garage door opener FORD EXPLORER 2004 3.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 2004, Model line: EXPLORER, Model: FORD EXPLORER 2004 3.GPages: 296, PDF Size: 5.77 MB
Page 50 of 296
Installing a garage door opener (if equipped)
The storage compartment can be converted to accommodate a variety of
aftermarket garage door openers:
•Place the Velcro hook onto the
side of the aftermarket
transmitter opposite of the
button.
•Place the transmitter into storage
compartment, button down.
•Place the provided height
adaptors onto the back of the
door as needed.
•Close the door.
•Press the depression in the door
to activate the transmitter.
Automatic dimming rear view mirror
The automatic dimming mirror is
equipped with an automatic
dimming feature. This feature will
change from the normal state to the
non-glare “active” state when bright
lights (glare) reach the mirror.
When the mirror detects bright light
from behind, it will adjust automatically to minimize glare.
The mirror will automatically return to the normal high reflective state
whenever the vehicle is placed in R (Reverse) (when the mirror is in the
ON position). This helps to ensure a bright clear view in the mirror when
backing up.
2004 Explorer(exp)
Owners Guide (post-2002-fmt)
USA English(fus)
Driver Controls
50
Page 60 of 296
Do not let children play with the moon roof. They may seriously
hurt themselves.
HOMELINKWIRELESS CONTROL SYSTEM (IF EQUIPPED)
The HomeLinkWireless Control System, located on the overhead
console, provides a convenient way to replace up to three hand-held
transmitters with a single built-in device. This feature will learn the radio
frequency codes of most current transmitters to operate garage doors,
entry gate operators, security systems, entry door locks, and home or
office lighting.
When programming your HomeLinkWireless Control System to
a garage door or gate, be sure that people and objects are out of
the way to prevent potential harm or damage.
Do not use the HomeLinkWireless Control System with any garage
door opener that lacks safety stop and reverse features as required by
U.S. federal safety standards (this includes any garage door opener
model manufactured before April 1, 1982). A garage door which cannot
detect an object, signaling the door to stop and reverse, does not meet
current U.S. federal safety standards. For more information, contact
HomeLinkat:www.homelink.comor1–800–355–3515.
Retain the original transmitter for use in other vehicles as well as for
future programming procedures (i.e. new HomeLinkequipped vehicle
purchase). It is also suggested that upon the sale of the vehicle, the
programmed Homelinkbuttons be erased for security purposes, refer to
Programmingin this section.
Programming
Do not program HomeLinkwith the vehicle parked in the garage.
Note:Some vehicles may require the ignition switch to be turned to the
second (or “ACC”) position for programming and/or operation of the
HomeLink. It is also recommended that a new battery be placed in the
hand-held transmitter of the device being programmed to HomeLinkfor
quicker training and accurate transmission of the radio-frequency signal.
2004 Explorer(exp)
Owners Guide (post-2002-fmt)
USA English(fus)
Driver Controls
60
Page 61 of 296
1. Press and hold the two outside
buttons releasing only when the red
light begins to flash after 20
seconds.Do notrepeat step one to
program additional hand-held
transmitters to the remaining two
HomeLinkbuttons. This will erase
previously programmed hand-held
transmitter signals into HomeLink.
2. Position the end of your
hand-held transmitter 2–8 cm (1–3
inches) away from the HomeLinkbutton you wish to program (located
on your overhead console) while keeping the red light in view.
3. Simultaneously press and hold
both the HomeLinkand hand-held
transmitter button.Do not release
the buttons until step 4 has been
completed.
Some entry gates and garage door
openers may require you to replace
step 3 with procedures noted in the
“Gate Operator and Canadian
Programming” section for Canadian
residents.
4. The red light will flash slowly and then rapidly. Release both buttons
when the red light flashes rapidly. (The rapid flashing light indicates
acceptance of the hand-held transmitters’ radio frequency signals.)
5. Press and hold the just-trained HomeLinkbutton and observe the red
light. If the light is a constant red, programming is complete and your
device should activate when the HomeLinkbutton is pressed and
released.Note:To program the remaining two HomeLinkbuttons,
begin with step 2 in the “Programming” section —do notrepeat step 1.
Note:If the red light blinks rapidly for two seconds and then turns to a
continuous red, proceed with steps 6 through 8 to complete
programming of a rolling code equipped device.
6. At the garage door opener receiver (motor-head unit) in the garage,
locate the “learn” or “smart” button (usually near where the hanging
antenna wire is attached to the unit).
7. Press and release the “learn” or “smart” button. (The name and color
of the button may vary by manufacturer.)
2004 Explorer(exp)
Owners Guide (post-2002-fmt)
USA English(fus)
Driver Controls
61
Page 62 of 296
Note:There are 30 seconds in which to initiate step eight.
8. Return to the vehicle and firmly press, hold for two seconds and
release the HomeLinkbutton. Repeat the press/hold/release sequence
again, and, depending on the brand of the garage door opener (or other
rolling code equipped device), repeat this sequence a third time to
complete the programming.
HomeLinkshould now activate your rolling code equipped device. To
program additional HomeLinkbuttons begin with step 2 in the
“Programming” section. For questions or comments, please contact
HomeLink atwww.homelink.comor1–800–355–3515.
Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLinkto accept the signal
from the hand-held transmitter.
After completing steps 1 and 2
outlined in the“Programming”
section, replace step 3 with the
following:
Note:If programming a garage door opener or gate operator, it is
advised to unplug the device during the “cycling” process to prevent
overheating.
•Continue to press and hold the HomeLinkbutton (note step 3 in the
“Programming” section) while you press and release —every two
seconds(“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink. The red indicator light
will flash slowly and then rapidly after HomeLinkaccepts the radio
frequency signal.
•Proceed with step 4 in the “Programming” section.
2004 Explorer(exp)
Owners Guide (post-2002-fmt)
USA English(fus)
Driver Controls
62
Page 287 of 296
coolant .....................................236
fail-safe coolant ......................240
idle speed control ...................234
lubrication
specifications ..................274, 276
refill capacities ........................272
service points ..................227–228
starting after a collision .........182
Engine block heater .................140
Engine oil ..................................229
checking and adding ..............229
dipstick ....................................229
filter, specifications ........233, 271
recommendations ...................233
refill capacities ........................272
specifications ..................274, 276
Exhaust fumes ..........................140
F
Fail safe cooling ........................240
Flexible Fuel Vehicle (FFV) ....242
Floor mats ...................................77
Fluid capacities .........................272
Foglamps .....................................37
Four-Wheel Drive vehicles .......153
driving off road ...............155, 163
indicator light .........................154
preparing to drive your
vehicle .....................................146
Fuel ............................................242
calculating fuel
economy
............................68, 248
cap ...........................................246
capacity ...................................272
choosing the right fuel ...........244
comparisons with EPA fuel
economy estimates .................251
detergent in fuel .....................246filling your vehicle
with fuel ..................242, 246, 248
filter, specifications ........247, 271
fuel pump shut-off
switch ......................................182
improving fuel economy ........248
octane rating ...........245, 276–277
quality ......................................245
running out of fuel .................246
safety information relating to
automotive fuels .....................242
Fuel - flex fuel vehicle
(FFV) .........................242, 244–245
Fuses ..................................183, 185
G
Garage door opener ....................50
Garage Door Opener
(see Homelink wireless control
system) ........................................60
Gas cap
(see Fuel cap) ...........................246
Gas mileage
(see Fuel economy) .................248
Gauges .........................................15
GAWR
(Gross Axle Weight Rating)
calculating ...............................174
GVWR
(Gross Vehicle Weight Rating)
calculating ...............................174
H
Hazard flashers .........................182
Head restraints ...........................94
Headlamps
aiming ........................................39
2004 Explorer(exp)
Owners Guide (post-2002-fmt)
USA English(fus)
Index
287
Page 288 of 296
bulb specifications ....................41
daytime running lights .............37
flash to pass ..............................38
high beam .................................38
Heating
heating and air conditioning
system .................................31–32
HomeLink universal
transceiver
(see Garage door opener) .........63
Homelink wireless control
system ..........................................60
Hood ..........................................226
I
Ignition .......................137, 276–277
Infant seats
(see Safety seats) .....................127
Inspection/maintenance (I/M)
testing ........................................253
Instrument panel
cleaning ...................................222
cluster ........................................10
J
Jack ....................................194, 197
positioning .......................194, 199
storage .............................194, 197
Jump-starting your
vehicle ........................................203
K
Keyless entry system .................87
autolock .....................................89
Keys
positions of the ignition .........137L
Lamps
bulb replacement
specifications chart ..................41
daytime running light ...............37
fog lamps ...................................37
high beams ................................38
instrument panel,
dimming .....................................38
interior lamps ...........................40
Liftgate ..................................77, 83
Lights, warning and
indicator ......................................10
anti-lock brakes (ABS) ..........141
Limited-slip axle .......................153
Load limits .................................171
Loading instructions .................174
Locks
autolock .....................................89
childproof ..................................82
doors ..........................................81
Lubricant
specifications .....................274, 276
Lumbar support, seats ...............98
M
Message center ...........................66
english/metric button ...............71
system check button ................71
warning messages .....................72
Mirrors .........................................51
automatic dimming rearview
mirror ........................................50
fold away ...................................53
heated ........................................53
side view mirrors (power) .......53
Moon roof ....................................59
2004 Explorer(exp)
Owners Guide (post-2002-fmt)
USA English(fus)
Index
288