rear view mirror FORD EXPEDITION 2007 3.G Quick Reference Guide

This vehicle handles differently from an ordinary passenger car in driving conditions which may occur on streets and
highways and off-road. driVe WiTH cAre And WeAr A
SAfeTY BeLT AT ALL TiMeS. ford urges you to read the
Owner’s guide and driving Your SuV or Truck Supplement
for further information on safe driving precautions and instructions.
9
quick reference guide1 h eadla Mp and
p anel diMM er
Control
r otate clockwise to
the first position to turn on the parking
lamps. rotate to
the second position to also turn on the
headlamps. rotate
counterclockwise to activate the autolamp, which provides light-sensi-tive automatic on-off control of the exterior lights and keeps them on for a short period of time after the ignition is turned
O ff . When the control
is in any position except high beams or off, pull the control toward you to activate the foglamps.
2 t urn Signal and
Wiper/Wa Sher
Control Push down to activate the left turn signal, or up to activate the right turn signal. On equipped vehicles, the lower portion of the corresponding side view mirror will blink to provide an additional warning to other drivers that your vehicle is about to turn.
for front wiper
operation, rotate the end of the control to the desired interval, low- or high-speed
position. When in the intermittent position, rotate the control up for fast, or down for slow intervals. The speed-sensitive feature also allows the wipers to adjust automatically as the vehicle’s speed changes when the wiper control is set on the intermittent settings. Push in the end of the stalk briefly for a single wipe (no wash). Push in and hold to activate the washer.
The ring on the right operates the rear window wiper.
r otate the control
to 2 (normal speed), 1 (intermittent), or washer position.
for extended
wiper blade quality, occasional cleaning of the wiper blades is required.
3 ab S Warning
l a M p This lamp illu-minates briefly when the ignition is turned
to the O n position. in
an emergency, apply continuous force on the brake to prevent wheel lockup when braking on slippery surfaces - do not pump your brakes. Any pulsation or noise you may feel or hear is normal.
4 Servi Ce engine
Soon la M p This lamp illuminates briefly to ensure the system is functional.
if the lamp comes
on after the engine is started, refer to
your Owner’s guide.
To help prevent activation, always secure your fuel cap by turning it clockwise 1/4 of a turn until at least a few clicks are heard.
Please note that if the fuel cap is not properly secured,
the warning “ check
f uel cap” will be
displayed on the optional message center. The warning will be reset once the cap is properly tightened and your vehicle is driven a
short distance. if
your vehicle is not equipped with a message center, the
Service engine Soon
lamp will illuminate.
5 Me SSage Center
(i F equipped) Please see “Additional
features” for more
details.
6 a ir Flo W a d Ju St You can direct or shut off the air flow from the instrument panel registers. Turn the steel portion on the round register module
either clockwise or counterclockwise with the vents open to adjust the airflow.
c lose the vents flat to
shut off the air flow.
7 pre Miu M/
audiophile a M/FM
in -da Sh S ix Cd/M p3
S atellite CoM pat
-
ible Sound SYSteM
(if equipped) Please see reverse side for more details.
8 h azard Fla Sher Control Press to activate all hazard flashers simultane-ously in an emer-gency to warn traffic of vehicle breakdown, approaching danger, etc. Press the control again to turn the flashers off. The hazard flashers can be operated when the ignition is off.
9 r ear Windo W
d eFro Ster Press to activate rear window defrost. The rear defrost indicator will illuminate. When in operation, the rear window defroster also defrosts the side view mirrors. The rear window defroster will automatically turn off after approximately 10 minutes of opera-tion. Press the control again to re-engage if needed.
in order to help you fully appreciate the countless
features of your new expedition, we invite you to
explore this easy-to-use quick reference guide.
For more information, please consult your
owner’s guide.
124567
1112131415
I N sTr Um ENT PaNEl
1234EXPEDITION
fOrD
38
10
10 auxiliar Y input
J a Ck (ai J) Your vehicle is equipped with an
Auxiliary input Jack
(A iJ) located below
the climate control. This allows you to plug and play auxiliary audio devices. Press
A ux repeatedly on
your audio system to
access. When L ine in
appears in the display, plug in your auxiliary
audio device. for more
detailed information, please refer to your
Owner’s guide.
11 Control tra C
Four-Wheel drive
(4 x4) operation (
if equipped) 2H (2W d) delivers power to the rear wheels only. This is appropriate for normal on-road driving on dry pavement.
4A (4 x4 A uTO)
provides electronic control four-wheel drive with power delivered to all four wheels, as required, for increased traction. The message center
will display “4 x4
A u TO” when this
position is selected.
4H (4 x4) provides
electronically locked four-wheel drive power to all four wheels. The message center
will display “4 x4”
when this position is selected. 4L (4
x4 LOW) provides
electronically locked four-wheel drive when extra power at reduced speeds is required. The message center will display
“4 x4 LOW” when this
position is selected.
To shift from 2H to 4A or 4H, move the control to the 4A or 4H position at any forward speed up to 55 mph (88 km/h) or at a stop. The message center
may display “4 x4
SH ifT in PrO gre SS”
during the system shift. The message center will then display
“4x4 A uTO” if 4A is
selected or “4 x4” if
4H is selected.
To shift from 4A to 4H, move the control from 4A to 4H at a stop or while driving at any speed. The message center will display “4x4”.
To shift to/from 4L, bring the vehicle to a stop. Place the
gearshift in n
( n eutral), then move
the control to the desired position. The message center will
display “4 x4 SH ifT in
P r O gre SS” during
the shift. The message center will then display the system mode
selected. if any of the
above shift conditions are not met, the shift will not occur and the message center will display the appropri-ate information.
Note: Some noise may be heard as the system shifts or engages.
12 g ear Shi Ft/
o verdrive Control Overdrive is the nor-mal drive position for the best fuel economy.
Only deactivate (O/ d
O ff ) overdrive when:
driving with a heavy load, towing a trailer up or down steep hills, or when additional engine braking is desired. To deactivate, press the switch located on the end of the gearshift lever.
Note: The transmis-sion shift strategy will slightly delay transmis-sion upshifts in cold weather to decrease the time required to warm up the engine and produce heat in the passenger compartment.
13 Steering Wheel
Control S (if equipped) for audio control operation,
press M ediA to select
which media to play.
depending on the
mode, press S eek to
select a preset station,
the next selection on a tape, or the next
track on a disc. use
VOL to adjust volume.
for climate control
operation, press T eMP
up or down to adjust temperature. Press the control with the fan icon up or down to adjust fan speed.
14 Speed Control To operate, the speed
control must be O n
and the vehicle speed must be greater than 30 mph (48 km/h). To set a speed, press
SeT +. To set a higher
speed, press S eT +
again. To set a lower
speed, press S eT -.
Pressing reS will
return to a previously set speed. To turn the speed control off,
press the O ff button,
or depress the brake pedal to disengage.
15 p o W er ad Ju St-
able Foot pedal S
(if equipped) Press and hold the rocker control to adjust the accelerator and brake pedal toward you or away from you. Adjust the pedals only when the vehicle is stopped and the gearshift lever is in the P (Park) position.
1112 1013
aDDITION al fEa TUrEs
1 a dvan CetraC®® W ith rSC® (if equipped) The AdvanceTrac®
with roll Stability controlTM
( r Sc ) system provides stability enhancement features for certain driving situations when driver assistance is
needed. it helps your vehicle
maintain traction when driving on slippery and/or hilly road
surfaces. if your vehicle should
become stuck, try switching the system off by pressing and holding the button on the center console for more than five seconds.
2 k eY le SS e ntr Y S YS teM (if equipped) With this control you can lock or unlock all doors
without using a key. first, enter
your five-digit program code and then press the corresponding quick key:
u nlock all doors = 3-4
Lock all doors = press buttons 7-8 and 9-0 simultaneously
3 h eated and Cooled Seat S (if equipped) The driver and passenger heated and cooled seat buttons are located on the climate control. Press the heated seat button once for full heat, twice for medium heat and three times for low heat. Pressing a fourth time will turn off this feature.
Press the cooled seat button once for full cool, twice for medium cool and a third time for low cool. Pressing a fourth time will turn off this feature.
4 Me SSage Center (if equipped) The message center displays important vehicle information through a constant monitor of vehicle systems
(with the ignition in the O n
position). The system will notify you of potential vehicle problems with a display of system warnings followed by a long indicator chime. You may select display features on the message center by pressing
the info or Setup buttons. The
r eset button may be used to
reset select functions in the
info and Setup menus.
f or complete details on the
message center display features, please consult your
Owner’s guide.
5 rever Se S en Sing SYS teM This system sounds a tone to warn the driver of obstacles near the rear bumper when the reverse gear is selected. Ob-stacles can be detected within approximately 10 feet (3m) behind the rear bumper while the vehicle moves in reverse at parking speeds. At higher speeds (above 2.5 mph), the system will report objects up to 16 feet (5m). The extended rear
park assist defaults to O n, but
can be disabled using the mes-sage center functions when the
ignition is O n, and the gearshift
is in r (r everse).
6 t ire pre SSure
Monitoring S YSteM (tp MS)
(if equipped) u sing radio-fre-quency pressure sensors, this
system monitors tire pressure on all road tires and provides the driver with a yellow warn-ing light when air needs to be added. Message center equipped vehicles provide ad-ditional warning messages. The TPMS warning light will reset itself (turn off) after the tires are set to specification and the vehicle is driven above 20 mph (32 km/h) for two minutes.
n ote: Outside temperature
affects tire pressure. Please
consult your Owner’s guide.
7 po Wer Fold Mirror S (if equipped) r otate the 4-way adjustment switch located on the driver’s door, to the center position. Press the switch to-ward you to fold in the mirrors. Press again to fold them back
to the original position. fold
the side mirrors in carefully when driving through a narrow space, like an automatic car wash.
if you fold in a mirror manually,
the power fold mirrors will need to be reset. To reset, move the 4-way adjustment switch to the center position. Press the switch toward you to fold the mirrors in, and wait for approximately 8 seconds. You should hear a clicking sound indicating that the mirrors have been reset.
if you do not hear the clicking
sound, press the switch to fold the mirrors back out, and repeat the reset procedure.
124