key FORD ESCORT 1998 6.G Owners Manual

ZX2 coupe instrument cluster
Low fuel
Illuminates when the fuel tank has
approximately eight liters (two
gallons) remaining. The lamp will
also illuminate when the ignition
key is turned to ON and the engine
is off.
Service engine soon
Your vehicle is equipped with a
computer that monitors the
engine's emission control system.
This system is commonly known as
the On Board Diagnostics System
(OBD II). This OBD II system
protects the environment by
ensuring that your vehicle
continues to meet government
emission standards. The OBD II
system also assists the service
technician in properly servicing
your vehicle.
TheService Engine Soon
indicator light illuminates when the
ignition is first turned to the ON
!
THEFT
LOW
FUEL
CHECK
COOLANTSERVICE
ENGINE
SOON
PBRAKEABS+ –MPH
205060 70FUEL
FILLEF
CH1
2 /RPMx1000
1234
5
6
7
8
304080
90
100
110
120
10
20 406080100120
140
160
180km/h
0
000000
00 0
LOW
FUEL
SERVICE
ENGINE
SOON
Instrumentation
7

For information on the safety belt
warning chime, refer to the
Seating and safety restraints
chapter.
Supplemental restraint system
(SRS) warning chime
For information on the SRS
warning chime, refer to the
Seating and safety restraints
chapter.
Key-in-ignition warning chime
Sounds when the key is left in the
ignition in the OFF/LOCK or ACC
position and either front door is
opened.
Headlamps on warning chime
Sounds when the headlamps or
parking lamps are on, the ignition
is off (and the key is not in the
ignition) and either front door is
opened.
Instrumentation
12

Fuel gauge
Displays approximately how much
fuel is in the fuel tank (when the
key is in the ON position). The
fuel gauge may vary slightly when
the vehicle is in motion. The
ignition should be in the OFF
position while the vehicle is being
refueled. When the gauge first
indicates empty, there is a small
amount of reserve fuel in the tank.
When refueling the vehicle from
empty indication, the amount of
fuel that can be added will be less
than the advertised capacity due to
the reserve fuel.
Engine coolant temperature
gauge
Indicates the temperature of the
engine coolant. At normal
operating temperature, the needle
remains within the normal area
(the area between the ªHº and
ªCº). If it enters the red section,
the engine is overheating. Stop the
vehicle, switch off the ignition and
let the engine cool. Refer to
Engine coolantin the
Maintenance and carechapter.
Never remove the coolant
recovery cap while the
engine is running or hot.
This gauge indicates the
temperature of the engine coolant,
not the coolant level. If the coolant
is not at its proper level or
mixture, the gauge indication will
not be accurate.
FUEL
FILL
EF
1
2 /
CH
Instrumentation
14

PANEL DIMMER CONTROL
Use to adjust the brightness of the
instrument panel.
²Rotate left to brighten.
²Rotate right to dim.
POWER SIDE VIEW MIRRORS
To adjust your mirrors:
1. Select L to adjust the left mirror
or R to adjust the right mirror.
2. Move the control in the
direction you wish to tilt the
mirror.
3. Return to the center position to
lock mirrors in place.
The ignition key must be in ACC
or ON to adjust the power side
view mirrors.
MIRRORS
L R
MIRRORS
L R
Controls and features
17

POSITIONS OF THE IGNITION
1. LOCK, locks the steering wheel,
gearshift lever (automatic
transaxle only) and allows key
removal. On vehicles with a
manual transaxle push the key in
while turning to lock.
2. ACCESSORY, allows the
electrical accessories such as the
radio to operate while the engine
is not running.
3. ON, all electrical circuits
operational. Warning lights
illuminated. Key position when
driving.
4. START, cranks the engine.
Release the key as soon as the
engine starts.
HEADLAMP CONTROL
Rotate the headlamp control
clockwise to the first position to
turn on the parking lamps only.
Rotate to the second position to
also turn on the headlamps.
Daytime running lamps (DRL)
(if equipped)
Turns the highbeam headlamps on
with a reduced output. To activate:
²the engine must be running
²the gearshift must not be in P
(Park)
²the headlamp control is in the
OFF or Parking lamps position.
LOCKACCONSTART0IIIIII4
3
2
1
OFF
Controls and features
26

The all-door remote entry system
allows you to:
²lock or unlock all vehicle doors
without a key.
²arm and disarm the anti-theft
system. (For more information
on the anti-theft system, refer to
Anti-theft systemin this
chapter.)
²open the trunk.
²activate the panic alarm.
The driver's door only entry
system allows you to:
²lock the driver's door and
liftgate (wagons)
²unlock the driver's door only
without a key.
²activate the panic alarm.
²open the trunk or unlock liftgate
(wagons).
The remote entry features only
operate with the ignition in the
OFF position.
Unlocking the doors
Press this control to unlock the
driver's door. The interior lamps
will illuminate.
With the all-door remote entry
system, press the control a second
time within five seconds to unlock
all doors (on wagons, this will not
unlock the liftgate).
Controls and features
40

1. Twist a thin coin between the
two halves of the transmitter. DO
NOT TAKE THE FRONT PART OF
THE TRANSMITTER APART.
2. Place the positive (+) side of
new batteries down. Refer to the
diagram inside the transmitter
unit.
3. Snap the two halves back
together.
Replacing lost transmitters
Take all your vehicle's transmitters
to your dealer for reprogramming
if:
²a transmitter is lost or
²you want to purchase additional
transmitters (up to four may be
programmed).
To reprogram the transmitters,
place the key in the ignition and
switch from OFF to ON eight times
in rapid succession (within 10
seconds). After doors lock/unlock,
press any button on all
transmitters (up to four). With
each button press of the
transmitters, the door should cycle
(lock/unlock) to confirm
programming. When completed,
switch the ignition to OFF. The
door locks should cycle
(lock/unlock) one last time to
confirm completion of
programming.
Controls and features
43

All transmitters must be
programmed at the same time.
Illuminated entry
Interior lamps will illuminate when
UNLOCK is pressed. The lamps
will illuminate for approximately 20
seconds or until the key is inserted
in the ignition and turned to ON or
until LOCK is pressed. The dome
lamp must be set to the DOOR
position in order for the
illuminated entry system to
operate.
ANTI-THEFT SYSTEM
(IF EQUIPPED)
When armed, the anti-theft system
will help protect your vehicle from
unauthorized entry.
Arming the anti-theft system
Turn the ignition to OFF and press
the lock control on the remote
entry transmitter.
Identifying an armed system
While the system is arming, the
THEFT light in the instrument
cluster will illuminate for 30
seconds. After 30 seconds, THEFT
will flash, indicating the system is
armed.
Controls and features
44

If the system is arming with the
doors open, the THEFT light will
stay illuminated until all the doors
are closed and then illuminate for
30 seconds and begin flashing.
When an unauthorized entry
occurs, the activated system will:
²flash the parking lamps and the
THEFT light
²sound the horn
The flashing parklamps and the
honking horn automatically shut
off after about three minutes and
will remain off unless another
unauthorized entry is attempted.
Disarming the anti-theft system
Disarming an untriggered
anti-theft system
Press the unlock control to disarm
the untriggered system. If the
driver armed the system but did
not exit the vehicle, disarm the
system by inserting the key and
turning the ignition to ON/ACC.
Using the ignition key to unlock
doors/trunk/liftgate will not disarm
the anti-theft system.
Controls and features
45

Disarming a triggered anti-theft
system
Press either the unlock or panic
control to disarm the system.
A triggered system may also be
disarmed by inserting the key and
turning the ignition to ACC or ON.
Controls and features
46