ECU FORD CONTOUR 1997 2.G Owner's Manual

Maintenance and Care
181
[MC03700(ALL)12/95]3.
Lift the hood and secure it in the open position with the
prop rod. Make sure only the hole in the hood marked in
yellow is used.
[MC03800(ALL)12/95]
When you close the hood, make sure the prop rod is in its
retainer and that the hood latches securely.
*
[MC03900(ALL)12/95]
NOTE: Apply lubricant to the hood latch at six-month
intervals to maintain smooth and trouble-free
operation.
*
[MC04000(ALL)01/96]
NOTE: Read and understandPrecautions When Servicing Your
Vehicleat the beginning of this chapter before
opening the hood.
%*
[MC04100(ALL)03/96]
Engine Compartment
[MC04200(ALL)12/95]
Your vehicle has a 4-cylinder 2.0L EFI or 6-cylinder 2.5L EFI
engine.
File:11cdmco.ex
Update:Thu Sep 12 11:08:18 1996

Maintenance and Care
185
%*
[MC05400(ALL)01/96
]
Checking and Adding Engine Oil
*
[MC05500(ALL)01/96]
Since the proper amount of engine oil is important for safe
engine operation, check the oil using the dipstick each time you
put fuel in your vehicle. Remember the engine must be off, the
oil must be warm and the vehicle must be parked on level
ground.
%*
[MC05600(ALL)01/96
]
Checking the engine oil level:
*
[MC05700(ALL)01/96]1.
Turn the engine off after it has warmed up and allow a few
minutes for the engine oil to drain back into the oil pan.
*
[MC05800(ALL)01/96]2.
Set the parking brake fully and make sure that the gearshift
is securely latched in P (Park) (automatic transaxle) or 1
(First) (manual transaxle).
*
[MC05900(ALL)01/96]3.
Open the hood. Protect yourself from engine heat.
*
[MC06000(ALL)01/96]4.
Locate the engine oil dipstick (highlighted in yellow) and
carefully pull it out of the engine.
*
[MC06100(ALL)01/96]5.
Wipe the dipstick clean and put it back into position, making
sure it is fully seated.
[MC06200(ALL)12/95]
6 pica art:0001305-A
Engine oil dipstick (2.0L engine)
File:11cdmco.ex
Update:Thu Sep 12 11:08:18 1996

Maintenance and Care
195
[MC12700(ALL)12/95]
10-1/2 pica
art:0001260-A
The power steering fluid reservoir
[MC12800(ALL)04/96]
Use only MERCONHpower steering fluid that meets Ford's
Specification or an equivalent.
%*
[MC12900(ALL)01/96]
Automatic Transaxle Fluid
*
[MC13000(ALL)02/96]
Under normal circumstances, you do not need to check the fluid
level of the transaxle, since your vehicle does not use up
transaxle fluid. Refer to theMaintenance Schedulebooklet for
replacement intervals. However, if the transaxle is not working
properly Ð for instance, the transaxle may slip or shift slowly,
or you may notice some sign of fluid leakage Ð the fluid level
should be checked.
%*
[MC13100(ALL)01/96
]
Checking the Automatic Transaxle Fluid
*
[MC13200(ALL)12/95]
With the vehicle on a level surface and the brake fully applied,
start the engine and move the gear shift selector through all of
the gears allowing sufficient time for each position to engage.
Securely latch the gear shift selector in the P (Park) position.
Fully set the parking brake and leave the engine running.
File:11cdmco.ex
Update:Thu Sep 12 11:08:18 1996

208
%*
[MC22000(ALL)01/96]
Snow Tires and Chains
*
[MC22100(ALL)01/96]
During the winter months in some climates, you may need to
use snow tires and occasionally chains for your tires.
*
[MC22200(ALL)01/96]
RWARNING
Snow tires must be the same size and grade as the tires
you currently have on your vehicle.
*
[MC22300(ALL)01/96]
Use chains on the tires only in an emergency or if the law
requires them where you live. If you choose to use chains on
your vehicle's tires, be aware of the following:
*
[MC22400(ALL)01/96]
n
Tire chains may scratch or chip aluminum wheels. IT IS
RECOMMENDED THAT TIRE CHAINS ARE INSTALLED
ON STEEL WHEELS ONLY. Be sure to remove wheel
covers (if equipped) from steel rims before using tire chains
to avoid scratches or damage.
[MC22500(ALL)12/95]
n
Tire chains cannot be fitted with 205/60R tires.
*
[MC22600(ALL)01/96]
n
Local regulations may prohibit or restrict the use of tire
chains. Investigate the laws and regulations in your area
before installing chains.
*
[MC22700(ALL)01/96]
n
Put the chains on the front tires tightly with the ends held
down securely. Retighten the chains after driving 1/2 mile
(1 km). Follow the chain manufacturer's instructions.
*
[MC22800(ALL)01/96]
n
Do not drive faster than 30 mph (50 km/h) or the chain
manufacturer's recommended speed limit, whichever is
lower. Avoid bumps, holes and sharp turns. If you can hear
the chains rub or bang against your vehicle, remove the
chains to prevent damage to your vehicle.
File:11cdmco.ex
Update:Thu Sep 12 11:08:18 1996