technical specifications FORD FIESTA 2007 Workshop Manual

Handles, Locks, Latches and Entry Systems 501-14
Wipers and Washers 501-16
Bumpers 501-19
Safety Belt System 50
I -20A
Supplemental Restraint
System 501 -20B
Body Repairs
- General
Information 501 -25
Body Repairs
- Vehicle Specific
lnformation and Tolerance
Checks 501 -26
To the best of our knowledge, the illustrations,
technical information, data and descriptions in
this issue were correct at the time of going to
print. The right to change prices, specifications,
equipment and maintenance instructions at
any time without notice is reserved as part of
FORD policy of continuous development and
improvement for the benefit of our customers.
No part of this publication may be reproduced,
stored in a data processing system or
transmitted in any form, electronic, mechanical,
photocopy, recording, translation or by any
other means without prior permission of
Ford-Werke Aktiengesellschaft. No liability can
be accepted for any inaccuracies in this
publication, although every possible care has
been taken to make it as complete and
accurate as possible.
Copyright
O
FORD-WERKE AKTIENGESELLSCHAFT
Service training programs D-FIGT-1
Printed in Germany
- rewi druckhaus, Wissen -
Printed on environmentally friendly
chlorine-free paper. (GB) Front End Sheet Metal Repairs
50 1 -27
Roof Sheet Metal Repairs 50 1 -28
Side Panel Sheet Metal Repairs 501 -29
Rear End Sheet Metal Repairs 501
-30
Paint
- General Information 501
-36
Frame and Mounting
Uni-Body, Subframe and Mounting
System 502-00
0512005 2006.0 Fiesta
procarmanuals.com

100-00-4 General Information 100=00=4
DESCRIPTION AND OPERATION
lnspection and Verification
Visual lnspection Charts, Symptom Charts and
other information charts (such as diagnostic
routines) or supplement test procedures with
technical specifications will navigate the user to a
specific test procedure.
Symptom Chart
The symptom chart indicates symptoms, sources
and actions to address a condition.
Item
1
2
3
4
5
6
7
8
9
10
Pinpoint Tests
For electrical systems, pinpoint test steps are used
to identify the source of a concern in a logical,
step-by-step manner. pinpoint tests have two
columns: CONDITIONS and
DETAILSIRESULTSIACTIONS.
Designation
Special tool
Install new component
l nspect
Apply sealant
Apply petroleum jelly Apply oil
Apply fluid
Apply grease
Removal or Disassembly
detail
Installation or Assembly
detail
The CONDITIONS column is used exclusively for
graphics and icons (with or without captions) and
the
DETAILSIRESULTSIACTIONS column
provides direction to another test step or specific
corrective actions.
The boxed numbers indicate the order in which the
described action is to be performed.
Description
A special tool is required for this component. There will also
be a removal or installation symbol alongside the special
tool symbol.
Discard the old component and install a new component.
Check the component for damage.
Apply sealant to the component as specified in the mate-
rials table.
Apply petroleum jelly to the component as specified in the
materials table.
Apply oil to the component as specified in the materials table.
Apply fluid to the component as specified in the materials
table.
Apply grease to the component as specified in the mate-rials
table.
Go to the removal or disassembly detail for additional
information to remove or disassemble a component
Go to the installation or assembly detail for additional
information to install or assemble a component
2006.0 Fiesta 1212006 GI 7371 en
procarmanuals.com