warning light FORD ESCORT 1997 7.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 1997, Model line: ESCORT, Model: FORD ESCORT 1997 7.GPages: 191, PDF Size: 2.02 MB
Page 4 of 191
MIRRORS
0000
0000002030405060
70
80
90
10 0
11 020 4060
8010 0
12 0
16 0
18 0 140
200FUEL FILLCHEF1/22
13RPM x 1000
RSM
SET
ACC
CST OFF ON
R L
OFF2INT
1 OFF MIST
Exterior lamps and
turn signal lever
(pg. 26 and
pg. 9)
Foglamp switch
(if equipped)
(pg. 27)Fuel gauge
(pg. 13)Engine coolant
temperature gauge
(pg. 13)
Speedometer
(pg. 13)Tachometer (if
equipped)
(pg. 14)
Warning lights
(pg. 6)
Wiper/washer
lever (pg. 30)
Rear wiper/washer
(if equipped) (pg.
30) Speed control
(if equipped)
(pg. 27) Power mirrors
control (if
equipped)
(pg. 16) Instrument panel
dimmer switch
(pg. 15)
Instrumentation
4
Page 8 of 191
Safety belt
The safety warning light/chime is a
reminder to fasten your safety belt.
One of the following will take
place:
²If the lap/shoulder belt is not
buckled before the key is turned
to the ON position, the
will
illuminate for approximately one
minute or until the safety belt is
buckled.
²If the lap/shoulder belt is
buckled while
is illuminated
and the chime is sounding, both
will turn off.
²If the lap/shoulder belt is
buckled before the key is turned
to the ON position, neither light
or chime will activate.
Upshift (if equipped)
Illuminates when it is best to shift
to the next highest manual
transaxle gear for the maximum
fuel economy.
Brake
Illuminates when the parking brake
is activated and the ignition is
keyed to ON or the brake fluid
level is low. In addition, with the
parking brake off, the light will
illuminate when the engine is
cranked.
!P
BRAKE
Instrumentation
8
Page 10 of 191
Engine coolant
Illuminates when there is low
coolant level or a problem with the
engine coolant system. Stop the
vehicle and check the engine
coolant level as soon as possible.
The light will also briefly illuminate
when the ignition key is turned to
ON and the engine is off. For more
information on engine coolant,
refer toChecking and adding
engine coolantin the
Maintenance and carechapter.
Liftgate ajar (if equipped)
Illuminates when the ignition is in
the ON position and the liftgate is
open.
Many of the lights illuminate
briefly when you start the vehicle.
For more information on warning
light illumination, refer to
Preparing to start the vehiclein
theStartingchapter.
Warning chimes
Safety belt warning chime
For information on the safety belt
warning chime, refer to the
Seating and safety restraints
chapter.
Supplemental restraint system
(SRS) warning chime
For information on the SRS
warning chime, refer to the
Seating and safety restraints
chapter.
CHECK
COOLANT
Instrumentation
10
Page 26 of 191
ACC allows operation of some
accessories without starting the
engine.
ON allows testing of the vehicle's
warning lights.
START cranks the engine. The key
returns to the ON position after it
is released.
For more information on the
vehicle ignition and starting the
vehicle, refer toPreparing to start
the vehiclein theStarting
chapter.
Headlamp switch
Rotate the headlamp switch to the
desired position.
Headlamps on
Parking lamps, side marker
lamps, instrument panel lamps,
license lamps, and tail lamps on
OFF Lamps off
Daytime running light (DRL)
system (if equipped)
The DRL system turns on the high
beam headlamps, with a reduced
light output, when:
²the vehicle is running
²the vehicle has a fully released
parking brake
²the headlamp system is in the
OFF position
OFF
Controls and features
26
Page 62 of 191
SAFETY BELT INDICATOR
LIGHT AND WARNING CHIME
illuminates in the instrument
cluster and a chime sounds to
remind the occupants to fasten
their safety belts.
Conditions of operation
If...Then...
The driver's safety belt is not
buckled before the ignition key is
turned to ON...The safety belt indicator
illuminates for one to two minutes
and the warning chime sounds for
4-8 seconds.
The driver's side safety belt is
buckled while the indicator light is
illuminated and the warning
chime is sounding...The safety belt indicator light and
the warning chime turn off.
The driver's safety belt is buckled
before the ignition key is turned
to ON...The safety belt indicator light and
warning chime remain off.
AIR BAG PRECAUTIONS
Your vehicle is equipped with an
air bag supplemental restraint
system (SRS) designed to work
with the safety belts to help
protect you and your right front
seat passenger in the event of a
collision.
All occupants of the
vehicle, including the
driver, should always wear their
safety belts, even when an air
bag SRS is provided.
Seating and safety restraints
62
Page 64 of 191
²The driver air bag in the middle
of the steering wheel and the
passenger air bag above the
glove compartment.
²The electrical system, made up
of impact sensors, a diagnostic
module, and a backup power
supply.
The air bags inflate within a
fraction of a second after air bag
sensors detect a severe frontal
collision. Gas generators within the
air bags fill the air bags with a
non-toxic, non-flammable gas.
After the vehicle occupants have
impacted the air bags, the gas
empties through holes in the air
bags and the air bags deflate. You
may notice smoke and smell the
escaping gas after the air bags
deflate. This is normal.
You and your passengermustwear
your safety belts in order for the
air bag system to operate
effectively.
AIR BAG WARNING LIGHT AND
WARNING CHIME
When you turn the ignition key to
the ON position, the air bag system
performs a self-check of the:
²air bag sensors
²air bag module
²air bag inflators
²available battery power
²air bag warning light
Following a successful system
self-check, the
warning light
Seating and safety restraints
64
Page 65 of 191
in the instrument cluster
illuminates for approximately six
seconds to indicate that the
system is functional.
If you hear a group of five beeps,
or if the
warning light does
not illuminate, stays lit, or flashes,
the air bag system requires
immediate service. Have the
vehicle serviced by your dealer.
CHILD RESTRAINT
PRECAUTIONS
You are required by law to use
safety restraints for children in the
United States and Canada. If small
children ride in your vehicle
(generally children who are four
years of age or younger and who
weigh 18 kg [40 lb] or less), you
must put them in safety seats
made specially for children. Check
your local and state laws for
specific requirements regarding the
safety of your children.
Never let a passenger hold
a child on his or her lap
while the vehicle is moving. The
passenger cannot protect the
child from injury in a collision.
Always follow the instructions and
warnings that come with any infant
or child restraint you might use.
If possible, place children in the
rear seat of your vehicle. Accident
statistics suggest that children are
safer when properly restrained in
rear seating positions than when
Seating and safety restraints
65
Page 94 of 191
The ABS brake system conducts a
self-test each time the vehicle is
driven. A mechanical noise may be
heard while the system conducts
its self-test.
ABS warning light
TheABSlight in the instrument
cluster illuminates and remains
illuminated if an ABS fault is
detected. Have your vehicle
serviced by a qualified service
technician as soon as possible.
Normal braking operation is still
effective unless the
P!BRAKElight is
also illuminated.
Parking brake
The parking brake should be used
whenever the vehicle is parked.
To set the parking brake:
The parking brake is not designed
to stop a moving vehicle. However,
if the normal brakes fail, the
parking brake can be set to stop
the vehicle. The vehicle's stopping
distance will increase greatly and
vehicle steering response will be
limited.
When the ignition is turned to ON,
the
P!BRAKElight in the instrument
cluster illuminates and remains
illuminated until the parking brake
is released.
Driving
94
Page 95 of 191
If the parking brake is fully
released but the
P!BRAKEwarning light remains on,
have the brakes checked
immediately. They may not be
working properly.
Always set the parking
brake fully and make sure
that the gearshift is securely
latched in P (automatic
transaxle) or first gear (manual
transaxle).
To release the parking brake:
²While pressing the release
button, pull the handle upward
to release the brake.
²Push handle downward to the
off position.
Driving
95
Page 104 of 191
and change the weight on the
hitch.
Using trailer brakes
Use electric brakes or manual,
automatic, or surge-type hydraulic
brakes that meet federal and local
regulations. Install and adjust the
brakes according to the
manufacturer's instructions.
Do not connect a trailer's
hydraulic brake system
directly to your vehicle's brake
system. Your vehicle may not
have enough braking power and
your chances of having a
collision greatly increase.
Using safety chains
Always connect the trailer's safety
chains to the vehicle. To connect
the chains, cross the chains under
the trailer tongue and attach to the
vehicle frame or hook retainers
(not the bumper). Make sure there
is enough slack to allow the vehicle
to turn corners.
Using trailer lamps
See your local trailer dealer or
rental agency for the proper
instructions and equipment for
hooking up trailer lamps.
Do not hook the trailer lights
directly into the vehicle's lighting
system wiring. If the trailer lamps
are not installed properly, the
warning lights in the instrument
cluster may not work properly.
Driving
104