engine coolant FORD KUGA 2011 1.G Workshop Manual

FORD KUGA 2011 1.G Workshop Manual KUGA 2011 1.G FORD FORD https://www.carmanualsonline.info/img/11/5478/w960_5478-0.png FORD KUGA 2011 1.G Workshop Manual

Page 49 of 2057

FORD KUGA 2011 1.G Workshop Manual Solvent-based Adhesives/Sealers - See
Solvents
Follow manufacturers instructions.
Water-based Adhesives/Sealers
Those based on polymer emulsions and rubber
latexes may contain small amounts of volatil

Page 63 of 2057

FORD KUGA 2011 1.G Workshop Manual Road/Roller Testing
Road or roller testing may be carried out for various
reasons and a procedure detailing pre-test checks,
engine starting and stopping, pre-driving checks,
on-test checks and final

Page 160 of 2057

FORD KUGA 2011 1.G Workshop Manual Description
Item
Electric Booster HeaterRefer to Component Description: (page
?)
1
GEM (generic electronic module)
2
Outside temperature sensor
3
Climate control system control assembly
4 Description

Page 165 of 2057

FORD KUGA 2011 1.G Workshop Manual System Operation
Electric Booster Heater
In diesel vehicles which give off little residual heat,
a booster heater is used to heat the passenger
compartment rapidly in the case of low ambient
temperatu

Page 166 of 2057

FORD KUGA 2011 1.G Workshop Manual Description
Item
Glow plug
1
Combustion Air Blower
2
Fuel pump
3
Fuel-fired heater on
4
Fuel-fired heater - large regulating step
5
Fuel-fired heater - small regulating step
6 Description
Item
Fuel-fi

Page 167 of 2057

FORD KUGA 2011 1.G Workshop Manual reprogrammed. However, if the engine hasnt been
run since the last programmed start, the fuel-fired
booster heater will not start up the second time so
as to prevent the battery from being discharged

Page 169 of 2057

FORD KUGA 2011 1.G Workshop Manual Description
Item
Combustion chamber
16
O Ring
17 Description
Item
Combustion blower motor cover
18
Glow plug wiring harness
19
Flame sensor
If the flame goes out independently during
operation of th

Page 170 of 2057

FORD KUGA 2011 1.G Workshop Manual Auxiliary Coolant Flow Pump
General Equipment
Hose Clamp(s) General Equipment
Hose Clamp Remover/Installer
Removal
1. Refer to: Engine Cooling System Health and
Safety Precautions (100-00 General
Info

Page 177 of 2057

FORD KUGA 2011 1.G Workshop Manual 7.
Installation
1.
To install, reverse the removal procedure.
2. Check the coolant level.
Refer to: Cooling System Draining and Vacuum
Filling (303-03 Engine Cooling, General
Procedures). G1163563en
2

Page 183 of 2057

FORD KUGA 2011 1.G Workshop Manual Instrument Cluster and Panel Illumination
Refer to
Wiring Diagrams Section 413-00, for
schematic and connector information.
Principles of Operation
NOTE: A new instrument cluster must be
configured.
T
Page:   1-10 11-20 21-30 31-40 40 next >