wheel FORD FLEX 2010 1.G Manual PDF

FORD FLEX 2010 1.G Manual PDF FLEX 2010 1.G FORD FORD https://www.carmanualsonline.info/img/11/5106/w960_5106-0.png FORD FLEX 2010 1.G Manual PDF

Page 296 of 397

FORD FLEX 2010 1.G Manual PDF Passenger compartment fuse panel
The fuse panel is located under the instrument panel to the left of the
steering wheel.
The fuses are coded as follows.
Fuse/Relay
LocationFuse Amp
RatingProtected Cir

Page 297 of 397

FORD FLEX 2010 1.G Manual PDF Fuse/Relay
LocationFuse Amp
RatingProtected Circuits
8 10A Low beam headlamps (right)
9 15A Interior lights, Cargo lamps
10 15A Backlighting, Puddle lamps
11 10A All wheel drive (AWD)
12 7.5A Not used

Page 302 of 397

FORD FLEX 2010 1.G Manual PDF Fuse/Relay
LocationFuse Amp
RatingProtected Circuits
64 HC micro relay PCM
65 G8VA relay A/C clutch
66 G8VA relay Fuel pump
* Cartridge Fuses ** Mini Fuses
CHANGING THE TIRES
If you get a flat tire wh

Page 303 of 397

FORD FLEX 2010 1.G Manual PDF replace it as soon as possible with a road tire/wheel that is the same size
and type as the road tires and wheels that were originally provided by
Ford. If the dissimilar spare tire or wheel is damage

Page 304 of 397

FORD FLEX 2010 1.G Manual PDF •Use snow chains on the end of the vehicle with the dissimilar spare
tire/wheel
The usage of a full-size dissimilar spare tire/wheel can lead to
impairment of the following:
•Handling, stability a

Page 305 of 397

FORD FLEX 2010 1.G Manual PDF 1. Remove the carpeted floor panel
located in the rear of the vehicle,
remove the wing nut that secures
the spare tire by turning it
counterclockwise.
2. Lift and remove the spare tire
from the trunk.

Page 306 of 397

FORD FLEX 2010 1.G Manual PDF 1. Block the diagonally opposite
wheel.
2. Remove wheel cover (if
equipped) with the lug wrench tip
and loosen each wheel lug nut
one-half turn counterclockwise but
do not remove them until the wheel

Page 307 of 397

FORD FLEX 2010 1.G Manual PDF 7. Remove the jack and fully tighten
the lug nuts in the order shown.
Refer toWheel lug nut torque
specificationslater in this chapter
for the proper lug nut torque
specification.
8. Install the wheel

Page 308 of 397

FORD FLEX 2010 1.G Manual PDF 4. Insert the straight end of the jack
retention bracket through the eyelet
of the angled bracket and swing the
retention bracket over the jack. With
the jack in place, place the looped
end of the ret

Page 311 of 397

FORD FLEX 2010 1.G Manual PDF •Read the information in theTips for use of the temporary mobility
kitsection to ensure safe operation of the temporary mobility kit and
your vehicle.
Tips for use of the temporary mobility kit
Read