brake FORD FOCUS 2015 3.G ST Supplement Manual

•2.0L GTDI EcoBoost I4 engine.
•Overboost function for increasedtorque.
•Electronic over-rev function with 6800RPM redline.
•ST-tuned 2.5 in (63.5 mm) center exitexhaust system.
•Getrag-Ford MMT6 6-speed manualtransaxle.
•Active sound symposer.
•Modified front suspension knuckle forimproved wheel end geometry.
•Cast rear knuckle (improved stiffness)and alternative anti-roll-bar mountingfor improved efficiency.
•ST-tuned springs and dampers.
•Increased diameter (13 in (335 mm))front brake rotors and unique caliperswith ST tuned pad formulation frontand rear.
•Enhanced torque vectoring control withcornering understeer control.
•ST-tuned electric power assistedsteering with torque steercompensation.
•AdvanceTrac® stability enhancementsystem with three modes: Normal,Sport and Disabled.
•20 in (45.7 cm) x 7.99 in (20.3 cm),2.17 in (55 mm) offset aluminum STwheels.
•P235/40-18 directional GoodyearEagle F1 summer only performancetires (standard).
5Focus (CDH), enUSA, First PrintingAt a GlanceE194501

MANUAL TRANSMISSION
Using the Clutch
Note:During each shift, you must fully pressthe clutch pedal to the floor and fullyrelease the accelerator. Failure to followthis may cause increased shift efforts,prematurely wear transmissioncomponents, or cause gear clash or damageto the transmission. Make sure you properlyposition the floor mat so it does not interferewith the full extension of the clutch pedal.
Note:If you attempt to shift when the drivewheels are spinning with a loss of traction,it is possible to cause damage to thetransmission. Do not attempt to shift whenthe drive wheels do not have traction.
Note:Do not drive with your foot resting onthe clutch pedal or use the clutch pedal tohold your vehicle at a standstill whilewaiting on a hill. These actions will reducethe life of the clutch.
Your vehicle has a twin disc clutch. Due tothe high performance of the powertrain, acertain amount of noise from thetransmission is normal.
The manual transmission has a starterinterlock that prevents cranking the engineunless you fully press the clutch pedal.
To start the vehicle:
1.Make sure the parking brake is fully set.
2.Press the clutch pedal to the floor, thenput the transmission in neutral (N).
3.Start the engine, then press the brakepedal and release the parking brake.
4.Move the transmission to position 1 ,then slowly release the clutch pedalwhile slowly pressing on theaccelerator.
5.To reverse, lift up on the reverselockout ring found under the shift knoband move the transmission fully to theleft and forward.
Recommended Shift Speeds forMaximum Fuel Economy
When accelerating, upshift according tothe following chart:
Shift from:
12 mph (19 km/h)1-2
23 mph (37 km/h)2-3
32 mph (51 km/h)3-4
41 mph (66 km/h)4-5
42 mph (67 km/h)5-6
Operating at High Speeds
Your ST vehicle is capable of high speedsand has tires rated for the vehicle’smaximum speed. Remember to drivesafely, obey all traffic laws and onlyoperate your ST vehicle at high speeds atlocations equipped and designed to do sosafely.
11Focus (CDH), enUSA, First PrintingTransmissionE144954

Enhanced Torque VectoringControl
Enhanced torque vectoring control iscomprised of two elements:
•Torque vectoring control, which appliesbrake torque on the inner wheel in acurve for better traction and lessundersteer.
•Cornering understeer control whichcontrols the yaw response of thevehicle under braking and accelerationon high and low friction surfaces.
Unlike electronic stability control,enhanced torque vectoring control doesnot slow the vehicle. It helps controlexcessive wheel slip and gives the vehiclecornering agility. The system only increasesperformance. Because of this, the systemdoes not disable enhanced torquevectoring control when the AdvanceTrac®system is off.
14Focus (CDH), enUSA, First PrintingStability Control

UNDER HOOD OVERVIEW - 2.0L ECOBOOST™
Engine coolant reservoir.A
Engine oil dipstick.B
Engine oil filler cap.C
Brake fluid and clutch fluid reservoir.D
Battery.E
Engine compartment fuse box.F
Engine air cleaner.G
Washer fluid reservoir.H
17Focus (CDH), enUSA, First PrintingMaintenanceE180866

Capacities
CapacityItem
5.7 qt (5.4 L)Engine oil
5.3 qt (5.0 L)Engine coolant
Between MIN and MAX on brake fluid reservoirBrake fluid
1.8 qt (1.7 L)*Manual transmission fluid
* Approximate dry fill capacity. Actual amount may vary during fluid changes.
Specifications
Materials
SpecificationName
WSS-M2C946-ARecommended motor oil (U.S.):Motorcraft SAE 5W-30 Premium Synthetic BlendMotor OilXO-5W30-QSP
WSS-M2C946-ARecommended motor oil (Canada):Motorcraft SAE 5W-30 Super Premium Motor OilCXO-5W30-LSP12
WSS-M2C946-AOptional motor oil (U.S.):Motorcraft SAE 5W-30 Full Synthetic Motor OilXO-5W30-QFS
WSS-M2C946-AOptional motor oil (Canada):Motorcraft SAE 5W-30 Full Synthetic Motor OilCXO-5W30-LFS12
WSS-M97B44-D2Engine coolant (U.S.):Motorcraft Orange Antifreeze/Coolant PredilutedVC-3DIL-B
26Focus (CDH), enUSA, First PrintingCapacities and Specifications

SpecificationName
WSS-M97B44-D2Engine coolant (Canada):Motorcraft Orange Antifreeze/Coolant PredilutedCVC-3DIL-B
WSS-M6C65-A2Brake fluid:Motorcraft DOT 4 Low Viscosity (LV) High Perform-ance Motor Vehicle Brake FluidPM-20
WSS-M2C200-D2Manual transmission fluid:Motorcraft Dual Clutch Transmission FluidXT-11-QDC
If you use oil and fluids that do not meetthe defined specification and viscositygrades this may lead to:
•Component damage which may not becovered by the vehicle Warranty.
•Longer engine cranking periods.
•Increased emission levels.
•Reduced engine performance.
•Reduced fuel economy.
•Degraded brake performance.
We recommend Motorcraft motor oil foryour vehicle. If Motorcraft oil is notavailable, use motor oils of therecommended viscosity grade that meetAPI SN requirements and display the APICertification Mark for gasoline engines. Donot use oil labeled with API SN servicecategory unless the label also displays theAPI certification mark.
An oil that displays this symbol conformsto current engine, emission system andfuel economy performance standards ofthe International Lubricant Standardizationand Approval Committee (ILSAC).
Do not use supplemental engine oiladditives because they are unnecessaryand could lead to engine damage that maynot be covered by your vehicle warranty.
Note:Ford recommends using DOT 4 LowViscosity (LV) High Performance Brake Fluidor equivalent meeting WSS-M6C65-A2. Useof any fluid other than the recommendedfluid may cause degraded brakeperformance and not meet the Fordperformance standards. Keep brake fluidclean and dry. Contamination with dirt,water, petroleum products or othermaterials may result in brake systemdamage and possible failure.
27Focus (CDH), enUSA, First PrintingCapacities and SpecificationsE142732