ignition FORD F150 2001 10.G Rear Seat Entertainment System Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 2001, Model line: F150, Model: FORD F150 2001 10.GPages: 24, PDF Size: 0.19 MB
Page 12 of 24
Press the speaker control to enter into DUAL PLAY. The rear speakers
will turn off and the rear seat passengers will enter into headphone
mode. They are able to listen to their selected media source via
headphones and control the volume level. While DUAL PLAY is engaged,
the front seat passengers can listen to the desired media source through
the radio speakers.
4.VOLUMEbuttons
Press (+) or (þ) button to decrease or increase audio volume. When
ignition is turned ON, volume defaults to LOW. In SINGLE PLAY mode,
the volume level can be changed in all media sources. However, the rear
seat passengers cannot exceed the volume level set by the front seat
passengers. In DUAL PLAY mode, only headphone volume level may be
changed.
5.MEDIAbutton
Press to toggle between the following media sources: AM, FM1, FM2,
TAPE, CD, CDDJ, VCP and AUX. When chosen, the media source will
illuminate in the radio display.
When the Rear Seat Entertainment System (RSES) is in dual play mode,
the selected media source will illuminate in the radio display. The letters
RSC will appear in front of the selected mode. ªRSCº indicates ªRear
Seat Controlº and identifies the mode as being used by the rear seat
passengers.
Note:While in dual play mode, both AM and FM media sources cannot
be selected simultaneously. A selected radio station will be shared by
front and rear seat passengers.
6.MEM
Press in radio mode to scroll through the memory presets in AM, FM1 or
FM2.
Press in CDDJ mode to select the next disc in the compact disc changer.
The memory function does not operate in TAPE, CD, VCP or AUX
modes.
7.SEEKbuttons
Press to find the next or previous listenable radio station, tape selection
or CD track (depending on the mode).
Description
12
Page 14 of 24
GENERAL OPERATION
²When the engine is not running, use the system sparingly otherwise it
will run the battery down.
²
When the ignition is turned to OFF, the Rear Seat Entertainment System
(RSES) is also turned OFF. When the ignition is turned ON, the RSES
returns to SINGLE PLAY mode and the last media position. To play a
video tape, toggle the MEDIA control on the RSEM to VCP mode.
²Do not leave the videocassette in the videocassette player (VCP)
overnight or for long periods of time.
²To listen through the vehicle's speaker system, press the speaker
button (
/) on the Rear Seat Entertainment Module (RSEM).
When the ignition is turned ON, audio is through the headphones at
LOW volume. Press the (+) control to increase volume.
²
To enable or disable the RSES, simultaneously press the 3 and 5 memory
presets on the radio face. When the RSEM controls are enabled,
will
appear in the radio display. Press the presets again to disable the RSES.
Inserting/removing cassette
Inserting cassette
²Open the center console cover. Insert a videocassette into the cassette
compartment.
Inserting a videocassette into the VCP automatically turns the power ON
and the tape should begin playback if the tape is an autoplay videocasette
tape (recording protection tabs are removed).
The tape counter is automatically reset to 0:00:00.
If the vehicle is traveling over rough terrain, it may be difficult to insert
the cassette because the machine attempts to hold the cassette firmly to
prevent vibration. If this condition is encountered, either press firmly or
Operating Instructions
14
Page 24 of 24
TROUBLESHOOTING
Use the following troubleshooting chart to remedy symptoms you may
experience. If the problem is not readily corrected, consult your Ford,
Lincoln-Mercury dealer.
Symptom Possible Cause Solution
No power supply.
Ignition ON, power
indicator light is OFF.
Power line
disconnected, shorted
or damaged. Blown fuseContact your local Ford
Lincoln-Mercury dealer.
VCP does not operate.
Power button is blinking
green.Machine is dewed
inside. Protection
circuit is operating.Wait until VCP
becomes dry inside.
May take several hours.
VCP does not operate.
Power button is blinking
red.Temperature too high.
Temperature protection
circuit is operating.Wait until vehicle cabin
temperature cools
down.
VCP does not operate.
Power button is blinking
orange.Over voltage situation
has occurred from
vehicle's electrical
systemTake your vehicle in for
service as soon as
possible to your local
Ford and Lincoln
Mercury Dealer.
Function indicators do not
disappear from screen.Incorrect display mode.Press the DISPLAY
button on remote control.
Video9noise9
(distortion) in playback.Abnormal tracking. If
noise appears at same
part of the tape all the
time, the tape is likely
damaged.Press AUTO button on
remote control to
cancel automatic
tracking. Manually
adjust (+) (þ)
TRACKING buttons.
Still picture fluctuates
up and down.Incorrect vertical hold
adjustment.Press AUTO button on
remote control to
cancel automatic
tracking. Manually
adjust (+) (þ)
TRACKING buttons.
Playback picture rough
or frosted.Dirty VCP heads. Clean heads with head
cleaning cassette.
No video playback on
screen.RSES not in VCP
mode.Press MEDIA button.
OBTAINING A FRENCH SUPPLEMENT
French supplements can be obtained from your dealer or by writing to
Ford Motor Company of Canada, Limited, Service Publications, P.O. Box
1580, Station B, Mississauga, Ontario L4Y 4G3.
Troubleshooting
24