

28
*
[AS35550(ALL)04/96]
NOTE: Always make sure your antenna is
fully extended to the maximum length
for proper reception. If your antenna is
not fully extended, you may experience
signal loss while traveling in fringe
reception areas.
*
[AS35600(ALL)08/95]
2. Terrain
*
[AS35700(ALL)08/95]
The terrain (hilly, mountainous, tall buildings) of
the area over which the signal travels may
prevent the FM signal from being noise-free.
*
[AS35900(ALL)08/95]
If there is a building or large structure between
the antenna and station, some of the signal
ªbendsº around the building, but certain spots
receive almost no signal. Moving out of the
ªshadowº of the structure will allow the station
to return to normal.
*
[AS36000(ALL)08/95]
When the radio waves are reflected off objects or
structures, the reflected signal cancels the normal
signal, causing the antenna to pick up noise and
distortion. Cancellation effects are most
prominent in metropolitan areas, but also can
become quite severe in hilly terrain and
depressed roadways.
*
[AS36100(ALL)08/95]
To minimize these conditions, a stereo/mono
blend circuit has been incorporated into this
system. This feature automatically switches a
weak stereo signal to a clearer monaural signal,
which improves the quality of reception.
*
[AS36200(ALL)08/95]
Several sources of static are normal conditions
on AM frequencies. These can be caused by
power lines, electric fences, traffic lights and
thunderstorms.
File:04icasf.ex
Update:Tue Mar 4 08:51:43 1997

41 %
*
[CF14900(ALL)03/96]
NOTE: Never use sharp instruments or
window cleaners with abrasives to
clean the inside of your rear window.
If you do, you may damage the heating
elements that are bonded to the inside
of the rear window and cause damage
to the rear window defroster.
*
[CF17700(ALL)01/96]
Interior Lights
%*
[CF20500(ALL)01/96]
Lighting Up the Interior and Instrument
Panel
*
[CF20600(ALL)01/96]
With the parking lamps or headlamps on, the
brightness of the instrument panel lighting can
be adjusted.
*
[CF20700(ALL)01/96]
To brighten or dim the instrument panel
lighting, rotate the dimmer control thumbwheel
as desired.
[CF20850(ALL)01/96]
quarter page art:0032171-B
Dimmer control thumbwheel
[CF20900(ALL)01/96]
The dimmer control thumbwheel is located to
the right of the steering wheel on the instrument
panel.
[CF21800(ALL)01/96]
Interior Courtesy Lamp
[CF22500(ALL)01/96]
Your vehicle is equipped with an interior
courtesy lamp with a three-position switch.
[CF22600(ALL)01/96]
q
OFF-light will not turn on
[CF22700(ALL)01/96]
q
DOOR-light will turn on when the door is
open
File:05iccff.ex
Update:Tue Mar 4 08:52:57 1997

45
*
[CF30620(ALL)01/96]
If your key is stuck in the LOCK position and
will not turn, move your steering wheel left or
right until the key turns freely.
[CF30630(ALL)01/96]
If your vehicle has a manual transaxle, you must
push the key toward the steering column to
rotate the switch to the LOCK position.
*
[CF30650(ALL)01/96]
ACC (accessory) allows some of your vehicle's
electrical accessories such as the radio and the
windshield wipers to operate while the engine is
not running.
*
[CF30660(ALL)01/96]
ON allows you to test your vehicle's warning
lights (except the brake system warning light) to
make sure they work before you start the
engine. The key returns to the ON position once
the engine is started and remains in this position
while the engine runs.
*
[CF30680(ALL)01/96]
START cranks the engine. Release the key once
the engine starts so that you do not damage the
starter. The key should return to ON when you
release it. The START position also allows you
to test the brake warning light.
%
*
[CF32000(ALL)01/96]
Hazard Flasher Switch
[CF32100(ALL)02/96]
The hazard flasher switch is located on the top
of the steering column. For more information,
refer toHazard Flasherin theRoadside Emergencies
chapter.
%
*
[CF34000(ALL)02/96]
The Turn Signal Lever
*
[CF35000(ALL)02/96]
You can use the turn signal lever on the left side
of the steering column to:
*
[CF35020(ALL)02/96]
q
operate the headlamps and parking lamps
*
[CF35030(ALL)02/96]
q
operate the turn signals and cornering lamps
*
[CF35050(ALL)03/96]
q
turn the high beams on/off
*
[CF35060(ALL)03/96]
q
flash the lamps
File:05iccff.ex
Update:Tue Mar 4 08:52:57 1997

46
*
[CF36000(ALL)02/96]
Headlamps and Parking Lamps
*
[CF36100(ALL)02/96]
To turn the parking lamps or headlamps on,
twist the knob at the end of the turn signal
lever.
[CF36200(ALL)01/96]
FIRST STOP Ð Turning the knob to the first
stop will turn on the license plate lamps,
parking lamps, side marker lamps, tail lamps,
and instrument panel lamps.
[CF36300(ALL)01/96]
SECOND STOP Ð Turning the knob to the
second stop will turn on the headlamps, license
plate lamps, parking lamps, side marker lamps,
tail lamps, and instrument panel lamps.
[CF36400(ALL)01/96]
quarter page art:0032172-A
Headlamp and parking lamp control
%*
[CF36450(ALL)03/96]
Daytime Running Light System
*
[CF36500(ALL)03/96]
(Canadian vehicles only)
*
[CF36600(ALL)04/96]
In Canada, the lights illuminate during daytime
operation. The Daytime Running Light system
(DRL) automatically illuminates when the
ignition switch is turned to the ON position. The
daytime running lights are switched off under
the following conditions:
*
[CF36620(ALL)01/96]
q
when the headlamps are switched on
*
[CF36630(ALL)01/96]
q
when the parking brake is applied
*
[CF36640(ALL)01/96]
q
when the flash-to-pass system is used
File:05iccff.ex
Update:Tue Mar 4 08:52:57 1997

47
*
[CF36700(ALL)03/96]
WARNING
The Daytime Running Light (DRL) system
will not illuminate the tail lamps and
parking lamps. Turn on your headlamps
at dusk. Failure to do so may result in a
collision.
*
[CF36800(ALL)08/95]
High Beams and Flashing the Lamps
*
[CF36900(ALL)01/96]
To turn on the high beams, turn the headlamp
control knob to the headlamp ON position and
push the turn signal lever away from you until
it latches. When the high beams are ON, the
high beam indicator light on the instrument
panel comes on.
*
[CF36950(ALL)01/96]
To turn off the high beams, pull the lever
toward you until it latches. The high beam
indicator light turns off.
%*
[CF36970(ALL)01/96]
Flashing the Lights
*
[CF37000(ALL)01/96]
To flash the headlamps, pull the lever toward
you for a moment and then release it. The
headlamps will flash whether the headlamp
knob is in the on or off position.
[CF37100(ALL)01/96]
quarter page art:0032173-B
High beam and flash-to-pass operation
File:05iccff.ex
Update:Tue Mar 4 08:52:57 1997

94
*
[TO05500(ALL)01/96]
3.If you have an automatic transaxle, make
sure that the gearshift is in P (Park) and the
parking brake is set before you turn the key.
*
[TO05600(ALL)01/96]
If you have a manual transaxle, make sure
that the parking brake is fully set, push the
clutch pedal to the floor, and put the
gearshift into Neutral before you turn the
key.(Remember, the starter will operate
only if the clutch pedal is pushed all the
way to the floor.)
*
[TO05800(ALL)02/96]
Before you start your vehicle, you should test
the warning lights on the instrument panel to
make sure that they work. Refer to the
Instrumentationchapter.
%*
[TO06000(ALL)01/96]
Starting Your Engine
*
[TO06100(ALL)01/96]
To start your engine:
*
[TO06300(ALL)01/96]
1. Follow the steps underPreparing to Start
Your Vehicleat the beginning of this section.
*
[TO06320(ALL)01/96]
2. Keep your foot on the brake pedal and turn
the ignition key to the ON position.
*
[TO06330(ALL)01/96]
3. DO NOT depress the accelerator pedal when
starting your engine. DO NOT use the
accelerator while the vehicle is parked.
*
[TO06340(ALL)01/96]
4. Turn the key to the START position
(cranking) until the engine starts. Allow the
key to return to the ON position after the
engine has started.
*
[TO06400(ALL)01/96]
If you have difficulty in turning the key,
rotate the steering wheel slightly because it
may be binding.
File:08ictof.ex
Update:Tue Mar 4 08:54:32 1997