lock FORD CONTOUR 1996 2.G Owners Manual

Safety Restraints
9
*
[SR03000(ALL)05/95]
RWARNING
Never let a passenger hold a child on his or her lap
while the vehicle is moving. The passenger cannot
protect the child from injury in a collision.
*
[SR03200(ALL)05/95]
Lock the doors of your vehicle before driving to lessen the risk
of the door coming open in a collision.
*
[SR03600(ALL)05/95]
Combination Lap and Shoulder Belts
*
[SR03900(ALL)05/95]
While your vehicle is in motion, the combination lap and
shoulder belt adjusts to your movement. However, if you brake
hard, turn hard, or if your vehicle receives an impact of 5 mph
(8 km/h) or more, the lap and shoulder belt locks and helps
reduce your forward movement.
*
[SR04000(ALL)05/95]
After you get into your vehicle, close the door and lock it. Then
adjust the seat to the position that suits you best.
*
[SR04100(ALL)05/95]
Pull the combination lap/shoulder belt from the retractor so
that the shoulder portion of the belt crosses your shoulder and
chest. Be sure the belt is not twisted. If it is, remove the twist.
Insert the belt tongue into the proper buckle until you hear a
snap and feel it latch. Make sure the tongue is securely fastened
to the buckle by pulling on tongue.
File:cdsro.ex
Update:Thu Jan 25 12:13:11 1996

Safety Restraints
11
% [SR05625(ALL)03/95]
Dual Locking Mode Lap/Shoulder Belt Retractor
[SR05650(ALL)12/94]
The front passenger seat and the rear outer seat combination lap
and shoulder belts are equipped with a dual locking mode
retractor on theshoulderbelt portion of the lap/shoulder belt.
This retractor can be switched from vehicle sensitive
(emergency) locking mode to automatic locking mode by pulling
the belt webbing all of the way out of the retractor. The
retractor modes function as follows.
*
[SR05675(ALL)02/95]
Vehicle sensitive (emergency) locking mode
[SR05700(ALL)05/94]
In this operating mode, the lap/shoulder belt retractor will
allow the occupant freedom of movement, locking tight only on
hard braking, hard cornering or impacts of approximately
5 mph (8 km/h) or more.
*
[SR05725(ALL)01/95]
Automatic locking mode
*
[SR05800(ALL)03/95]
This mode must be used when installing a child seat on the
front passenger seat and rear seats where dual locking retractors
are provided. To switch the retractor from the emergency
locking mode to the automatic locking mode, perform the
following steps:
*
[SR05850(ALL)03/95]
RWARNING
Rear facing infant seats should never be placed in the
front seat.
*
[SR05900(ALL)03/95]1.
Buckle the lap/shoulder combination belt.
*
[SR05950(ALL)01/95]2.
Grasp the shoulder portion of the belt and pull downward
until all of the belt is extracted and a click is heard. At this
time, the retractor is in the automatic locking mode (child
restraint mode).
[SR06000(ALL)03/95]3.
Allow the belt to retract. A clicking sound will be heard as
the belt retracts. This indicates that the retractor is in the
automatic locking mode.
File:cdsro.ex
Update:Thu Jan 25 12:13:11 1996

12
[SR06025(ALL)03/95]4.
Pull up on the shoulder belt to remove slack in the lap belt.
*
[SR06050(ALL)05/95]
NOTE: When the combination lap/shoulder belt is unbuckled
and allowed to retract completely, the retractor will
switch to the vehicle sensitive (emergency) locking
mode. See the detailed instructions underSafety Seats
for Childrenin this chapter.
*
[SR06051(ALL)05/95]
Shoulder Belt Height Adjustment
*
[SR06052(ALL)05/95]
Driver and right front passenger
[SR06053(ALL)03/95]
You can adjust the shoulder belt height to one of four (4)
positions.
*
[SR06054(ALL)03/95]
To adjust the belt down, push the release button (see figures 1
and 2). To adjust the belt up, slide the adjuster up. (You do not
have to push the release button.)
[SR06056(ALL)05/95]
17-1/2 pica
art:0001183-C
Figure 1 Ð The shoulder belt height adjuster
File:cdsro.ex
Update:Thu Jan 25 12:13:11 1996

Safety Restraints
13
[SR06057(ALL)05/95]
10-1/2 pica
art:0001184-D
Figure 2 Ð Adjusting the shoulder belt height
[SR06070(ALL)05/95]
Make sure the adjuster is firmly in one of the four positions.
The belt should be adjusted up or down until the belt rests on
your shoulder near your neck.
*
[SR06075(ALL)05/95]
RWARNING
Position the shoulder belt height adjuster so that the belt
rests across the middle of your shoulder. Be sure the
shoulder belt is properly positioned on your shoulder
each time you use the belt. If the shoulder belt is off
your shoulder, on your upper arm or neck, there is a
greater risk of severe injury in a collision.
*
[SR06100(ALL)05/95]
Lap Belts
*
[SR06200(ALL)05/95]
The lap belt in the center of the rear seat does not adjust
automatically. You must adjust it to fit snugly and as low as
possible around your hips. Do not wear it around your waist.
*
[SR06300(ALL)05/95]
Pull the belt across your hips andinsert the tongue into the
correct buckleon your seat until you hear a snap and feel it
lock. Make sure the buckle is securely fastened.
File:cdsro.ex
Update:Thu Jan 25 12:13:11 1996

Safety Restraints
29
%*
[SR22750(ALL)11/94]
Installing Child Safety Seats in the Front Passenger
Seat and Outer Rear Seating Positions
[SR22800(ALL)04/95]
Your vehicle is equipped with a dual locking mode retractor on
the shoulder belt portion of the combination lap/shoulder safety
belt for the right front seat passenger and rear outer passengers.
*
[SR22850(ALL)03/95]
If you choose to install a child safety seat in the front seating
position, move vehicle seat as far back as possible.
*
[SR22900(ALL)03/95]1.
Position the child seat in center of passenger seat.
*
[SR22950(ALL)03/95]2.
Pull down on shoulder belt, then grasp shoulder belt and lap
belt together. Figure 1.
[SR23000(ALL)02/94]
17-1/2 pica
art:0001270-AFile:cdsro.ex
Update:Thu Jan 25 12:13:11 1996

32
[SR23200(ALL)01/95]4.
Grasp the shoulder portion of the belt and pull downward
until all of the belt is extracted from the reel and a click is
heard. At this time the retractor is in the automatic locking
mode (child restraint mode). Figure 4.
[SR23250(ALL)04/94]
24 pica art:0001273-AFile:cdsro.ex
Update:Thu Jan 25 12:13:11 1996

Safety Restraints
33
[SR23300(ALL)03/95]5.
Allow the belt to retract. Pull up on the shoulder webbing. A
clicking sound will be heard as the belt retracts. This
indicates the retractor is in the automatic locking mode. Push
down on the child seat while you pull up on the belt to
remove any slack in the belt. Figures 5 and 6.
[SR23350(ALL)05/94]
17-1/2 pica
art:0001274-BFile:cdsro.ex
Update:Thu Jan 25 12:13:11 1996

36
*
[SR23550(ALL)11/94]7.
Double check that the retractor is in the automatic locking
mode. Try to pull more belt out of the retractor. If you
cannot, the belt is in the automatic locking mode, Figure 8.
[SR23600(ALL)05/94]
17-1/2 pica
art:0001277-B[SR23650(ALL)02/94]8.
Check to make sure that the child seat is properly secured
prior to each use. If the belt is not locked, repeat steps 4
through 7.
[SR23700(ALL)02/94]
To remove retractor from automatic lock mode, unbuckle the
belt and allow the webbing to retract fully. A click will be
heard as the belt retracts. The belt is back in normal operating
mode (vehicle sensitive emergency locking mode) when this
click disappears.
File:cdsro.ex
Update:Thu Jan 25 12:13:11 1996

41
Starting Your Contour
*
[ST03300(ALL)03/95]
Ignition
*
[ST03400(ALL)01/95]
Understanding the Positions of the Ignition
[ST03725(ALL)02/95]
10-1/2 pica
art:0001185-D
The positions of the key in the ignition
[ST04100(ALL)02/95]
LOCK and ACCESSORY lock the gearshift for all vehicles with
an automatic transaxle.
*
[ST04150(ALL)05/95]
RWARNING
LOCK position does not lock the gearshift on
floor-mounted manual transaxle gearshifts. If the parking
brake is not set and the gearshift is moved out of gear,
your vehicle may move unexpectedly and injure someone.
*
[ST04180(ALL)06/95]
The automatic transaxle gearshift must be in P (Park) to move
the key to the LOCK position.
*
[ST04200(ALL)01/95]
LOCK is the only position that allows you to remove the key.
The LOCK feature helps to protect your vehicle from theft.
*
[ST04300(ALL)05/95]
If your key is stuck in the LOCK position and will not turn,
move your steering wheel left or right until the key turns freely.
File:cdsto.ex
Update:Thu Jan 25 12:13:36 1996

42
[ST04400(ALL)05/94]
ACCESSORY allows some of your vehicle's electrical accessories
to operate while the engine is not running. For example, you
can use ACCESSORY to turn on the radio without starting the
engine.
*
[ST04425(ALL)05/95]
ON allows you to test your vehicle's warning lights (except the
brake system warning light) to make sure they work before you
start the engine. The key returns to the ON position once the
engine is started and remains in this position while the engine
runs.
*
[ST04450(ALL)03/95]
START cranks the engine. Release the key once the engine starts
so that you do not damage the starter. The key should return to
ON when you release it. The START position also allows you to
test the brake warning light.
%*
[ST04500(ALL)02/95]
Removing the Key From the Ignition
*
[ST04600(ALL)05/94]
Procedures for removing your key from the ignition vary,
depending on whether your vehicle has an automatic or manual
transaxle.
*
[ST04700(ALL)04/94]
If your vehicle has an automatic transaxle:
*
[ST04800(ALL)06/92]1.
Put the gearshift lever in P (Park).
*
[ST04900(ALL)01/95]2.
Set the parking brake fully.
[ST05000(ALL)05/94]3.
Rotate the ignition key to the LOCK position.
[ST05100(ALL)02/95]4.
Remove the key from the ignition.
*
[ST05200(ALL)04/94]
If your vehicle has a manual transaxle:
*
[ST05300(ALL)06/92]1.
Put the gearshift lever in 1 (First).
*
[ST05400(ALL)01/95]2.
Set the parking brake fully.
[ST05701(ALL)05/94]3.
Rotate the ignition key to the LOCK position.
[ST05801(ALL)02/95]4.
Remove the key from the ignition.
File:cdsto.ex
Update:Thu Jan 25 12:13:36 1996