automatic transmission fluid FORD RANGER 1998 2.G Owners Manual

Mud and water
If you must drive through high water, drive slowly. Traction or brake
capability may be limited.
When driving through water, determine the depth; avoid water higher
than the bottom of the hubs (if possible) and proceed slowly. If the
ignition system gets wet, the vehicle may stall.
Once through water, always try the brakes. Wet brakes do not stop the
vehicle as effectively as dry brakes. Drying can be improved by moving
your vehicle slowly while applying light pressure on the brake pedal.
After driving through mud, clean off residue stuck to rotating driveshafts
and tires. Excess mud stuck on tires and rotating driveshafts causes an
imbalance that could damage drive components.
If the transmission and transfer case are submerged in water, their fluids
should be checked and changed, if necessary.
Water intrusion into the transmission may damage the
transmission.
If the rear axle is submerged in water, the rear axle lubricant should be
checked and changed, if necessary. The rear axle is filled with a
synthetic lubricant and does not normally require a lubricant change for
the life of the vehicle. Rear axle lubricant quantities should not need to
be checked unless a leak is suspected.
Driving on hilly or sloping terrain
When driving on a hill, avoid driving crosswise or turning on steep
slopes. You could lose traction and slip sideways. Drive straight up,
straight down or avoid the hill completely. Know the conditions on the
other side of a hill before driving over the crest.
When climbing a steep hill, start in a lower gear rather than downshifting
to a lower gear from a higher gear once the ascent has started. This
reduces strain on the engine and the possibility of stalling.
When descending a steep hill, avoid sudden braking. Rapid pumping of
the brake pedal will help slow the vehicle and still maintain steering
control.
When speed control is on and you are driving uphill, your vehicle speed
may drop considerably, especially if you are carrying a heavy load.
If vehicle speed drops more than 16 km/h (10 mph), the speed control
will cancel automatically. Resume speed with accelerator pedal.
Driving
78

If speed control cancels after climbing the hill, reset speed by pressing
and holding the SET ACCEL button to resume speeds over 50 km/h
(30 mph).
Automatic transmissions may shift frequently while driving up steep
grades. Eliminate frequent shifting by shifting out of
(Overdrive) into
D (Drive).
Driving on snow and ice
A 4WD vehicle has advantages over 2WD vehicles in snow and ice but
can skid like any other vehicle.
Avoid sudden applications of power and quick changes of direction on
snow and ice. Apply the accelerator slowly and steadily when starting
from a full stop.
When braking, apply the brakes as you normally would. In order to allow
the anti-lock brake system (ABS) to operate properly, keep steady
pressure on the brake pedal.
Allow more stopping distance and drive slower than usual. Consider
using one of the lower gears.
TRACTION-LOK AXLE (IF EQUIPPED)
This axle provides added traction on slippery surfaces, particularly when
one wheel is on a poor traction surface. Under normal conditions, the
Traction-Lok axle functions like a standard rear axle.
Extended use of other than the manufacturer's specified size tires on a
Traction-Lok rear axle could result in a permanent reduction in
effectiveness. This loss of effectiveness does not affect normal driving
and should not be noticeable to the driver.
To avoid injury, never run the engine with one wheel off the
ground, such as when changing a tire.
VEHICLE LOADING
Before loading a vehicle, familiarize yourself with the following terms:
²Base Curb Weight: Weight of the vehicle including any standard
equipment, fluids, lubricants, etc. It does not include passengers or
aftermarket equipment.
Driving
79

SERVICE RECOMMENDATIONS
To help you service your vehicle:
²We highlight do-it-yourself items in the engine compartment for easy
location.
²We provide a ªService Guideº which makes tracking routine service
easy.
If your vehicle requires professional service, your dealership can provide
necessary parts and service. Check your ªWarranty Guideº to find out
which parts and services are covered.
Use only recommended fuels, lubricants, fluids and service parts
conforming to specifications. Motorcraft parts are designed and built to
provide the best performance in your vehicle.
PRECAUTIONS WHEN SERVICING YOUR VEHICLE
Be especially careful when inspecting or servicing your vehicle.
²Do not work on a hot engine.
²When the engine is running, make sure that loose clothing, jewelry or
long hair does not get caught up in moving parts.
²Do not work on a vehicle with the engine running in an enclosed
space, unless you are sure you have enough ventilation.
²Keep all lit cigarettes, open flames and other lit material away from
the battery and all fuel related parts.
If you disconnect the battery, the engine must ªrelearnº its idle
conditions before your vehicle will drive properly, as explained inBattery
in this chapter.
Working with the engine off
²Automatic transmission:
1. Set the parking brake and
ensure the gearshift is securely latched in P (Park).
2. Turn off the engine and remove the key.
3. Block the wheels to prevent the vehicle from moving unexpectedly.
²Manual transmission:
1. Set the parking brake.
2. Depress the clutch and place the gearshift in 1 (First).
Maintenance and care
110

IDENTIFYING COMPONENTS IN THE ENGINE COMPARTMENT
2.5L I4 engine
1. Engine coolant reservoir
2. Windshield washer fluid reservoir
3. Transmission fluid dipstick (automatic transmission)
4. Engine oil dipstick
5. Brake fluid reservoir
6. Clutch fluid reservoir (manual transmission)
7. Battery
8. Power steering fluid reservoir
9. Engine oil filler cap
10. Air filter assembly
10
165432
987
Maintenance and care
112

3.0L V6 Vulcan engine
1. Engine coolant reservoir
2. Windshield washer fluid reservoir
3. Engine oil filler cap
4. Transmission fluid dipstick (automatic transmission)
5. Engine oil dipstick
6. Brake fluid reservoir
7. Clutch fluid reservoir
8. Battery
9. Power steering fluid reservoir
10. Air filter assembly
1098
123456
7
Maintenance and care
113

4.0L V6 engine
1. Windshield washer fluid reservoir
2. Engine oil filler cap
3. Transmission fluid dipstick (automatic transmission)
4. Engine oil dipstick
5. Power steering fluid reservoir
6. Brake fluid reservoir
7. Clutch fluid reservoir (manual transmission)
8. Battery
9. Air filter assembly
10. Engine coolant reservoir
10
1235674
89
Maintenance and care
114

4. Check the fluid level on the dipstick. It should be between the arrows
in the FULL HOT range. Do not add fluid if the level is within this range.
5. If the fluid is low, add fluid in small amounts, continuously checking
the level until it reaches the FULL HOT range. Be sure to put the
dipstick back in the reservoir.
TRANSMISSION FLUID
Checking and adding automatic transmission fluid
Follow the scheduled service intervals outlined in the ªService Guide.º
Before adding any fluid, make sure the correct type is used. The type of
fluid used is normally indicated on the dipstick and/or dipstick handle
and also in theLubricant specificationssection in theCapacities and
specificationschapter.
An overfill condition of transmission fluid may cause shift and/or
engagement concerns and/or possible damage.
Do not drive the vehicle if the fluid
level is below the bottom hole on
the dipstick and outside
temperatures are above 10ÉC (50ÉF)
(see figure to the right).
Your transmission does not use up fluid. However, it is recommended
that you check the transmission fluid at least twice a year. The fluid level
should be checked if the transmission is not working properly, i.e., if the
transmission slips or shifts slowly or if you notice some sign of fluid
leakage.
Transmission fluid should be checked at normal operating temperatures
66ÉC-77ÉC (150ÉF-170ÉF) on a level surface. The normal operating
temperature can be reached after approximately 32 km (20 miles) of
driving.
The transmission fluid should be in
this range if at normal operating
temperature (66ÉC-77ÉC
[150ÉF-170ÉF])
(see figure to the right).
DON’T ADD IF IN CROSSHATCH AREA
DON’T ADD IF IN CROSSHATCH AREA
Maintenance and care
124

REFILL CAPACITIES
Fluid Ford Part
NameApplication
Capacity
Engine oil
(includes
filter
change)Motorcraft
5W30 Super
Premium Motor
Oil2.5L I4 and 3.0L
V6 engine4.3L (4.5 quarts)
4.0L V6 engine 4.7L (5.0 quarts)
Brake fluid High
Performance
DOT 3 Motor
Vehicle Brake
FluidAll
Fill to line on
reservoir
Power
steering
fluidMotorcraft
MERCONtAT FAll
Fill to range on
dipstick
Transmission
fluidMotorcraft
MERCONtAT F5-speed manual
2.65L (2.8 quarts)
Motorcraft
MERCONtV
AT F4x2 vehicles with
automatic9.0L (9.5 quarts)
4x4 vehicles with
automatic9.3L (9.8 quarts)
Engine
coolantFord Extended
Life Engine
Coolant
(DEX-COOL)2.5L I4 engine
without A/C6.2L (6.5 quarts)
2.5L I4 engine
with A/C6.8L (7.2 quarts)
3.0L V6 engine
without A/C9.0L (9.5 quarts)
3.0L V6 engine
with A/C9.6L (10.2 quarts)
4.0L V6 engine
without A/C7.4L (7.8 quarts)
4.0L V6 engine
with A/C8.1L (8.6 quarts)
Capacities and specifications
148

ItemFord part
name or
equivalentFord part
numberFord
specification
Power steering fluid,
transfer case fluid and
transmission fluid
(manual)Motorcraft
MERCONt
AT FXT-2-QDX MERCONt
Automatic transmission
(4R44E and 5R55E)Motorcraft
MERCONtV
AT FXT-5-QM
MERCONtV
Windshield washer fluidUltra-clear
windshield
washer
concentrateC9AZ-
19550-ABESR-
M17P5-A
1Add 118 ml (4 oz.) of additive friction modifier C8AZ-19B546±A, Ford
specification EST-M2C118±A for complete refill of Traction-Lok axles.
ENGINE DATA
Engine 2.5L I4 engine 3.0L V6 engine 4.0L V6 engine
Cubic inches 153 182 245
Horsepower 119 @ 5000 rpm 150 @ 5000 rpm 160 @ 4200 rpm
Torque 146 lbs. ft. @
3000 rpm185 lbs. ft. @
3250 rpm225 lbs. ft. @
2750 rpm
Required fuel
grade87 octane 87 octane 87 octane
Firing order 1-3-4-2 1-4-2-5-3-6 1-4-2-5-3-6
Spark plug
gap1.07-1.17 mm
(0.042-.046 inch)1.07-1.17 mm
(0.042-.046 inch)1.3-1.4 mm
(0.052-.056 inch)
Ignition
systemEDIS EDIS EDIS
Compression
ratio9.4:1 9.14:1 9.0:1
Capacities and specifications
151

canceling a set speed ...............27
indicator light ...........................28
resuming a set speed ...............28
tap up/tap down .......................26
turning off .................................25
Speedometer ...............................14
Starting your vehicle .............59,61
Tachometer
mechanical cluster ...................13
Tilt steering wheel ......................29
Tires ....................................130,132
changing ..................................103
checking the pressure ............132
replacing ..................................133
rotating ....................................132
snow tires and chains ............134
treadwear ................................131
Traction-lok rear axle ..........79,127
Trailer towing ..............................81
tips .............................................89
Transaxle
fluid, checking and adding
(manual) .................................126
Transfer case
fluid checking .........................127Transmission .............................124
automatic
operation ..........67,68,69,70,71,72
fluid, checking and adding
(automatic) .............................124
Trip odometer .............................14
Turn signal
lever ...........................................24
Vehicle dimensions ...................152
Vehicle Identification Number
(VIN) ..........................................154
Vehicle loading ............................79
Ventilating your vehicle .............63
Windows
power windows, operating .......30
Windshield washer fluid and
wipers
checking and adding fluid .....120
checking and replacing wiper
blades ......................................129
operation ...................................29
Wrecker towing .........................109
Index
158