clock FORD KUGA 2015 2.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine POWER WINDOWS
To reduce wind noise or buffeting when justone window is open, open the oppositewindow slightly.
GLOBAL OPENING AND
CLOSING
Global Opening
1.Press and release the remote controlunlock button.
2.Press and hold the remote controlunlock button for at least three seconds.
Press the lock or unlock button to stop theopening function.
Global Closing
Vehicles Without Keyless Entry
To close all the windows, press and holdthe remote control lock button for at leastthree seconds. Press the lock or unlockbutton to stop the closing function.
Vehicles With Keyless Entry
To close all the windows, press and holdthe driver’s door handle for at least threeseconds.
MOONROOF (If Equipped)
Opening and Closing the Sunscreen
Press and release the rear of the control toopen the sunscreen. Press and release thefront of the control to close the sunscreen.
Opening and Closing the Moonroof
Press and release the rear of the control toopen the moonroof. Press and release thefront of the control to close the moonroof.
CLOCK
Type 1
To adjust the clock, switch the ignition onand press buttons H or M on the informationand entertainment display as necessary.
Type 2
Use the information display to adjust theclock.
TRIP COMPUTER
Fuel Used
Indicates the approximate distance yourvehicle will travel on the fuel remaining inthe tank. Changes in driving pattern maycause the value to vary.
6Kuga (CBS) Vehicles Built From: 08-09-2014 Vehicles Built Up To: 31-05-2015, CG3586en enGBR, Edition date: 09/2014, Second Printing

Downloaded from www.Manualslib.com manuals search engine Inflating the Tire
Protective capA
Pressure relief valveB
HoseC
Orange capD
Bottle holderE
Pressure gaugeF
Power plug with cableG
Compressor switchH
LabelI
Bottle lidJ
Sealant bottleK
1.Open the lid of the kit.
2.Peel off the label I showing themaximum permissible speed of 50 mph(80 km/h) from the casing and attachit to the instrument panel in the driver’sfield of view. Make sure the label doesnot obscure anything important.
3.Take the hose C and the power plugwith cable G out of the kit.
4.Unscrew the orange cap D and thebottle lid J.
5.Screw the sealant bottle K clockwiseinto the bottle holder E fully tight.
6.Remove the valve cap from thedamaged tire.
7.Detach the protective cap A from thehose C and screw the hose C firmly ontothe valve of the damaged tire.
8.Make sure that the compressor switchH is in position 0.
9.Insert the power plug G into the cigarlighter socket or auxiliary power point.
10.Start the engine.
11.Move the compressor switch H toposition 1.
12.Inflate the tire for no longer than 10minutes to an inflation pressure ofminimum 1.8 bar (26 psi) and amaximum of 3.5 bar (51 psi). Move thecompressor switch H to position 0 andcheck the current tire pressure withpressure gauge F.
13.Remove the power plug G from thecigar lighter socket or auxiliary powerpoint.
14.Quickly unscrew the hose C from thetire valve and replace the protectivecap A. Fasten the valve cap again.
15.Leave the sealant bottle K in thebottle holder E.
16.Make sure the kit, the bottle lid andthe orange cap are stored safely, butstill easily accessible in your vehicle.The kit will be required again when youcheck the tire pressure.
17.Immediately drive approximatelytwo miles (three kilometers) so thatthe sealant can seal the damagedarea.
TIRE PRESSURE MONITORING
SYSTEM
13Kuga (CBS) Vehicles Built From: 08-09-2014 Vehicles Built Up To: 31-05-2015, CG3586en enGBR, Edition date: 09/2014, Second Printing