engine FORD FIESTA 2013 6.G Quick Reference Guide
[x] Cancel search | Manufacturer: FORD, Model Year: 2013, Model line: FIESTA, Model: FORD FIESTA 2013 6.GPages: 8, PDF Size: 2.57 MB
Page 3 of 8

INStrumENt PaNEl5
1. Media Steering
Wheel ControlS*
(Volume): Press to increase (+)
or decrease (-) volume levels.
Press to access voice recognition.
Press to answer an
incoming call.
Press to exit phone mode or
end a call.
Press OK to confirm messages
and selections.
2. tilt/teleSC ope
Steering Colu Mn
Unlock the steering wheel by
pulling the lever down. Adjust the wheel to the desired position. Push the lever back up to lock the steering wheel in place.
3. ServiCe engine Soon light
Illuminates briefly when
the ignition is turned on. If it remains on or is blinking after the engine is started, the on-board diagnostics system (OBD-II) has detected a malfunction. Drive in a
moderate fashion and contact your
authorized dealer as soon as possible.
4. inforMation diSplayS
Provides information about various
systems on your vehicle. Use the trip
computer lever, on the left-hand side of
the steering wheel to scroll through and
choose trip computer functions. Refer to
the Information Displays chapter of your
Owner’s Manual for more information.
5. CruiSe Control*
To set your cruise control speed:
1. Press the ON control and release.
2. Accelerate to the desired speed.
3. Press the SET + control and
release, then take your foot off
the accelerator.
After your speed has been set, you
can press SET +/ SET - to adjust your
cruise speed. To disable, press the
OFF control.
6. Wiper ControlS
Pull the stalk down for a single wipe.
Raise the stalk upward for intermittent
wipe mode. Adjust the intermittent
wipe intervals by using the rotary
control on the stalk. To spray and wash
the windshield, press the end of the
wiper stalk in, the wipers will operate for
a short time after. To operate the rear
wipers pull the stalk toward you.
7. puSh Button Start*
Allows you to start your vehicle by
pressing the ENGINE START/STOP
button while fully pressing down on the
brake pedal. Press the button again to
turn the engine off.
NOTE: Your intelligent access key*
must be inside the vehicle for keyless
starting to work.
8. infotainMent Center
Use your center stack controls to
interact with SYNC* as well as your
audio and vehicle settings. SYNC and
entertainment messages as well as your
settings will appear in the infotainment
screen. Press OK to confirm messages.
9. l oCk/unloCk Button
Lights up when all doors and trunk are
locked. When the button remains unlit,
one or more doors are unlocked.
* if equipped
1
2
3
5
6
8
9
7
4