turn signal bulb FORD EXPEDITION 2002 1.G Owners Manual

Oil pressure/Engine coolant
Illuminates when the engine coolant
temperature is above the normal
range or the engine oil pressure is
below normal range. Check the
engine oil and coolant level refer to
Adding engine oilandAdding coolantin theMaintenance and
specifications chapter.
Turn signals
Illuminates when the turn signals or
the hazard lights are turned on. If
the lights stay on continuously or
flash faster, check for a burned-out
bulb.
High beams
Illuminates when the high beam
headlamps are turned on.
Door ajar
Illuminates when any door is open
(or not fully closed).
SecuriLockYanti-theft system
Illuminates when the anti-theft
alarm system is armed. If the light
fails to illuminate, continues to flash
or remains on, have the system
serviced.
Refer toSecuriLockypassive anti-theft systemin theLocks and
Securitychapter.
DOOR
AJAR
THEFT
Instrument cluster
13

Without trip computer
To turn on the map lamps, press the control next to each lamp.
Rear dome lamp
The dome lamp lights when:
²any door is opened.
²the instrument panel dimmer
switch is held up until the
courtesy lamps come on.
²any of the remote entry controls
are pressed and the ignition is
OFF.
With the ignition key in the ACC or ON position, the rear dome lamp can
be turned ON or OFF by sliding the control.
BULBS
Replacing exterior bulbs
Check the operation of the following lamps frequently:
²Headlamps
²Foglamps
²High-mount brakelamp
²Brakelamps
²Parking lamps
²Turn signals
AUTO
ROOF
Lights
62

Replacing front parking lamp/turn signal bulbs
1. Make sure that the headlamp control is in the OFF position.
2. Open the hood.
3. Remove the screw and lamp assembly from the vehicle.
4. Rotate the bulb socket
counterclockwise and remove from
the lamp assembly.
5. Carefully pull the bulb out of the
socket and push in the new bulb.
6. Install the bulb socket into the
lamp assembly and rotate clockwise.
7. Install parking lamp assembly on
vehicle.
8. Push gently until parking lamp assembly seats.
9. Install screw on the lamp assembly.
Replacing tail lamp/backup lamp bulbs
The tail lamp/backup lamp bulbs are
located in the same portion of the
tail lamp assembly, one just below
the other. Follow the same steps to
replace either bulb:
1. Open the liftgate to expose the
lamp assembly screws.
2. Remove the two screws from the
lamp assembly.
3. Carefully pry the lamp assembly
away from the vehicle to expose the bulb sockets.
4. Rotate the bulb socket counterclockwise and remove from lamp
assembly.
5. Pull bulb straight out of socket and push in the new bulb.
6. Install the bulb socket into the lamp assembly and rotate clockwise.
7. Carefully install the tail lamp assembly on the vehicle snapping the
three retaining tabs into place.
8. Secure the lamp assembly with two screws.
Lights
66

headlamps, flash to pass ..........60
instrument panel, dimming .....60
interior lamps ...............61±62, 64
replacing bulbs .......62, 64, 66±68
Lane change indicator
(see Turn signal) ........................61
Liftgate ........................................93
Lights, warning and indicator ....10
air bag ........................................12
air suspension .........................159
anti-lock brakes (ABS) ....11, 156
anti-theft ...................................13
brake ..........................................11
charging system ........................12
check coolant ............................13
cruise indicator .........................12
door ajar ....................................13
engine oil pressure ...................13
high beam .................................13
low fuel ......................................12
low washer fluid .......................12
safety belt .................................11
service engine soon ..................10
speed control ............................86
turn signal indicator .................13
Load limits .................................177
GAWR ......................................177
GVWR ......................................177
trailer towing ..........................177
Loading instructions .................179
Locks
autolock ...................................101
childproof ..................................95
doors ..........................................95
Lubricant specifications ...263, 265
Lumbar support, seats .............110M
Message center .....................74, 90
english/metric button ...............90
menu button .............................91
Mirrors .........................................71
automatic dimming rearview
mirror ........................................80
fold away ...................................82
heated ........................................81
programmable memory ..........100
side view mirrors (power) .......80
Moon roof ....................................73
Motorcraft parts ................244, 259
O
Octane rating ............................243
Odometer .....................................17
Oil (see Engine oil) ..................228
Overdrive .....................................92
P
Panic alarm feature, remote
entry system ................................98
Parking brake ............................156
Parts (see Motorcraft parts) ....259
Pedals (see Power
adjustable foot pedals) ...............82
Power distribution box
(see Fuses) ...............................193
Power door locks ................95, 101
Power steering ..................157±158
fluid, checking and adding ....250
fluid, refill capacity ................260
fluid, specifications .........263, 265
Index
277