wipers FORD EXPEDITION 2013 3.G Quick Reference Guide

12
12
45
87
6
1 HeadlaMp ContR ols Turns the headlamps off. Turns on the parking lamps. Turns on the headlamps. Autolamps:
Automatically turns the
exterior lamps on/off based
on available daylight.
Turns on fog lamps by pulling
the control toward you.
2 MUltI-FUnC tIon leVeR:
Rotate the end of the control
stalk up/down to increase/
decrease the speed of the
wipers. Push the end of
the stalk:
• Quickly for a single swipe
without fluid;
• And hold briefly for three
swipes with washer fluid;
• And hold for a longer
wash cycle.
t o operate your rear
window wiper:
Turn the rear wiper control
to 1 (intermittent speed),
2 (normal speed) or o (off).
For a rear wash cycle, rotate
and hold the rear wiper control
to either
position. Note:
For optimal wiper
performance, clean your blades
and glass regularly. Refer to
your Owner’s Manual for
more information.
3 aBs WaRnIng lIgHt
The ABS light
illuminates
briefly when the ignition is
turned on. If the ABS light
remains on or continues
to flash, a malfunction has
been detected. Contact your
authorized dealer as soon as
possible. Normal braking (less
ABS) is still functional unless
the brake warning light
is
also illuminated.
4 s ervice engine s oon light
The service engine soon light
illuminates briefly when the
ignition is turned on. If it remains
on or is blinking after the
engine is started, the on-board
diagnostics system (OBD-II)
has detected a malfunction.
Drive in a moderate fashion and
contact your authorized dealer
as soon as possible.
5
InF oRMatIon CenteR*
The information center displays
important vehicle information
through a constant monitoring
of vehicle systems. The system
will notify you of potential
vehicle problems by displaying
system warnings followed by a
long indicator chime. For more
information about your vehicle’s
functions, please see your
Owner’s Manual.
6 po WeR- adJUstaBle
F oot pedals let you move
your brake and accelerator
pedals closer. Located on the
left-hand side of your steering
column, press the
arrow to
move the pedals closer to you,
or the
to move the pedals
further away from you. The
pedals should only be adjusted
when the vehicle is stopped
and in Park (P).
7 speed C ontRol
To set the speed:
1. Press on.
2. Accelerate to the
desired speed. 3.
Press set + and take your
foot off the accelerator.
• To set a higher or lower
speed, press and hold
set + / set - or press
set + / set - repeatedly
until the desired speed
is reached.
• To return to a previously
set speed, press R es.
• To turn off, press oFF or
turn off the ignition.
8 steeRIng WHeel
C ontR ols*
Press Vol + / V ol – to
increase/decrease your
volume level.
Press to access
the previous/next radio station,
CD track or preset satellite
radio channel.
Press MedIa repeatedly
to access all possible
media sources.
Press VoICe to access voice
recognition (if equipped).
Press
to access SYNC® phone
features (if equipped).
page 5 page 4
Instrument Panel
14
* if equipped
3

CONVENIENCE

mykey®
MyKey allows you to program certain
driving restrictions in order to promote
good driving habits. You can program
things such as speed restrictions and
limited volume levels. For complete
information, refer to the MyKey chapter in
your Owner’s Manual.
inTegraTed keyHead TranSmiTTer
Press once to lock all doors. Press
again to confirm all doors are closed.
• Press
once to unlock the driver’s
door. Press again within three seconds
to unlock all doors.
• Press
to activate the panic alarm.
Press again or turn the ignition on
to deactivate.
• Press
twice within three seconds to
open the liftgate.
• Car finder: Press
twice within
three seconds to locate your vehicle.
The horn will chirp and the turn lamps
will flash.


Securicode™ keyLeSS
enTry SySTem
Lock or unlock the doors, or release the
liftgate glass without using a key. The
keypad can be operated with the factory-
set, 5-digit entry code; this code is located
on the owner’s wallet card in the glove
box. You can also create up to five of your
own 5-digit personal entry codes.
To lock all of the doors and liftgate:
press and hold 7•8 and 9•0 at the same
time. For complete information, refer to
the SecuriCode Keyless Entry section in
the Locks chapter of your Owner’s Manual.
rain-SenSing wiPerS*
If activated, your wipers will automatically
turn on when moisture is present on
the windshield. The wiper speed will
vary based on the amount of moisture
detected and the sensitivity setting. To
deactivate, turn your wiper controls off.
Note: Make sure that this feature is turned
off before entering a car wash.
memory fea Ture*
The memory function allows a “one
touch” recall of personalized memory
features (i.e. the positions of the driver
seat, power mirrors and power-adjustable
foot pedals). Use the memory controls
located on the side of the driver’s seat
to program and then recall
memory positions.
To program position 1, press and hold the
1 button
until you hear a chime.
Use this same procedure to set the
second position using the 2 button
.
You can now use these controls to recall
the set memory positions.
SoS PoST -craSH aLerT SySTem™
The SOS Post-Crash Alert System™
provides audible and visual alarms in
the event of a crash. The turn signals
will flash and the horn will sound. To
deactivate the system, press the hazard
flasher control, or you can press on your
remote transmitter.
COMFORT
SeaTing-To-cargo VerSa TiLiTy
Note: Before folding the second- or third-row
seats, ensure that the head restraints are fully
flipped down by pulling on the strap, and that
all items have been removed from the floor
and seats.
To foLd THe fLa T-foLding THird-row
Sea TS down:
1. Lift Lever 1 located on the outboard side of
the seat.
2. Pull Lever 2 to release the seat into the
kneel-down, floor position.
3. Move the seat forward and down.
Note: A moderate force may be required to
move the seat forward and down.

t o return them to a seating position:
1. Lift and pull the seat rearward until the latch
is fully engaged.
2. Lift up on the seat back until a click is heard.
This click signals that the seat has locked
into its upright position.
3. Lift up on the head restraint until it locks into
its original position.

Pull Strap
Lever 1
Lever 2
e-Z enTry inTo THe
THird-row Sea TS
The E-Z entry seat allows for easier
entry and exit to and from the third-
row seat.
to enter the third-row seating area:
1. Fold the head restraint forward.
2. Pull up on Lever 1.
3. Fold down the second-row seat
and release the handle.
4. Pull the handle up again until the
seat releases from the floor.
5. Push the seat upward and fold it
away from the third row.
t o return the seat to a
seating position:
1. Push the seat down and latch
to the floor.
2. Bring the seat back to an upright
position. It should lock into position.
3. Lift up on the head restraint until it
locks into its original position.

Lever 1
Pos. 2
Pos. 3
page 11 page 10* if equipped