jump cable FORD EXPLORER 2010 4.G Owners Manual

Preparing your vehicle
When the battery is disconnected or a new battery is installed, the
automatic transmission must relearn its shift strategy. As a result, the
transmission may have firm and/or soft shifts. This operation is
considered normal and will not affect function or durability of the
transmission. Over time, the adaptive learning process will fully update
transmission operation.
1.Use only a 12–volt supply to start your vehicle.
2. Do not disconnect the battery of the disabled vehicle as this could
damage the vehicle’s electrical system.
3. Park the booster vehicle close to the hood of the disabled vehicle
making sure the two vehiclesdo nottouch. Set the parking brake on
both vehicles and stay clear of the engine cooling fan and other moving
parts.
4. Check all battery terminals and remove any excessive corrosion before
you attach the battery cables. Ensure that vent caps are tight and level.
5. Turn the heater fan on in both vehicles to protect from any electrical
surges. Turn all other accessories off.
Connecting the jumper cables
1. Connect the positive (+) jumper cable to the positive (+) terminal of
the discharged battery.
Note:In the illustrations,lightning boltsare used to designate the
assisting (boosting) battery.
+–+–
Roadside Emergencies
326
2010 Explorer(exp)
Owners Guide(own2002), 1st Printing
USA(fus)

4. Make the final connection of the negative (-) cable to the ground stud
located toward the front of the vehicle (forward of the battery) on the
radiator support. Keep the negative (-) cable away from the battery and
the carburetor/fuel injection system.
Note:Do not attach the negative (-) cable fuel lines, engine rocker
covers, the intake manifold or electrical components asgrounding
points.
WARNING:Do not connect the end of the second cable to the
negative (-) terminal of the battery to be jumped. A spark may
cause an explosion of the gases that surround the battery.
5. Ensure that the cables are clear of fan blades, belts, moving parts of
both engines, or any fuel delivery system parts.
++-
-
Roadside Emergencies
328
2010 Explorer(exp)
Owners Guide(own2002), 1st Printing
USA(fus)

Jump starting
1. Start the engine of the booster vehicle and run the engine at
moderately increased speed.
2. Start the engine of the disabled vehicle.
3. Once the disabled vehicle has been started, run both engines for an
additional three minutes before disconnecting the jumper cables.
Removing the jumper cables
Remove the jumper cables in the reverse order that they were
connected.
1. Remove the jumper cable from thegroundmetal surface.
2. Remove the jumper cable on the negative (-) connection of the
booster vehicle’s battery.
3. Remove the jumper cable from the positive (+) terminal of the booster
vehicle’s battery.
+–+–
+–+–
Roadside Emergencies
329
2010 Explorer(exp)
Owners Guide(own2002), 1st Printing
USA(fus)

4. Remove the jumper cable from the positive (+) terminal of the
disabled vehicle’s battery.
After the disabled vehicle has been started and the jumper cables
removed, allow it to idle for several minutes so the engine computer can
relearn its idle conditions.
+–+–
Roadside Emergencies
330
2010 Explorer(exp)
Owners Guide(own2002), 1st Printing
USA(fus)

SecuriCode keyless entry
system ........................................161
SecuriLock passive anti-theft
system ........................................162
Setting the clock
AM/FM single CD .....................45
AM/FM/In-dash 6 CD ................52
Snowplowing .................................6
SOS Post Crash Alert ...............213
Spark plugs,
specifications .....................384, 390
Special notice
ambulance conversions ..............6
utility-type vehicles ....................6
Specification chart,
lubricants ...................................385
Speed control ............................128
Starting your
vehicle ........................270–271, 273
jump starting ..........................325
Steering wheel
controls ....................................130
tilting .......................................118
SYNC
..........................................98
T
Third-row power fold seat .......182
Tilt steering wheel ....................118
Tire Pressure Monitoring
System (TPMS)
Driving .....................................300
Roadside Emergencies ...........315
Tires, Wheels and Loading ....250
Warning Displays ..........12, 27, 36
Tires ...........................235–237, 315
alignment ................................244care ..........................................240
changing ..........................315, 320
checking the pressure ............240
inflating ...................................238
label .........................................249
replacing ..........................241, 320
rotating ....................................244
safety practices .......................243
sidewall information ...............245
snow tires and cables .............255
spare tire .................315, 318–319
terminology .............................237
tire grades ...............................236
treadwear ........................236, 240
Towing .......................................263
recreational towing .................268
trailer towing ..........................263
wrecker ....................................331
Transfer case
fluid checking .........................381
Transmission .............................286
brake-shift interlock (BSI) ....285
fluid, checking and adding
(automatic) .............................380
fluid, refill capacities ..............385
lubricant specifications ..........385
Turn signal ................................110
U
Universal garage door
opener ........................................133
USB port ......................................60
V
Vehicle Identification Number
(VIN) ..........................................391
Vehicle loading ..........................255
Ventilating your vehicle ...........273
Index
403
2010 Explorer(exp)
Owners Guide(own2002), 1st Printing
USA(fus)