oil level FORD ESCORT 1997 6.G Owners Manual

Anti-lock brake system (ABS)
Illuminates when the ABS needs
service. The light will also briefly
illuminate when the ignition key is
turned to ON and the engine is off.
Turn signal
Illuminates when the left hand or
right hand turn signal or the
hazard lamps are illuminated.
High beams
Illuminates when the headlamp
high beams are on.
Anti-theft (if equipped)
Illuminates when the anti-theft
system is arming and flashes when
the anti-theft system is armed.
Charging
Illuminates when there is a
problem with the alternator or
charging system and the electrical
system requires service. The light
will also briefly illuminate when
the ignition key is turned to ON
and the engine is off.
Oil pressure
Illuminates when the oil pressure
is low, not the low oil level.
However, if your engine's oil level
is low, it could affect the oil
pressure. Stop the vehicle and
check the oil level as soon as
possible. Do not drive the vehicle if
the light remains on. The light will
also briefly illuminate when the
ignition key is turned to ON and
the engine is off.
ABS
THEFT
Instrumentation
9

To check the engine oil, follow
these steps:
1. Once the engine is warm, turn
the engine off. Make sure the
vehicle is parked on level ground.
2. Automatic transaxle:
²Engage the parking brake.
²Place the gearshift in P.
Manual transaxle:
²Engage the parking brake.
²Depress the clutch and place
the gearshift in first gear.
3. Open the hood. If you need
assistance, refer toOpening the
Hoodin this chapter. Protect
yourself from engine heat.
4. Remove the engine oil dipstick
and wipe it clean. Insert the
dipstick fully, then remove it again.
The oil level should be in the
range shown on the dipstick.
5. Carefully pull the dipstick out
again. If the oil level is below the
ADD arrow, add engine oil as
necessary. If the engine oil is
beyond the FULL arrow, engine
damage or high oil consumption
may occur and some oil must be
removed from the engine.
6. Put the dipstick back and
ensure that it is properly seated.
ADD FULL
Maintenance and care
131

Adding engine
oil
1. Check the
engine oil. For
instructions,
refer to
Checking the
engine oilin this
chapter.
2. If the fluid
level is not
within the
normal range,
add engine oil by
removing the
engine oil filler cap and pouring in
oil.
3. Confirm that the oil level is full,
but be careful not to overfill the
engine.
Continuous contact with
USED motor oil has
caused cancer in laboratory rats.
Maintenance and care
132