ignition FORD F650 2000 10.G Owner's Guide

Fuse/Relay
LocationFuse Amp
RatingPower Distribution Box Description
7 15A* Stop Lamps
8 25A* C AT Fuel Heater
9—Not Used
10 15A* Shift Modulator (Allison AT trans only)
11 20A* Allison MD Trans
12—Not Used
13—Not Used
14—Not Used
15 7.5A*
Body Builder Prep (Hydraulic Vehicles Only)
16—Not Used
17—Not Used
18—Not Used
19—Not Used
20—Not Used
21 10A* GEM (Hydraulic Vehicles Only)
22—Not Used
23—Not Used
24—Not Used
101 40A** ABS (Air Only)
102 20A** Body Builder Prep Run Feed
103 50A** Ignition Switch (JB fuses 8, 9, 11, 19, 20,
22, 23, 24, 25, 29, 30, 31)
104 20A** Power Point
105 20A** Power Door Locks
106 30A** Headlamps
107 50A** Junction Box Battery Feed (fuses 1, 2, 3, 4,
12, 13, 14, 15)
108 40A** Cummins Fuel Heater
109 40A** Power Windows
110—Not Used
111 30A** Body Builder Prep
Roadside emergencies
120

Fuse/Relay
LocationFuse Amp
RatingPower Distribution Box Description
112 40A** Blower Motor
113—Not Used
114—Not Used
115 40A** Ignition Switch (JB fuses 5, 8, 9, 11, 21)
116 30A** Body Builder Prep
117 20A** 7.3L Power Stroke PCM
118 30A** IDM (7.3L Power Stroke only)
119
12060A** Hydraulic ABS
121
12260A** Hydromax Motor
201—Washer Pump Relay
202—Wiper Speed Relay
203—Wiper Run/Park Relay
204—Cummins VP44 Relay/7.3L Power Stroke
Neutral Start Relay
205—Right Hand Stop/Turn Relay
206—Left Hand Stop/Turn Relay
207—Shift Modulator Relay
208—Backup Lamps Relay
209—Stop Lamps Relay
301—Fuel Heater Relay (CAT and Cummins
only)/7.3L Power Stroke PCM Relay
302—Park Lamps Relay
303—Blower Motor Relay
304—Air ABS Relay
401—Not Used
501—Not Used
502—Not Used
503 Diode 7.3L Power Stroke PCM Diode
* Mini Fuses ** Maxi Fuses
Roadside emergencies
121

JUMP STARTING YOUR VEHICLE
The gases around the battery can explode if exposed to flames,
sparks, or lit cigarettes. An explosion could result in injury or
vehicle damage.
Do not push start your vehicle. You could damage the catalytic
converter.
Batteries contain sulfuric acid which burns skin, eyes, and
clothing.
Preparing your vehicle
Also see the label on the battery.
1. Use only a 12–volt supply to start your vehicle. If you connect your
battery to a 24–volt power supply you can damage your starter, ignition
system and other electrical components. Do not attach the jumper cables
to the glow plug relay as this could severely damage the glow plugs,
injector driver module and PCM.
2. Do not disconnect the battery of the disabled vehicle as this could
damage the vehicle’s electrical system.
3. Park the booster vehicle close to the disabled vehicle making sure
theydo nottouch. Set the parking brake on both vehicles and stay clear
of the engine cooling fan and other moving parts.
4. Check all battery terminals and remove any excessive corrosion before
you attach the battery cables.
5. Turn the heater fan on in both vehicles to protect any electrical
surges. Turn all other accessories off.
Roadside emergencies
122

Do not use diesel fuel blended with waste oil in engines equipped with a
catalytic converter-muffler. Blending waste oil in with the fuel will plug
the catalytic converter-muffler, resulting in a significant loss of engine
power. Your emissions warranty will be voided if blending waste oil with
diesel fuel is practiced.
Use low sulfur (less than 0.05% by weight) fuel as required by the EPA
for emission compliance.
Do not mix diesel fuel with gasoline, gasohol or alcohol. This
could cause an explosion resulting in personal injury.
Do not use starting fluid such as ether or gasoline. Such fluids
can cause immediate explosive damage to the engine and
possible personal injury.
Running out of fuel
Avoid running out of fuel as this will allow air to enter the fuel system,
which will make restarting the vehicle difficult.
If you have run out of fuel:
•If your vehicle is equipped with dual fuel tanks,add at least
15–19 liters (4–5 gallons) of fuel to each tank before attempting to
restart the engine.
•If your vehicle is equipped with the Caterpillar 3126 B engine,
the fuel system must be primed before attempting to restart the
engine. Refer to the engine operator’s manual for instructions on
priming the engine.
•Use caution not to overheat and damage the starterby cranking
the engine for an excessive period of time. You may need to crank the
engine for a longer time than normal. If the engine fails to start in 30
seconds, turn the ignition to the OFF position and wait for two
minutes before cranking the engine again.
•Any remaining trapped air will self-purge from the fuel system once
the engine starts running.
•The engine may run rough and produce white smoke while air is in
the fuel system. This is normal and should stop after a short period of
time.
Maintenance and care
153

OWNER MAINTENANCE
You can do much of the maintenance your vehicle requires yourself, if
you have the time and a reasonable amount of mechanical ability. If you
prefer to have this work done professionally, your authorized dealer
stands ready to help you.
All mechanical components and attachments are important in that they
could affect the performance of vital components and systems. If
replacement becomes necessary, they must be replaced with parts having
the same part number or with equivalent parts. Torque values of the
attaching parts must be used as specified during any reassembly
procedure to assure proper retention.
EMISSIONS CONTROL SYSTEM
To assure the emissions control systems operate effectively, you should
have the services listed in the maintenance schedule performed at the
specified time and km/mileage intervals. You should avoid running out of
fuel or turning off the ignition while the vehicle is in motion, especially
at high speeds.
Because of high engine compartment and exhaust system
temperatures resulting from emissions equipment, do not park,
idle or operate your vehicle in dry grass or other dry ground cover
where the possibility of ground fire exists.
Do not make unauthorized modifications to the engine or vehicle.
Modifications causing increased amounts of unburned fuel to reach the
exhaust system can significantly increase the temperature of the engine
compartment and/or the exhaust system.
Avoid driving your vehicle if it does not operate properly. If the engine
diesels (more than five seconds of engine run-on after shut-off), misfires,
surges, stalls or backfires, see your dealer. Be alert for fluid leakage,
odor, smoke, loss of oil pressure, or charge indicator or over temperature
warning.
Do NOT use diesel fuel blended with waste oil in engines equipped with
a CATALYTIC CONVERTER-MUFFLER. Waste lube oil blending in fuel
will plug the CATALYTIC CONVERTER-MUFFLER, resulting in a
significant loss of engine power.
General maintenance information
176

calculating
fuel economy ...................112,157
choosing the right fuel ...........152
filling your vehicle with fuel ..151
filter, specifications .........154,155
gauge .........................................16
improving
fuel economy ...................112,157
safety information relating to
automotive fuels .....................151
Fuses ...................................115,116
Gas mileage
(see Fuel economy) ..........112,157
Gauges .........................................16
battery voltage gauge ...............18
engine coolant
temperature gauge ...................16
engine oil pressure gauge ........19
fuel gauge ..................................16
odometer ...................................17
speedometer .............................17
tachometer ................................18
trip odometer ............................18
Hazard flashers .........................115
Headlamps ...................................20
aiming ......................................163
daytime running lights .............20
flash to pass ..............................50
high beam ............................12,50
turning on and off ....................20
warning chime ..........................15
Heating ........................................21
heater only system ...................21
heating and
air conditioning system ............23
Hood ..........................................126
Ignition
positions of the ignition ...........49
removing the key ....................101
Infant seats
(see Safety seats) ..................72,73Instrument panel
cleaning ...................................166
cluster ......................................167
lighting up
panel and interior .....................20
location of components ............10
Jump-starting your vehicle ......125
Keys
key in ignition chime ...............15
positions of the ignition ...........49
removing from the ignition ....101
Lamps
cargo lamps ...............................20
daytime running light ...............20
headlamps .................................20
headlamps, flash to pass ..........50
instrument panel, dimming .....20
replacing bulbs ..159,160,161,162
Lane change indicator
(see Turn signal) ........................49
Lights, warning and indicator ....10
anti-lock brakes (ABS) .......12,83
brake .....................................10,11
charging system ........................10
check coolant ............................14
high beam .................................12
safety belt .................................14
service engine soon ..................14
turn signal indicator .................12
Lubricant specifications ...........169
Maintenance and Care ..............179
Manual transmission ...................97
Mirrors .........................................57
Odometer .....................................17
Parking brake ....................85,87,90
Power distribution box
(see Fuses) ...............................119
Power door locks ........................56
Power steering .......................95,96
fluid, checking and adding ....136
Radio ............................................26
Refill capacities for fluids ........168
Index
206