automatic transmission FORD RANGER 1998 2.G Owner's Manual

3.0L V6 Vulcan engine
1. Engine coolant reservoir
2. Windshield washer fluid reservoir
3. Engine oil filler cap
4. Transmission fluid dipstick (automatic transmission)
5. Engine oil dipstick
6. Brake fluid reservoir
7. Clutch fluid reservoir
8. Battery
9. Power steering fluid reservoir
10. Air filter assembly
1098
123456
7
Maintenance and care
113

4.0L V6 engine
1. Windshield washer fluid reservoir
2. Engine oil filler cap
3. Transmission fluid dipstick (automatic transmission)
4. Engine oil dipstick
5. Power steering fluid reservoir
6. Brake fluid reservoir
7. Clutch fluid reservoir (manual transmission)
8. Battery
9. Air filter assembly
10. Engine coolant reservoir
10
1235674
89
Maintenance and care
114

ENGINE OIL
Checking the engine oil
Check the engine oil each time you fuel your vehicle.
1. Make sure the vehicle is on level ground.
2. Turn the engine off and wait a few minutes for the oil to drain into the
oil pan.
3. Set the parking brake and ensure the gearshift is securely latched in P
(Park) (automatic transmissions) or 1 (First) (manual transmissions).
4. Open the hood. Protect yourself from engine heat.
5. Locate and carefully remove the engine oil level indicator (dipstick).
²2.5L I4 engine
MAX MIN
Maintenance and care
115

4. Check the fluid level on the dipstick. It should be between the arrows
in the FULL HOT range. Do not add fluid if the level is within this range.
5. If the fluid is low, add fluid in small amounts, continuously checking
the level until it reaches the FULL HOT range. Be sure to put the
dipstick back in the reservoir.
TRANSMISSION FLUID
Checking and adding automatic transmission fluid
Follow the scheduled service intervals outlined in the ªService Guide.º
Before adding any fluid, make sure the correct type is used. The type of
fluid used is normally indicated on the dipstick and/or dipstick handle
and also in theLubricant specificationssection in theCapacities and
specificationschapter.
An overfill condition of transmission fluid may cause shift and/or
engagement concerns and/or possible damage.
Do not drive the vehicle if the fluid
level is below the bottom hole on
the dipstick and outside
temperatures are above 10ÉC (50ÉF)
(see figure to the right).
Your transmission does not use up fluid. However, it is recommended
that you check the transmission fluid at least twice a year. The fluid level
should be checked if the transmission is not working properly, i.e., if the
transmission slips or shifts slowly or if you notice some sign of fluid
leakage.
Transmission fluid should be checked at normal operating temperatures
66ÉC-77ÉC (150ÉF-170ÉF) on a level surface. The normal operating
temperature can be reached after approximately 32 km (20 miles) of
driving.
The transmission fluid should be in
this range if at normal operating
temperature (66ÉC-77ÉC
[150ÉF-170ÉF])
(see figure to the right).
DON’T ADD IF IN CROSSHATCH AREA
DON’T ADD IF IN CROSSHATCH AREA
Maintenance and care
124

BATTERY
Your vehicle may be equipped with a
Superstart maintenance-free battery.
If the original equipment battery
needs replacing, it may be replaced
with a low-maintenance battery. The
low-maintenance battery normally
does not require additional water
during its life of service.
If the electrolyte level in the battery
is low, you can add plain tap water
to the battery, as long as you do not
use hard water (water with a high
alkali content). If possible, however,
try to only fill the battery cells with
distilled water. If the battery needs
water often, have the charging system checked.
For longer, trouble-free operation, keep the top of the battery clean and
dry. Also, make certain the battery cables are always tightly fastened to
the battery terminals.
If you see any corrosion on the battery or terminals, remove the cables
from the terminal(s) and clean with a wire brush. You can neutralize the
acid with a solution of baking soda and water. Reinstall the cables when
you are done cleaning them, and apply a small quantity of grease to the
top of each battery terminal to help prevent corrosion.
If your battery has a cover/shield, make sure it is reinstalled
after the battery is replaced.
Because your vehicle's engine is electronically controlled by a computer,
some control conditions are maintained by power from the battery. When
the battery is disconnected or a new battery is installed, the engine must
relearn its idle conditions before your vehicle will drive properly. To
begin this process:
1. Put the gearshift in P (Park) (automatic transmission) or the neutral
position (manual transmission), turn off all accessories and start the
engine.
2. Let the engine idle for at least one minute.
Maintenance and care
128

REFILL CAPACITIES
Fluid Ford Part
NameApplication
Capacity
Engine oil
(includes
filter
change)Motorcraft
5W30 Super
Premium Motor
Oil2.5L I4 and 3.0L
V6 engine4.3L (4.5 quarts)
4.0L V6 engine 4.7L (5.0 quarts)
Brake fluid High
Performance
DOT 3 Motor
Vehicle Brake
FluidAll
Fill to line on
reservoir
Power
steering
fluidMotorcraft
MERCONtAT FAll
Fill to range on
dipstick
Transmission
fluidMotorcraft
MERCONtAT F5-speed manual
2.65L (2.8 quarts)
Motorcraft
MERCONtV
AT F4x2 vehicles with
automatic9.0L (9.5 quarts)
4x4 vehicles with
automatic9.3L (9.8 quarts)
Engine
coolantFord Extended
Life Engine
Coolant
(DEX-COOL)2.5L I4 engine
without A/C6.2L (6.5 quarts)
2.5L I4 engine
with A/C6.8L (7.2 quarts)
3.0L V6 engine
without A/C9.0L (9.5 quarts)
3.0L V6 engine
with A/C9.6L (10.2 quarts)
4.0L V6 engine
without A/C7.4L (7.8 quarts)
4.0L V6 engine
with A/C8.1L (8.6 quarts)
Capacities and specifications
148

ItemFord part
name or
equivalentFord part
numberFord
specification
Power steering fluid,
transfer case fluid and
transmission fluid
(manual)Motorcraft
MERCONt
AT FXT-2-QDX MERCONt
Automatic transmission
(4R44E and 5R55E)Motorcraft
MERCONtV
AT FXT-5-QM
MERCONtV
Windshield washer fluidUltra-clear
windshield
washer
concentrateC9AZ-
19550-ABESR-
M17P5-A
1Add 118 ml (4 oz.) of additive friction modifier C8AZ-19B546±A, Ford
specification EST-M2C118±A for complete refill of Traction-Lok axles.
ENGINE DATA
Engine 2.5L I4 engine 3.0L V6 engine 4.0L V6 engine
Cubic inches 153 182 245
Horsepower 119 @ 5000 rpm 150 @ 5000 rpm 160 @ 4200 rpm
Torque 146 lbs. ft. @
3000 rpm185 lbs. ft. @
3250 rpm225 lbs. ft. @
2750 rpm
Required fuel
grade87 octane 87 octane 87 octane
Firing order 1-3-4-2 1-4-2-5-3-6 1-4-2-5-3-6
Spark plug
gap1.07-1.17 mm
(0.042-.046 inch)1.07-1.17 mm
(0.042-.046 inch)1.3-1.4 mm
(0.052-.056 inch)
Ignition
systemEDIS EDIS EDIS
Compression
ratio9.4:1 9.14:1 9.0:1
Capacities and specifications
151

canceling a set speed ...............27
indicator light ...........................28
resuming a set speed ...............28
tap up/tap down .......................26
turning off .................................25
Speedometer ...............................14
Starting your vehicle .............59,61
Tachometer
mechanical cluster ...................13
Tilt steering wheel ......................29
Tires ....................................130,132
changing ..................................103
checking the pressure ............132
replacing ..................................133
rotating ....................................132
snow tires and chains ............134
treadwear ................................131
Traction-lok rear axle ..........79,127
Trailer towing ..............................81
tips .............................................89
Transaxle
fluid, checking and adding
(manual) .................................126
Transfer case
fluid checking .........................127Transmission .............................124
automatic
operation ..........67,68,69,70,71,72
fluid, checking and adding
(automatic) .............................124
Trip odometer .............................14
Turn signal
lever ...........................................24
Vehicle dimensions ...................152
Vehicle Identification Number
(VIN) ..........................................154
Vehicle loading ............................79
Ventilating your vehicle .............63
Windows
power windows, operating .......30
Windshield washer fluid and
wipers
checking and adding fluid .....120
checking and replacing wiper
blades ......................................129
operation ...................................29
Wrecker towing .........................109
Index
158

Recommended fuel Unleaded fuel only - 87 octane
Fuel tank capacity
(Regular cab-Short wheel base)62.8L (16.6 gallons)
Fuel tank capacity
(Regular cab-Long wheel base)75.7 (20.0 gallons)
Fuel tank capacity (SuperCab) 74.2L (19.6 gallons)
Engine oil capacity
(with filter change)-
2.5L and 3.0L engines4.3L (4.5 quarts). Use Motorcraft
5W30 Super Premium Motor Oil,
Ford Specification WSS-M2C153-G
Engine oil capacity
(with filter change)-
4.0L engine4.7L (5.0 quarts). Use Motorcraft
5W30 Super Premium Motor Oil,
Ford Specification WSS-M2C153-G
Tire size and pressure See Safety Compliance
Certification Label on inside of
driver door.
Hood release Pull handle under the left side of
the instrument panel
Coolant capacity-2.5L
without air conditioning6.2L (6.5 quarts)
Coolant capacity-2.5L
with air conditioning6.8L (7.2 quarts)
Coolant capacity-3.0L
without air conditioning9.0L (9.5 quarts)
Coolant capacity-3.0L
with air conditioning9.6L (10.2 quarts)
Coolant capacity-4.0L
without air conditioning7.4L (7.8 quarts)
Coolant capacity-4.0L
with air conditioning8.1L (8.6 quarts)
Power steering fluid capacity Fill to range on dipstick
Manual transmission fluid capacity 2.65L (2.8 quarts)
Automatic transmission fluid
capacity-4x2 vehicles9.0L (9.5 quarts)
Automatic transmission fluid
capacity-4x4 vehicles9.3L (9.8 quarts)
Filling station information
159

Ensure correct automatic transmission fluid is used for a specific
application. Check the container to verify the fluid is MERCONtand/or
MERCON Vtapproved. Some fluids have been approved as meeting both
MERCONtand MERCONtV requirements and will be labeled as such.
Fluids labeled as meeting only MERCONtor only MERCONtV
requirements must not be used interchangeably. DO NOT mix MERCONt
and MERCONtV. Transmission fluid requirements are indicated on the
dipstick or on the dipstick handle. Refer to your ªService Guideº to
determine the correct service interval.
Filling station information
160