brake FORD PROBE 1996 2.G User Guide

56 [LG02350(ALL)01/94]This light should come on as you start the
vehicle. If it doesn't come on then, have it fixed
so it will be ready to warn you if there's a
problem.
[LG02550(ALL)06/93]
one inch art:0030319-E
Brake system and parking brake light
[LG02600(ALL)01/93]
This light comes on briefly when you turn the
ignition key to START. It normally goes off
shortly after the engine starts and you release
the parking brake, but it may stay on for up to
60 seconds. If the light stays on for longer than
60 seconds or comes on after you have fully
released the parking brake, have the hydraulic
brake system serviced.
*
[LG02650(ALL)02/94]
This light will also come on if the parking brake
does not release fully. If it does stay onafterthe
parking brake is fully released, it means there
may be a brake problem. Pull off the road and
stop carefully. You may notice that the pedal is
harder to push, the pedal may go closer to the
floor, or it may take longer to stop the vehicle.
Try the brakes again after you have stopped.
*
[LG02700(ALL)05/95]
RWARNING
The BRAKE light indicates that the brakes
may not be working properly. Have the
brakes checked immediately.
File:prlgp.ex
Update:Fri Jun 23 19:38:06 1995

57 %
*
[LG02750(ALL)02/95]
Anti-Lock Brake System Warning Light
[LG02760(ALL)01/94]
When the ignition switch is turned to the ON
position, the anti-lock brake system warning
light will come on. When the engine is started,
the anti-lock brake system control unit will
determine if all components of the system are
operating correctly. The warning light could
remain on for two to four seconds.
[LG02771(ALL)06/95]
one inch art:0032359-C
The anti-lock brake system warning light
*
[LG02780(ALL)05/95]
RWARNING
If the anti-lock brake system warning
light remains on or comes on while
driving, have the braking system checked
by a qualified service technician as soon
as possible.
*
[LG02785(ALL)06/95]
NOTE: If a fault occurs in the anti-lock
system, and the brake warning light is
not lit, the anti-lock system is disabled
but normal brake function remains
operational.
*
[LG02790(ALL)09/93]
NOTE: If your vehicle must be jump-started
because of a low battery, the anti-lock
brake system warning light could
remain on. This is due to low battery
voltage and does not indicate a
malfunction in the system. Under these
circumstances, you should drive your
vehicle only after the battery has had
time to charge and the light has gone
out.
File:prlgp.ex
Update:Fri Jun 23 19:38:06 1995

78 [SC01105(ALL)08/91]
quarter page art:0032032-AHeadlamp control
*
[SC01110(ALL)01/95]
Daytime Running Light System
*
[SC01115(ALL)03/95]
(Canadian vehicles only)
*
[SC01120(ALL)05/95]
In Canada, certain regulations require vehicles to
be driven with lights illuminated during daytime
operation. It is for that reason that the daytime
running lights are automatically illuminated
when the ignition switch is turned to the ON
position. The daytime running lights are
switched off under the following conditions:
*
[SC01130(ALL)05/95]
q
when the headlamps are switched on
*
[SC01140(ALL)01/92]
q
when the parking brake is applied
*
[SC01150(ALL)01/92]
q
when the flash-to-pass system is used
*
[SC01175(ALL)05/95]
RWARNING
The Daytime Running Light (DRL) system
will not illuminate the tail lamps and
parking lamps. Turn on your headlamps
at dusk. Failure to do so may result in a
collision.
File:prscp.ex
Update:Fri Jun 23 19:37:07 1995

81
*
[SC02090(ALL)05/95]
Flashing the Lights
*
[SC02091(ALL)06/95]
To flash the headlamps, pull the lever toward
you for a moment and then release it. The
headlamps will flash whether the headlamp
knob is in the on or off position.
[SC02093(ALL)08/91]
quarter page art:0032034-A
Highbeam and flash-to-pass operation
[SC02095(ALL)11/91]
If the headlamps are retracted when you pull
the lever toward you, they will pop up and
flash.
%*
[SC02097(ALL)05/95]
Cleaning the Exterior Lamps
*
[SC02098(ALL)05/95]
Do not use dry paper towel, chemical solvents
or abrasive cleaners to clean the lamps, as these
may cause scratches or crack the lamps.
%
*
[SC02100(ALL)03/95]
Hazard Flasher
*
[SC02200(ALL)09/93]
To alert other drivers to hazardous situations,
press the flasher switch on the top of the
steering column. All the turn signals will flash
on and off at the same time. The flashers will
also operate while the brake pedal is applied. To
turn the hazards off, press the switch again.
*
[SC02300(ALL)01/94]
The flashers work whether your vehicle is
running or not. The flashers will work for up to
two hours when the battery is fully charged and
in good condition. They will not drain the
battery excessively unless they are left on for an
extended period of time.
File:prscp.ex
Update:Fri Jun 23 19:37:07 1995

93
*
[SC07150(ALL)04/95]
To Cancel Speed Control
*
[SC07200(ALL)06/95]
You can cancel the speed control while you are
driving.
[SC07250(ALL)05/93]
Press the brake pedal or clutch pedal (manual
transaxle) slightly. The speed control is
cancelled, but you can reset it by pressing SET
ACC or RSM.
%*
[SC07300(ALL)05/95]
To Turn Off the Speed Control System
[SC07350(ALL)01/94]
Press the OFF switch. The speed control system
is off and will remain off until you press the ON
switch and reset the speed control.
*
[SC07400(ALL)05/95]
In addition, the speed control is turned off each
time you turn the vehicle off.
%*
[SC07450(ALL)06/95]
Cancelling and Resuming a Set Speed
[SC07500(ALL)04/95]
If you press the brake pedal, the clutch pedal
(manual transaxle), or shift the transaxle into N
(Neutral) the speed control is suspended. You
can return to the speed you set by using the
RSM switch.
*
[SC07550(ALL)06/95]
To resume the speed you had before, you must
be driving at least 30 mph (50 km/h).
*
[SC07600(ALL)05/93]
Press and release the RSM switch. Your vehicle
gradually returns to the previously set speed
and then maintains it.
File:prscp.ex
Update:Fri Jun 23 19:37:07 1995

114 [FV21000(ALL)06/94]
half page art:0030108-CDual-electric side mirror control switches
*
[FV21600(ALL)01/95]
Console
[FV21700(ALL)03/94]
A fully-equipped console on your vehicle will
include the following items:
[FV21800(ALL)01/92]
q
ashtray and lighter
[FV22200(ALL)01/92]
q
parking brake lever
[FV22250(ALL)01/92]
q
cupholder or storage compartment with
cupholder
File:prfvp.ex
Update:Fri Jun 23 19:36:28 1995

148 [DR02205(ALL)06/93]
two third page art:0032064-DAutomatic shift lever
*
[DR02400(ALL)03/94]
Your automatic transaxle vehicle has a
console-mounted shift selector lever. You must
step on the brake pedal, start the engine, and
then push in the thumb button to move the shift
selector lever to the position you choose.
*
[DR02500(ALL)05/95]
RWARNING
Hold the brake pedal down while you
move the gearshift lever from position to
position. If you do not hold the brake
pedal down, your vehicle may move
unexpectedly and injure someone.
File:prdrp.ex
Update:Fri Jun 23 19:35:02 1995

149 [DR02550(ALL)03/94]
NOTE: If the shift selector lever will not move
with the key on and the brake pedal
depressed refer toShift lock systemin
the Index.
*
[DR02600(ALL)11/94]
Once the gearshift is secure in the desired
position, release the brake pedal and use the
accelerator as necessary.
%*
[DR02900(ALL)06/92]
Backing Up
*
[DR03000(ALL)02/95]
With the gearshift in the R (Reverse) position,
the vehicle will move backward. You should
always come to a complete stop before shifting
into or out of R (Reverse).
*
[DR03100(ALL)01/95]
Driving
[DR03200(ALL)05/93]
When to use Overdrive (D with Overdrive
activated)
[DR03300(ALL)01/94]
Overdrive is the usual driving position for an
automatic overdrive transaxle. It works the same
way Drive (Overdrive OFF) works, automatically
upshifting or downshifting as the vehicle speeds
or slows.
[DR03400(ALL)01/94]
However, Overdrive also shifts into a fourth
gear Ð an overdrive gear Ð when your vehicle
cruises at a consistent speed for any length of
time. This fourth gear will increase your fuel
economy when you travel at cruising speeds.
[DR03500(ALL)05/95]
Overdrive may not be appropriate for certain
terrain. If the transaxle shifts back and forth
between third and fourth gears while you are
driving on hilly roads, select Drive (Overdrive
OFF) by cancelling Overdrive as outlined below.
File:prdrp.ex
Update:Fri Jun 23 19:35:02 1995

152 [DR04280(ALL)11/91]Reverse
[DR04315(ALL)01/92]
In the Reverse (R) position, the vehicle moves
only backward. Your vehicle must be stopped
before shifting into Reverse (R).
[DR04330(ALL)11/91]
Neutral
[DR04360(ALL)01/92]
In Neutral (N), the wheels of the transaxle are
not locked. Your vehicle will roll freely, even on
the slightest incline, unless the parking brake or
brakes are on.
*
[DR04500(ALL)06/92]
Parking
[DR04600(ALL)03/94]
Always come to a complete stop before you shift
into P (Park). Make sure that the shift selector
lever is securely latched in P (Park). This locks
the transaxle and prevents the front wheels from
rotating.
*
[DR04700(ALL)05/95]
RWARNING
Always set the parking brake fully and
make sure that the gearshift is securely
latched in P (Park).
*
[DR04800(ALL)06/95]
RWARNING
Never leave your vehicle unattended
while it is running.
*
[DR05000(ALL)02/91]
You can tell the gearshift is securely latched
when the thumb button has popped out. In this
position the gearshift selector lever cannot be
moved unless the button is pushed in.
File:prdrp.ex
Update:Fri Jun 23 19:35:02 1995

153
*
[DR05050(ALL)05/95]
RWARNING
Hold the brake pedal down while you
move the gearshift lever from position to
position. If you do not hold the brake
pedal down, your vehicle may move
unexpectedly and injure someone.
*
[DR05100(ALL)01/89]
Driving with a Manual Transaxle
*
[DR05200(ALL)03/95]
Using the Clutch
*
[DR05300(ALL)05/95]
After the engine starts, allow it to idle for a few
seconds. Then, hold your right foot on the brake
pedal, push the clutch pedal to the floor with
your left foot, and move the shift selector lever
into 1 (First) or R (Reverse).
*
[DR05400(ALL)01/94]
To move the vehicle, lift your right foot off the
brake pedal and slowly release the clutch pedal.
(You need to press down slowly on the
accelerator at the same time you release the
clutch pedal.)
*
[DR05500(ALL)03/95]
Do not drive with your foot resting on the
clutch pedal and do not use the clutch to hold
your vehicle at a standstill while waiting on a
hill. These actions will seriously reduce clutch
life.
*
[DR05600(ALL)03/95]
Driving with your foot resting on the clutch may
cause the vehicle to jerk sharply when pressing
or removing your other foot from the
accelerator.
File:prdrp.ex
Update:Fri Jun 23 19:35:02 1995