wipers FORD MONDEO 2010 3.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 2010, Model line: MONDEO, Model: FORD MONDEO 2010 3.GPages: 16, PDF Size: 4.2 MB
Page 6 of 16
Downloaded from www.Manualslib.com manuals search engine Locking and unlocking the
doors with the key blade
1. Carefully remove the cover.
2.
Remove the key blade and insert it into
the lock.
AUTOWIPERS WARNING
For all warnings and cautions, refer
to your Owner's handbook.
Low sensitivity
A
OnB
High sensitivity
C
The rain sensor will continuously measure
the amount of water on the windscreen
and adjust the speed of the front wipers
automatically. Adjust the sensitivity of the rain sensor
using the rotary control.
CHANGING THE WIPER
BLADES
WARNING
For all warnings and cautions, refer
to your Owner's handbook.
Windscreen wiper blades
CAUTION
Set the windscreen wipers in the
service position to change the wiper
blades.
Service position
4121E87964 E71013CAB E85833 AE75188
Page 7 of 16
Downloaded from www.Manualslib.com manuals search engine Switch off the ignition and move the wiper
lever to positionAwithin three seconds.
Release the lever when the windscreen
wipers have moved to the service position.
AUTOMATIC MAIN BEAM
CONTROL
WARNINGS
For all warnings and cautions, refer
to your Owner's handbook.
The system does not relieve you of
your responsibility to drive with due
care and attention. A manual
override may be necessary if the system
fails to switch the main beam on or off.
CAUTION
In cold and severe weather conditions
the system may not function. A
manual override may be necessary in
these cases.
The system will automatically switch on
main beam if it is dark enough and no
other traffic is present. If it detects an
approaching vehicle’s headlamps or tail
lamps, or street lighting ahead the system
will switch off main beam before it can
distract other road users.
Once the system is active the main beam
will switch on if:
• it is dark enough to require the use of
main beams and
• there is no traffic or street lighting
ahead and
• vehicle speed is greater than 40 km/h
(25 mph).
The main beam will switch off if:
• The ambient light is high enough that
main beam is not required.
• An approaching vehicle's headlamps
or tail lamps are detected.
• Street lighting is detected. •
Vehicle speed falls below 25 km/h (16
mph).
• The camera sensor is too hot or
becomes blocked.
Activating the system
Switch on the system using the information
display and autolamps.
E70719
Turn the switch to the autolamps position.
Manually overriding the system
E70725
Use the main beam lever to switch
between main beam and dipped beam.
ELECTRIC WINDOWS
WARNING
For all warnings and cautions, refer
to your Owner's handbook.
5