ECO mode FORD KUGA 2011 1.G Owners Manual

Measure the compression pressure
(Engine - 2.5L Duratec-ST (VI5))
TIE44608
1. Remove the central junction box (CJB) cover.
TIE44609
2. Open the CJB and remove the fuel pump relay.
3. NOTE: The engine will start, run for a fewseconds and then stop.
Start the engine.
4. Remove the ignition coil-on-plug.
REFER to: Ignition Coil-On-Plug (303-07 Engine
Ignition - 2.5L Duratec (147kW/200PS) - VI5,
Removal and Installation). 5. Connect the battery ground cable.
REFER to: Battery Disconnect and Connect
(414-01 Battery, Mounting and Cables,
General Procedures).
E68679
x5
6. Using Special Tool 303-499, remove the spark plugs.
E68434
NOTE: Operate the starter motor with wide open
throttle until the pointer on the measuring device
stops rising.
7. Carry out the measurement in accordance with the instructions supplied with the measuring
device on every cylinder using a suitable
compression pressure recorder with a suitable
adapter.
E68680
28 Nm
8. Using Special Tool 303-499, install the sparkplugs.
G1055128en2008.50 Kuga8/2011
303-00- 10
Engine System - General Information
303-00- 10
DIAGNOSIS AND TESTING
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL

Engine Data
DescriptionHYDC
HYDB
Engine code
1-2-4-5-3
Firing order
Stage V
Stage IV
Emission level
83 mm
Bore
93.2 mm
Stroke
2522 cm³
Cubic capacity
9:1
Compression ratio
147 kW (200 PS)
Power output at 6000 rpm
320 Nm
Maximum torque at 1600
rpm
6850 rpm
Maximum engine speed
(intermittent)
6500 rpm
Maximum engine speed
(continous)
770 rpm
Idle speed
6
Number of main bearings
Belt
Camshaft drive
0.5 l/1000 Km
Oil consumption
Engine Oil
Specification
Ty p e
Viscosity / ambient temper-
ature
Recommended engine oil WSS-M2C913-C
Ford Formula E
SAE 5W-30 / below -20°C to over
+40°C
Alternative engine oils (for top-
up only)
ACEA A3/B3
Ford Formula XR+
SAE 10W-40 / -20°C to over
+40°C
ACEA A3/B3
Ford Formula S
SAE 5W-40 / below -20°C to over
+40°C
Engine Oil Capacity
Liters
Description
5.8
Service fill including filter
5.5
Service fill excluding filter
Oil Pressure
Bar
Description
1.0
Minimum oil pressure at 800 - 850 rpm (normal operating temperature)
3.5
Minimum oil pressure at 4000 rpm (normal operating temperature)
G1079019en2008.50 Kuga8/2011
303-01- 3
Engine— 2.5L Duratec (147kW/200PS) - VI5303-01-
3
SPECIFICATIONS
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL

27. CAUTION: Note the position of thecomponents before removal.
E68493
x20
x5
28. CAUTION: Make sure that no fluids arepresent in the threaded bores.
Torque:
• Stage 1: 20
Nm
• Stage 2: 60Nm
• Stage 3: 130°
E68494
1591284
37111062
29. WARNING: Be prepared to collectescaping fluid.
General Equipment: Fluid Container
Torque: 38
Nm
E115890
30.Torque: 25Nm
E115891
31.
E116077
Installation
1.To install, reverse the removal procedure.
G1079022en2008.50 Kuga8/2011
303-01- 54
Engine— 2.5L Duratec (147kW/200PS) - VI5303-01-
54
REMOVAL AND INSTALLATION
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL

E84406
x20
20.
21.
22.
x4
23.
E84206
24.
25. CAUTION: Note the position of thecomponents before removal.
G543498en2008.50 Kuga8/2011
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUALBACK TO CHAPTER INDEX
TO MODEL INDEX
1591284
3711106
2
E64878E68495
19.
E84582
303-01-
88
Engine— 2.5L Duratec (147kW/200PS) - VI5303-01-
88
DISASSEMBLY

E122192
x10
26. CAUTION: Note the position of thecomponents before removal.
E77266
27. CAUTION: Note the position of thecomponents before removal.
E122197
x5
28.
G543498en2008.50 Kuga8/2011
303-01- 89
Engine— 2.5L Duratec (147kW/200PS) - VI5303-01-
89
DISASSEMBLY
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL

E122198
x12
x12x5
29. CAUTION: Note the position of thecomponents before removal.
G543498en2008.50 Kuga8/2011
303-01- 90
Engine— 2.5L Duratec (147kW/200PS) - VI5303-01-
90
DISASSEMBLY
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL

E122294
x5
30.
E122227
31. CAUTION: Note the position of thecomponents before removal.
G543498en2008.50 Kuga8/2011
303-01- 91
Engine— 2.5L Duratec (147kW/200PS) - VI5303-01-
91
DISASSEMBLY
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL

6
1
2
3
4
5
6
E122606
1
2
3
4
5
6
123456
2. CAUTION: Make sure that thecomponents are installed to the position
noted before removal.Apply a thin coating.
Material: Engine Oil - 5W-30 (WSS-M2C913-C)engine oil
G543500en2008.50 Kuga8/2011
303-01- 95
Engine— 2.5L Duratec (147kW/200PS) - VI5303-01-
95
ASSEMBLY
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL

E122293
x5
3. CAUTION: Make sure that thecomponents are installed to the position
noted before removal.Apply a thin coating.
Material: Engine Oil - 5W-30 (WSS-M2C913-C)engine oil
G543500en2008.50 Kuga8/2011
303-01- 96
Engine— 2.5L Duratec (147kW/200PS) - VI5303-01-
96
ASSEMBLY
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL

E122634
1
2
3
4
5
12345
11. CAUTION: Make sure that thecomponents are installed to the position
noted before removal.
General Equipment: Piston Ring Compressor
E122334
x5
12. CAUTION: Make sure that thecomponents are installed to the position
noted before removal.
Apply a thin coating.
Material: Engine Oil - 5W-30 (WSS-M2C913-C)engine oil
E77266
13. CAUTIONS:
Make sure that the components are
installed to the position noted before
removal.
Make sure that new bolts are installed.
G543500en2008.50 Kuga8/2011
303-01- 100
Engine— 2.5L Duratec (147kW/200PS) - VI5303-01-
100
ASSEMBLY
TO MODEL INDEX
BACK TO CHAPTER INDEX
FORD KUGA 2011.0MY WORKSHOP REPAIR MANUAL