c max FORD C MAX 2008 1.G User Guide

Downloaded from www.Manualslib.com manuals search engine CAUTIONS
Do not exceed the maximumpower output. If you do, the LEDwill flash twice. Remove the plug andre-insert it.
If the LED flashes 3 or 4 times,have the system checked by aproperly trained technician.
CENTRE CONSOLE
Front seat centre console
WARNINGS
Do not place hot drinks in thecup holders when the vehicle ismoving.
Do not use the rear storagecompartment as an ashtray.
The following features areincorporated into the centre console:
•Front and rear storagecompartments.
•Ashtray. To empty, pull out thecomplete ashtray.
•Cigar lighter. See Cigar lighter(page 134).
•Cup holders.
•Auxiliary input (AUX IN) socket.See Auxiliary input (AUX IN)socket (page 140).
•Storage box.
Storage box
135
Convenience featuresE98199 E73704

Downloaded from www.Manualslib.com manuals search engine Except vehicles with aFlexfuel engine
Cold/hot engine
WARNING
At temperatures below -20 ºC,turn the ignition key to positionII for at least one second. Thisensures that maximum fuel pressureis established.
Depress the clutch pedal fully andstart the engine without touching theaccelerator.
If the engine does not start within 15seconds, wait for a short period andrepeat the procedure.
If the engine does not start afterthree attempts wait 10 seconds andfollow the Flooded engineprocedure.
If starting difficulty is experienced attemperatures below -25ºC, depressthe accelerator pedal ¼ to ½ of itstravel to assist starting.
Flooded engine
Depress the clutch pedal fully.
Slowly depress the accelerator fully,hold it in this position and start theengine.
If the engine does not start repeatthe Cold/hot engine procedure.
Vehicles with a Flexfuelengine
Starting at low ambienttemperatures
When the temperature is expectedto be lower than -15°C and thevehicle is filled with bio ethanol E 85,an engine block heater should beused to facilitate starting.
If the temperature is expected toremain below -15°C, it isrecommended that you increase theproportion of petrol in the tank bytopping up with 95 octane unleadedpetrol if the tank is not already full.About 10 litres of petrol will reducethe proportion of bio ethanol E 85 ina ¾ full tank from 85% to 70%.
If, at very low temperatures, the tankis filled with only bio ethanol E 85 andthere is no way to use an engineblock heater, you may experiencedifficulties starting the engine.
If the engine fails to start, proceed asfollows:
1.Depress the accelerator pedal 1/3to ½ of its travel.
2.Turn the ignition key to positionIII.
3.Release the ignition key as soonas the engine has started andrelease the accelerator pedalgradually as the engine speedincreases.
4.If the engine fails to start, depressthe accelerator pedal fully andrepeat steps 2 and 3.
143
Starting the engine

Downloaded from www.Manualslib.com manuals search engine PRINCIPLE OF
OPERATION
Electronic stabilityprogramme (ESP)
WARNING
ESP does not relieve you of yourresponsibility to drive with duecare and attention.
without ESPA
with ESPB
The ESP supports stability when thevehicle starts to slide away from yourintended path. This is performed bybraking individual wheels andreducing engine torque as needed.
The system also provides anenhanced traction control functionby reducing engine torque if thewheels spin when you accelerate.This improves your ability to pull awayon slippery roads or loose surfaces,and improves comfort by limitingwheel spin in hairpin bends.
Stability control (ESP) warninglamp
The ESP warning lamp will flash whenthe system is operating. SeeWarning lamps and indicators(page 90).
Emergency brake assist
WARNING
Emergency brake assist doesnot relieve you of yourresponsibility to drive with due careand attention.
Emergency brake assist will detectwhen you brake heavily by measuringthe rate at which you press the brakepedal. It will provide maximumbraking efficiency as long as youpress the pedal. Emergency brakeassist can reduce stopping distancesin critical situations.
160
Stability controlE72903AAABBBB

Downloaded from www.Manualslib.com manuals search engine GENERAL INFORMATION
WARNINGS
Use load securing straps to anapproved standard, e.g. DIN.
Make sure that you secure allloose items properly.
Place luggage and other loadsas low and as far forward aspossible within the luggage orloadspace.
Do not drive with the tailgate orrear door open. Exhaust fumesmay enter the vehicle.
Do not exceed the maximumfront and rear axle loads for yourvehicle. See Vehicleidentification (page 226).
Heavy loads, when placed in thepassenger compartment,should be on folded rear seats asshown. See Rear seats (page 124).
LUGGAGE COVERS
WARNING
Do not place objects on theluggage cover.
Note:When moving the rear seatsinto the comfort position, fold backthe cover from the front edge.
Detach the two lifting straps on thetailgate. Fold back the cover from thefront edge. Release the cover fromits retaining points and lift it out.
When reinstalling it, ensure that it isproperly secured at the retainingpoints.
167
Load carryingE97377 E78092

Downloaded from www.Manualslib.com manuals search engine TOWING A TRAILER
WARNINGS
Do not exceed the maximumvehicle and trailer weight statedon the vehicle identification plate. SeeVehicle identification (page 226).
ST vehicles are not approvedfor trailer towing.
Note:Not all vehicles are suitable orapproved to have tow bars fitted.Check with your dealer first.
Place loads as low and central to theaxle(s) of the trailer as possible. If youare towing with an unladen vehicle,the load in the trailer should beplaced toward the nose, within themaximum nose load, as this gives thebest stability.
Note:The maximum trailer noseweight can be found on themanufacturers data plate on the towbar.
The stability of the vehicle to trailercombination is very much dependanton the quality of the trailer.
In high altitude regions, the stipulatedmaximum permitted gross trainweight must be reduced by 10% forevery 1 000 metres (3 281 feet).
Steep gradients
WARNING
The overrun brake on a trailer isnot controlled by ABS.
Change down a gear before youreach a steep downhill gradient.
DETACHABLE TOW BALL
WARNING
The tow ball arm must be storedsecurely in the luggagecompartment at all times whendetached.
169
TowingE71328

Downloaded from www.Manualslib.com manuals search engine Brake and clutch fluid reservoir (left-hand drive)*: See Brake and
clutch fluid check (page 202).
E
Battery: See Vehicle battery (page 209).F
Auxiliary fuse box: See Fuses (page 176).G
Air cleaner: No maintenance necessary.H
Engine oil dipstick*: See Engine oil check (page 200).I
*For easy identification, filler caps and the engine oil dipstick are marked in
colour.
ENGINE OIL DIPSTICK -
1.6L DURATEC-16V
(SIGMA)/1.6L DURATEC-
16V TI-VCT (SIGMA)
MINA
MAXB
ENGINE OIL DIPSTICK -
1.8L DURATEC-HE
(MI4)/2.0L DURATEC-HE
(MI4)
MINA
MAXB
199
MaintenanceE95540BA E92036AB

Downloaded from www.Manualslib.com manuals search engine ENGINE OIL DIPSTICK -
1.6L DURATORQ-TDCI
(DV) DIESEL
MINA
MAXB
ENGINE OIL DIPSTICK -
1.8L DURATORQ-TDCI
(LYNX) DIESEL
MINA
MAXB
ENGINE OIL DIPSTICK -
2.0L DURATORQ-TDCI
(DW) DIESEL
MINA
MAXB
ENGINE OIL CHECK
CAUTION
Do not use oil additives or otherengine treatments. Under certainconditions, they could damage theengine.
Note:The oil consumption of newengines reaches its normal level afterapproximately 5 000 kilometres (3000 miles).
Checking the oil level
CAUTION
Make sure that the level isbetween the MIN and the MAXmarks.
Note:Check the level before startingthe engine.
200
MaintenanceE90983AB E95527BA E95543BA

Downloaded from www.Manualslib.com manuals search engine Note:Make sure that your vehicleis on level ground.
Note:Oil expands when it is hot. Thelevel may therefore extend a fewmillimetres beyond the MAX mark.
Remove the dipstick and wipe it witha clean, lint free cloth. Replace thedipstick and remove it again to checkthe oil level.
If the level is at the MIN mark, top upimmediately.
Topping up
WARNINGS
Only top up when the engine iscold. If the engine is hot, wait 10minutes for the engine to cool down.
Do not remove the filler capwhen the engine is running.
Remove the filler cap.
CAUTION
Do not top up further than theMAX mark.
Top up with fluid that meets the Fordspecification. See Technicalspecifications (page 204).
ENGINE COOLANT
CHECK
CAUTION
Make sure that the coolant levelis between the MIN and theMAX marks.
Note:Coolant expands when it ishot. The level may therefore extendbeyond the MAX mark.
Topping up the coolant
WARNING
Do not remove the coolantreservoir cap when the engineis hot. Wait for the engine to cooldown.
Unscrew the cap slowly. Anypressure will escape slowly as youunscrew the cap.
201
MaintenanceE75521

Downloaded from www.Manualslib.com manuals search engine WARNINGS
Only add coolant when theengine is cold. If the engine ishot, wait 10 minutes for the engine tocool down.
Do not allow coolant to touchyour skin or eyes. If thishappens, rinse the affected areasimmediately with plenty of water andcontact your doctor.
CAUTION
Do not spill coolant on any partof the engine.
Only add coolant that meets the Fordspecification. See Technicalspecifications (page 204).
BRAKE AND CLUTCH
FLUID CHECK
WARNING
Do not allow brake fluid to touchyour skin or eyes. If thishappens, rinse the affected areasimmediately with plenty of water andcontact your doctor.
The brake and the clutch systemsare supplied from the same reservoir.
Make sure that the brake fluid levelis between the MIN and the MAXmarks.
POWER STEERING FLUID
CHECK
Vehicles with 1.4L Duratec-16V (Sigma) or 1.6LDuratec-16V (Sigma) or1.6L Duratec-16V Ti-VCT(Sigma) engine
The fluid level should come up to theMAX mark when the engine is cold.
202
MaintenanceE78897 E73701

Downloaded from www.Manualslib.com manuals search engine TECHNICAL SPECIFICATIONS
Vehicle fluids
SpecificationRecommended fluidItem
WSS-M2C913-B
Ford or MotorcraftFormula E SAE 5W-30
Engine Oil*Engine oil
WSS-M2C204-A2Ford or MotorcraftPower Steering FluidPower steering fluid
WSS-M97B44-DMotorcraft SuperPlusAntifreezeAntifreeze
ESD-M6C57-AFord or Motorcraft SuperDOT 4 Brake FluidBrake fluid
* You can use an alternative SAE 5W-30 engine oil, providing it meets the
specification defined by WSS-M2C913-B.
Note:If you operate your vehicle in temperatures below -20°C, you mustnot use SAE 10W-40 engine oil.
Topping up the oil: If you are unable to find an oil that meets thespecification defined by WSS-M2C913-B, you must use SAE 5W-30(preferred), SAE 5W-40 (except Flexfuel vehicles) or SAE 10W-40 thatmeets the specification defined by either ACEA A1/B1 (preferred) or ACEAA3/B3. Using these oils can result in longer engine cranking periods, reducedengine performance, reduced fuel economy and increased emission levels.
Capacities
Capacity in litres(gallons)ItemVariant
MAX-markPower assisted steeringfluidAll
55 (12.1)Fuel tankVehicles with a petrolengine
55 (12.1)Fuel tankVehicles with a dieselengine
204
Maintenance