hood release FORD EXPLORER SPORT TRAC 2005 1.G Quick Reference Guide

4X4 LOW uses extra gearing to provide
maximum power to all four wheels.
To shift between 2WD and 4X4 HIGH: Turn
the control between the 2WD and the 4X4
HIGH position at any forward speed, as long
as the rear wheels are NOT slipping.
To shift to or from 4X4 LOW: Bring the
vehicle to a complete stop. Press the brake.Place the gearshift in N (Neutral), and then
turn the control to the desired position.
Premium Dual Media Radio (if equipped)
Please see reverse side for more details.
In Dash SixCD Radio (if equipped)
Please see reverse side for more details.
Power Down Back Window Control
Turn counterclockwise and release to lower
the window to the fullopen position. Turn
the control clockwise and release to raise the
window to the fullclosed position. Press onceto move the window (up or down) to the
vent position. If the window is already in the
vent position and the control is pressed, no
movement will occur.
To operate the power down back window,
the ignition switch must be in the ON or ACC
position. All rearseat occupants and/or cargo
must be properly restrained and clear of the
back window opening before operating the
power down back window.
Climate Control System
Please see reverse side for more details.
Speed Control (if equipped)
To operate, the speed
control must be ON and the
vehicle’s speed must be at or
above 30 mph (48 km/h). To
set a speed, press SET ACC.
To set a higher speed, press
SET ACC again. To set a lower
speed, press COAST. Pressing
RSM will return to a previously
set speed. To turn the speed
control off, press the OFF button or
turn off the vehicle’s ignition. Press
the brake pedal to disengage.
Hood Release
Inside the vehicle, pull the hood release
handle under the bottom of the instrument
panel near the steering column. Next, release
the auxiliary latch located in the centerbetween the hood and the grille. Lift the
hood and secure it with the prop rod.
Turn Turn Signal and Wiper/Washer Control
Rotate the end
of the control
to increase or
decrease the speed of the wipers.
When the wiper control is on, the speed of the wipers will automatically adjust with the
vehicle’s speed. Push the control on the end of the lever briefly for a single wipe (no wash).
Push and hold for three wipes with a wash. A long push and hold will activate a longerwash cycle (up to ten seconds).
The Explorer Sport Trac is also equipped
with a rear window wiper and washer control,
located to the right of your audio system. Turn
the control clockwise to the desired interval
speed. Press to activate the washer fluid.
For extended wiper blade quality, occasional
cleaning of the wiper blades is required.
8
9
10
11
12
13
14

Headlamp/Panel
Dimmer Control Check
Engine
Lamp ABS
Warning Lamp Over
Hood
Release Turn Signal
and Wiper/Washer
Control
Hazard
Flasher
Control
2
34
12
1314
5
Park Brake
Release