transmission FORD EXCURSION 2000 1.G Service Manual

Item Information
Required fuel Unleaded fuel only - 87 octane
Fuel tank capacity 166.6L (44.0 gallons)
Engine oil-gasoline engines
(includes filter change)5.7L (6.0 quarts). Use Motorcraft SAE
5W-30 Super Premium Motor Oil, Ford
specification WSS-M2C153-H.
Engine oil -diesel engine Refer to your 7.3L Diesel Supplement.
Tire size and pressure Refer to the label inside of driver's door.
Hood release Pull handle under the left side of the
instrument panel.
Coolant capacity
(gasoline engines)Refer toRefill capacitiesin the
Capacities and specificationschapter.
Coolant capacity
(diesel engine)Refer to your 7.3L Diesel Supplement.
Power steering fluid
capacityFill to line on dipstick. Use Motorcraft
MERCONtAT F.
Automatic transmission
fluid capacity
(4x2 vehicles)
1
16.1L (17.1 quarts). Use Motorcraft
MERCONtAT F.2
Automatic transmission
fluid capacity
(4x4 vehicles)
1
16.7L (17.7 quarts). Use Motorcraft
MERCONtAT F.2
Windshield washer fluid 4.2L (1.1 gallons). Use Ultra-Clear
Windshield Washer Concentrate.
1Ensure the correct automatic transmission fluid is used. Transmission
fluid requirements are indicated on the dipstick or on the dipstick
handle. Check the container to verify the fluid being added is of the
correct type. Refer to your scheduled maintenance guide to determine
the correct service interval.
Some transmission fluids may be labeled as dual usage, such as
MERCONtand MERCONtV. These dual usage fluids are not to be used
in an automatic transmission that requires use of the MERCONttype
fluid. However, these dual usage fluids may be used in transmissions that
require the MERCONtV type fluid.
MERCONtand MERCONtV type fluids are not interchangeable.
DO NOT mix MERCONtand MERCONtV. Use of a transmission
Filling station information
231

fluid that indicates dual usage (MERCONtand MERCONtV) in
an automatic transmission application requiring MERCONtmay
cause transmission damage. Use of any fluid other than the
recommended fluid may cause transmission damage.
2Indicates only approximate dry-fill capacity. Some applications may
vary based on cooler size and if equipped with in-tank cooler. The
amount of transmission fluid and fluid level should be set by the
indication on the dipstick's normal operating range.
Filling station information
232